Resumo do conteúdo contido na página número 1
MicroGate™ Online Kitchen™ Gateway
User Guide
MG1-1000
January 2005
Part Number: 4911000-010
Revision Number: A3
MicroGate™ User Manual 1
Resumo do conteúdo contido na página número 2
TABLE OF CONTENTS I. INTRODUCTION............................................................................................................................... 3 II. FEATURES AND SPECIFICATIONS............................................................................................. 5 ARCHITECTURE .......................................................................................................................................... 5 SERIAL INTERFACE PORT #1 AND PORT #2 ...........
Resumo do conteúdo contido na página número 3
I. Introduction • Everything you need for full NAFEM protocol compliance • Translates and organizes your legacy equipment's data into the NAFEM Data Protocol framework • Supports all of the MIBs defined by the NAFEM Data Protocol Group • Built-In Web Server • Optional Modem for installations without a network infrastructure • Connect up to 253 equipment with one MicroGate™ • Firmware Upgradeable in the field as protocol standards change E-Control Systems MicroGate™ is one of
Resumo do conteúdo contido na página número 4
Total Online Kitchen™ Solution Package Coupled with E-Control Systems' enterprise Raptor Web Software™, equipment manufacturers, systems integrators, and IT professionals have a total Online Kitchen™ system to help manage a fully integrated restaurant. Never before has there been such a synergy between all aspects of the restaurant. MicroGate™ User Manual 4
Resumo do conteúdo contido na página número 5
II. Features and Specifications Architecture CPU: Advanced High Performance Motorola 32-bit embeddedPowerPC™ Network Processor with 66 MIPS at 50 MHz Memory: 16 Mbytes of SDRAM (expandable to 64 Mbytes) 2 Mbytes of Flash (expandable to 16 Mbytes) 512 Kbytes of battery-backed SRAM (optional) Real time clock with battery backup Serial Interface Port #1 and Port #2 Interface Type: CMOS, RS232, or RS485 Data Rates: 300 to 115.2 kbps Characters:
Resumo do conteúdo contido na página número 6
With Modem: Input Current (25 MHz Clock): 490mA max Input Current (50 MHz Clock): 610mA max Environmental Operating: 0 C to 70 C (32 F to 158 F) Storage: -40 C to 85 C (-40 F to 185 F) Humidity: Maximum 95% Relative Humidity, non-condensing Altitude: 10,000 ft (3048 m) max Physical Specifications TOLERANCES 4701000A1 .010 Inches Figure 1 Without Modem: Dimensions: 4.75x3.00x0.80 inches (120.7x76.2x20.4 mm) Weight: 3.1 oz (88 grams) With Modem: Dimension
Resumo do conteúdo contido na página número 7
III. Hardware Description The MicroGate™ is meant to be connected between a local network/internet (using the LAN Port) and the equipment(s) (using any of the serial interfaces). The MicroGate™ also includes 4 LED indicators to simplify installation and network troubleshooting. The following figure shows the components/connectors of the gateway: DS1 DS2 DS3 DS4 J10 J11 J13 J1 MODEM 2 1 (OPTIONAL) J12 J14 J9 J2 2 1 BATTERY J8 (OPTIONAL) 1 E1 + + E2 2 1 J4 J5 J6 J7 2 2 2 2 J3 1 1 1 1 Figure
Resumo do conteúdo contido na página número 8
LED Indicators Table 2 - LED Indicators Designator Name Condition Status The Ethernet Port has established a On valid network connection DS1 Link (green) Network connection does Off not exist, or bad cable. The Ethernet Port DS2 Activity (green) Flashing is transmitting or receiving traffic Gateway is alive DS3 Heartbeat (green) Flashing (1 sec rate) and running The MicroGate is On receiving power DS4 Power (green) The MicroGate is Off not receiving power Power Connec
Resumo do conteúdo contido na página número 9
RS232 Serial Port Pin Assignment Table 5 - J4 (RS232 Channel #1) or J9 (Channel #2) Pin Name Description Type Number 1 CD Carrier Detect Input 2 DSR Data Set Ready Input 3 RX Receive Input 4 RTS Request To Send Output 5 TX Transmit Output 6 CTS Clear To Send Input 7 DTR Data Terminal Ready Output 8 RI Ring Indicator Input 9 Ground Ground Power Supply voltage, Must be regulated if power to board is being supplied from this 10 +5V Input pin (Option must be specified when ordering
Resumo do conteúdo contido na página número 10
Table 7 - J7 RS485 Channel #2 Pin Name Description Type Number Non-Inverting Receiver Input 2 RS485_RX+ Input (Full Duplex Mode) Inverting Receiver Input 4 RS485_RX- Input (Full Duplex Mode) RS485 Ground 6 RS485_GND Power (Not signal Ground!!!) Non-Inverting Driver Output RS485_TX+ Output (Full Duplex mode) 8 Non-Inverting Receiver Input / RS485_TX/RX+ Driver Output (Half Duplex Input/Output mode) Inverting Driver Output RS485_TX- Output (Full Duplex mode) 10 Inverting
Resumo do conteúdo contido na página número 11
Ethernet (RJ45) Cable Specifications and Pin Assignments Figure 3 Table 8 - Cable Specification Cable Type Max. Length Connector 10BASE-T Cat. 3, 4, 5 100-ohm UTP 100 m (328 ft) RJ45 Table 9 - J1 Ethernet Pin MDI Signal Name MDI-X Signal Name Number 1 Transmit Data (TD+) Receive Data (RD+) 2 Transmit Data (TD-) Receive Data (RD-) 3 Receive Data (RD+) Transmit Data (TD+) 6 Receive Data (RD-) Transmit Data (TD-) Pins 4, 5, 7, and 8 are not connected. Table 10 Table 11
Resumo do conteúdo contido na página número 12
IV. Installation and Configuration System Requirements You must meet the following requirements to install and configure the MicroGate™: • Static IP address, Subnet Mask, and Gateway Address to assign the MicroGate™ • A computer equipped with a 10 Mbps, 100 Mbps, or 10/100 Mbps Fast Ethernet Card, or USB-to-Ethernet converter. Computer must have TCP/IP protocols installed and have a fixed (static) or dynamic IP Address assigned to it. • MicroGate Discovery Utility CD (might be bundled
Resumo do conteúdo contido na página número 13
Basic Network Configuration Procedure 1. Start the Discovery Utility by selecting Start > Programs > Raptor Web Software > ECSDiscovery – This utility might reside in a different location depending on how it was installed. Figure 4 2. Click on Start Discovery (see Figure 4, note #1) to start looking for E-Control Systems’ units on your network. Note: This could take up to 30 seconds to complete Figure 5 3. A list of all of the ECS units on the network is listed sorted by th
Resumo do conteúdo contido na página número 14
Figure 6 4. Once the row corresponding to the unit to be configured is highlighted, click on Edit Unit (see Figure 6, note #1) to bring up the Unit’s Properties Figure 7 MicroGate™ User Manual 14
Resumo do conteúdo contido na página número 15
5. Change the IP Address, Subnet Mask, and Gateway Address as needed and then click on Update (see Figure 7, note #1) to send configuration to the unit. To quit without updating the unit, click on the X (see Figure 7, note #2) 6. Writing the configuration and restarting the unit can take as long as 2 minutes. In that time you will see DS3 stop flashing. When it starts flashing again you are done configuring the MicroGate™. Note: You can also verify that the MicroGate’s configuration change
Resumo do conteúdo contido na página número 16
V. Part Number Selection See Figure 8 for configuration options and suggestions. For custom configurations please consult E-Control Systems. Optional Special Build RS232 #1 RS232 #2 RS485 #1 and #2 (Consult Factory) MG1- SL- XX- XX- XX-SPXXX Functional Options Connector Options L No add-on modules A None M 33.6 Kbps Modem Module B Header only C Sh
Resumo do conteúdo contido na página número 17
VI. Limited Warranties E-Control Systems' Limited Warranty Statement Limited Warranty Statement: E-Control Systems ("ECS") warrants its products to be free from defects in workmanship and materials, under normal use and service, for the applicable warranty term. All ECS products carry a standard 1 year limited warranty from the date of purchase from ECS or its Authorized Reseller/Distributors. ECS may, at its own discretion, repair or replace any product not operating as warranted with a
Resumo do conteúdo contido na página número 18
ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME COUNTRIES DO NOT ALLOW THE EXCLUSION OF IMPLIED WARRANTIES OR THE LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR CONSUMER PRODUCTS, SO THE ABOVE LIMITATIONS AND EXCLUSIONS MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, WHICH MAY VARY FROM COUNTRY TO COUNTRY. NOTHING IN THIS WARRANTY SHALL BE TAKEN TO AFFECT YOUR STATUTORY RIGHTS. Firmware and Drivers For latest driver, technical information and bug-fixes plea
