Manual do usuário Code Alarm CA 310

Resumo do conteúdo contido na página número 1

CA 310 Owners Manual
128-6530
1 of 10

Resumo do conteúdo contido na página número 2

Your system has many features and available options some of which are selected at time of installation. Consult your installing dealer for options that may have been installed and are not listed. ARMING THE SYSTEM: 1. Turn the engine OFF, exit the vehicle, and close all doors, hood and trunk. 2. Press and release the LOCK button of your Factory (OEM) transmitter one time. The parking lights will flash once, the siren will chirp once, and the dash mounted LED will begin to flash slowly confirming

Resumo do conteúdo contido na página número 3

Whenever the system is triggered, the vehicle's parking lights will flash for the full siren sounding period. Optional - whenever the system is triggered, the interior courtesy light will flash for the full siren sounding period. Optional- whenever the system is armed, the vehicle starter circuit is disabled, and the vehicle will not start with the ignition key. Whenever the system is armed, any strong impact to the vehicle will cause the shock sensor to trigger the alarm. Any lesser impact w

Resumo do conteúdo contido na página número 4

If the LED flashes 4 times...pause, 4 times...pause etc., then an intrusion attempt was made by impact or a strong vibration that the shock sensor detected. Check the vehicle for possible damage to the glass or body panels. NOTE: The LED intrusion warning indications are stored in the system's memory and will be erased when the ignition switch is turned on. VALET/OVERRIDE SWITCH: The valet switch allows you to temporarily bypass all alarm functions, eliminating the need to hand your transmitter

Resumo do conteúdo contido na página número 5

ELIMINATING/RETURNING THE NORMAL ARM/DISARM CHIRPS You can selectively eliminate the normal arm & disarm chirps using the valet/ override switch, following these steps. 1) Turn the ignition key ON the OFF. 2) Within 10 seconds of turning the ignition key OFF, press and release the valet/override switch 3 times. 3) If, before step 1,the chirps were ON, then you will hear 2 short chirps, which indicates the chirps are turned OFF. 4) If, before step 1, the chirps were OFF. then you will hear 1 shor

Resumo do conteúdo contido na página número 6

Code Systems, Inc. Limited Lifetime Warranty Code Systems Inc. (“CODE”) warrants to the ORIGINAL PURCHASER of this CODE vehicle security product (the “Product”), purchased from an authorized CODE dealer, that (except as provided below) should this Product under normal use and conditions, be proven defective in material or workmanship DURING THE LIFETIME OF THE VEHICLE IN WHICH IT WAS ORIGINALLY INSTALLED, such defect(s) will be repaired or replaced (at CODE’s option) without charge for parts dir

Resumo do conteúdo contido na página número 7

CODE-SYSTEM, INC. Theft Protection Program The Theft Protection Program is designed to provide the retail purchaser of a security system provided by CODE-ALARM, INC. (“CODE”) an additional benefit, at no additional cost to the purchaser, should their vehicle be stolen while protected by a CODE-ALARM security system. While CODE has created this program as a way of showing appreciation to its customers, CODE RE- SERVES THE RIGHT TO UNILATERALLY CHANGE, ALTER, MODIFY, OR DISCONTINUE ALL OR PART OF

Resumo do conteúdo contido na página número 8

Plan duration: 3 Years from the date of installation. Plan amount: Maximum allowable value equal to insurance deductible or up to $2,500 whichever is less. Conditions of the Theft Protection Program: 1. The Theft Protection Program is non-transferable and non-assignable. 2. The system must be installed by an authorized CODE dealer. 3. Vehicle must be less than three (3) model years old at the time of installation. 4. The security system must have been fully armed at the time of the vehicle theft