Manual do usuário Dakota Digital LED Tail Lights for 1969 Camaro LAT-NR111

Resumo do conteúdo contido na página número 1

INSTALLATION INSTRUCTIONS
LAT-NR111
LED Tail Lights for 1969 Camaro

MAN#650170

Kit Includes:

Installation:

1. Remove the original bulb connectors from the bottom side of the housing.
2. Remove the plastic housing from the vehicle.
3. Remove the tail light lens by gently prying the housing away from the lens tabs.

4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is
recommended.
5. Note that the screws and mounting plates are assembl

Resumo do conteúdo contido na página número 2

6. Insert each new LED assembly through the hole where the original bulb and connector were located. Use caution when feeding the wires through the socket opening to avoid damaging the wire insulation. 7. Feed the wires through the large hole in the back plate and attach the back plate onto the back side of the housing. The flat side of the mounting plate should be toward the outside and the side with the slight raised center should go in towards the housing. This will align the

Resumo do conteúdo contido na página número 3

10. Cut off the existing light socket as it will not be used. Do not strip the wires. Trim the wires from LED assembly to appropriate length once mounted, making sure wires are routed cleanly and securely. 11. Use the supplied moisture resistant pigtail connectors* to attach the wires from the new LED assembly to the existing vehicle harness. Insert the appropriate wire from vehicle harness and mating LED assembly wire into a connector and crimp following instructions below. *For the