Manual do usuário Audiovox 650

Resumo do conteúdo contido na página número 1

FOR
50 - - 015 SERIES 1181272























These i








5. 18 GA wire 4' - 6' 6. 1/4" Hex Socket Bit
o Module


NOT FOR VEHICLES EQUIPPED WITH SUN ROOF.




-
Printed in the U.S.A

0044A INSTALLATION INSTRUCTION # 44
Nov. 8, 1999
NOT FOR USE IN VEHICLES EQUIPPED WITH FACTORY REAR A

Resumo do conteúdo contido na página número 2

1 1 2 - 2 6 3 4 2 SCREW, # 8 X 1 1/2" PWH 4 1 2 5 3 1 6 7 1 4 8 1 9 1 10 1 5 - 00 44A Nov. 8, 1999 Printed in the U.S.A.

Resumo do conteúdo contido na página número 3

Caution: Before cutting indicated. Make sure that the 7" cut is centered ure 2. DO NOT 4. pg. 2) with the 5. Secure front of bracket to front roof brace using (2) two # 10 X 1/2" 3 FIGURE 3 screws (item 1 pg 2). roof. See Fig. 3 and Fig. 4. notches in bracket with center lines scribed on rear tabs engage rear O.E.

Resumo do conteúdo contido na página número 4

7. Construct a jumper h See Figure 5.

Resumo do conteúdo contido na página número 5

suggested routing of the - the B - pillar to the floor. Route the power lead to an accessory controlled source. Connect the Sensor extension, etc.) to the VCP location. - 32 x 3/4" secure rear then tighten (2) two 6 - See Figure 7. 5 FIGURE 7 32 screws previously installed. (item 4 pg. 2). Make sure console alignment is straigh

Resumo do conteúdo contido na página número 6

Lower video sc ort phone Note : Make sure wires do not get pinched between video system and console. (4) four 6 - Caution : Do not overtighten screws. Caution: Do not overtighten screws or damage to 19. 20. (2) # 6 X 1/2" screws (item 5 pg 2). 21.