Resumo do conteúdo contido na página número 1
MICRO COMPONENT SYSTEM
UX-H35— Consists of CA-UXH35 and SP-UXH35
UX-H33— Consists of CA-UXH33 and SP-UXH33
UX-H30— Consists of CA-UXH30 and SP-UXH30
MICRO COMPONENT SYSTEM
INSTRUCTIONS
For Customer Use:
Enter below the Model No. and Serial No.
which are located either on the rear, bot-
tom or side of the cabinet. Retain this
information for future reference.
Model No.
Serial No.
GVT
Resumo do conteúdo contido na página número 2
Warnings, Cautions and Others CAUTION— (standby/on) button! IMPORTANT for the U.K. Disconnect the mains plug to shut the power off completely (all lamps and indications go off). The (standby/on) DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home button in any position does not disconnect the mains line. or the cable is too short to reach a power point, then • When the unit is on standby, the STANDBY lamp lights obtain an appro
Resumo do conteúdo contido na página número 3
SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards, but like any electrical equip- ment, care must be taken if you are to obtain the best results and safety is to be assured. ✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮ Do read the operating instructions before you attempt to use the equipment. Do ensure that all electrical connections (including the mains plug, extension leads and int
Resumo do conteúdo contido na página número 4
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Power sources About This Manual • When unplugging the unit from the wall outlet, always pull on the plug, not the AC power cord. This manual is organized as follows: • The manual mainly explains operations using the DO NOT handle the AC power cord w
Resumo do conteúdo contido na página número 5
Contents Location of the Buttons ............................................... 3 Main Unit .......................................................................... 3 Remote Control ................................................................. 5 Getting Started............................................................. 6 Supplied Accessories ......................................................... 6 Connecting Antennas ........................................................ 6 Connecti
Resumo do conteúdo contido na página número 6
Location of the Buttons Become familiar with the buttons on your unit. Main Unit Top view PHONES 1 2 COMPACT 7 DIGITAL AUDIO 3 8 TIMER/SNOOZE 4 OPEN 9 MULTI CONTROL ONE TOUCH AHB PRO REC 4 7 ¢ VOLUME BAND p 5 AUX TAPE TUNER CD 6 Front view q STANDBY r MICRO COMPONENT SYSTEM w e t 3 EN01-15_UX-H30[B]f.pm6 3 02.12.26, 1:35 PM
Resumo do conteúdo contido na página número 7
Continued Display window 12 3 4 567 8 BASS SLEEP SNOOZE REC ON STEREO 9 OFF CLOCK MONO p REC RDS TA NEWS INFO q w 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 PROGRAM RANDOM ALL OVER er t y See the pages in parentheses for details. Main unit Display window 1 PHONES jack (11) 1 Tape operation indicators REC 2 Disc cover • 2 3 (tape direction), (recording), and 3 TIMER/SNOOZE button (10, 22 – 24) (reverse mode) 4 ONE TOUCH REC (recording) button (20, 21) 2 (timer) indicator 5 (standby/on) button (
Resumo do conteúdo contido na página número 8
Remote Control See the pages in parentheses for details. 1 Number buttons 2 BASS button (11) 3 Multi control buttons STANDBY/ON • UP, 4 (reverse skip), 7 (stop), ¢ 1 2 3 (forward skip), and DOWN 9 4 SET button (13) 4 5 6 DISPLAY 5 Source buttons p • 3/8 CD, 2 3 TAPE, TUNER, and AUX 1 CLOCK 7 8 9 /TIMER Pressing one of these buttons also turns on the q unit. 10 10 SLEEP 6 REV.MODE (reverse mode) button (19 – 21) w 7 PRGM (program) button (17) UP BASS TREBLE 8 RDS operation buttons (14, 15) e 2 •
Resumo do conteúdo contido na página número 9
Getting Started Continued To connect an outdoor FM antenna Supplied Accessories Before connecting the antenna, disconnect the supplied FM antenna. Make sure that you have all the following items. The number in parentheses indicates the quantity of each piece supplied. Outdoor FM antenna • AM loop antenna (1) (not supplied) • FM antenna (1) • AC power cord (1) • Remote control (1) Coaxial cable (not supplied) • Batteries (2) If anything is missing, consult your dealer immediately. Connecting A
Resumo do conteúdo contido na página número 10
AM (MW) antenna Connecting Speakers 1 12 Vinyl-covered wire (not supplied) Speaker cord Speaker cord 2 AM loop antenna (supplied) Right speaker Left speaker 1 Connect the AM loop antenna to the 1 Press and hold the clamp of the AM LOOP terminals as illustrated. speaker terminal on the rear of the unit. 2 Turn the AM loop antenna until you have the best reception. 2 Insert the end of the speaker cord into the terminal. Match the polarity between the unit and the To connect an outdoor AM (MW) ante
Resumo do conteúdo contido na página número 11
Continued To remove the speaker grilles NOW you are ready to plug in the unit The speaker grilles are removable. and any other connected equipment. Projections IMPORTANT: Be sure to check all connections to be done before plugging the power cord. Holes This unit can be supplied with power through the AC IN connector (at home) or the DC IN connector (in a car). • Do not connect the unit using the AC IN connector and the DC IN connector at the same time for safe and correct use. Speaker grille
Resumo do conteúdo contido na página número 12
When using the unit in your car Putting the Batteries into the Remote Control To car’s cigarette lighter socket (12 V) Insert the batteries—R6(SUM-3)/AA(15F)—into the remote control, by matching the polarity (+ and –) on the batteries with the + and – markings on the battery compartment. When the remote control can no longer operate the unit, replace both batteries at the same time. 1 12V 4A Car adapter DC IN (JVC model: CA-R120E) R6(SUM-3)/AA(15F) 2 Connect a car adapter to the DC IN (12 V, 4 A
Resumo do conteúdo contido na página número 13
Common Operations Continued Setting the Clock 3 Press ¢ or 4 to adjust the minute, then press TIMER/SNOOZE. Before operating the unit any further, first set the unit’s clock. When you plug in the power cord, the CLOCK indicator and “0:00” start flashing on the display. To check the clock time during play You can set the clock whether the unit is on or off. On the remote control ONLY: • There is a time limit in doing the following steps. If DISPLAY Press DISPLAY (grey-colored). the setting is
Resumo do conteúdo contido na página número 14
Turning On the Power Adjusting the Tone (Bass/Treble) STANDBY/ON To turn on the unit, press You can adjust the bass level (low frequency range) STANDBY/ON ( on the unit). and the treble level (high frequency range) within a The STANDBY lamp on the unit goes off. range of –5 to +5. • When you press the source button When shipped, the bass level set to “BASS 0” and the —3/8 CD, 2 3 TAPE, TUNER (or treble level set to “TREBLE +1.” BAND TUNER on the unit) and AUX, the unit • This function only affe
Resumo do conteúdo contido na página número 15
Listening to FM and AM (MW) Broadcasts Continued Tuning in to a Station Presetting Stations You can preset 30 FM and 15 AM (MW) stations— TUNER using either automatic presetting or manual presetting. 1 Press TUNER (or BAND In some cases, test frequencies have been already TUNER on the unit) to select memorized for the tuner since the factory examined the the band. tuner preset function before shipment. This is not a The unit automatically turns on and BAND malfunction. tunes in to the previou
Resumo do conteúdo contido na página número 16
To preset stations manually—Manual presetting To tune in to a preset station directly using the You need to preset stations separately for the FM and number buttons AM (MW) bands. On the remote control ONLY: • There is a time limit in doing the following steps. If 1 3 Pressing the number button(s) 2 the setting is canceled before you finish, start over allows you to select the preset from step 2. 4 5 6 number you want. Ex.: For preset number 5, press 5. 7 8 9 On the remote control ONLY: For pres
Resumo do conteúdo contido na página número 17
Continued On the remote control ONLY: Changing the RDS Information PTY 1 Press PTY SEARCH. SEARCH You can see RDS information on the display while “PTY” and “SELECT” appear on the listening to an FM station. display alternately. On the remote control ONLY: PTY 2 Press PTY SELECT + or SELECT DISPLAY Press DISPLAY (orange-colored). PTY SELECT – until the • Each time you press the button, the PTY code you want display changes to show the following appears on the display. information: • Each time
Resumo do conteúdo contido na página número 18
Switching Temporarily to a Program How the Enhanced Other Networks function Type of Your Choice actually works: The Enhanced Other Networks function allows the unit CASE 1 to switch temporarily to a broadcast program of your If there is no station broadcasting the program choice (TA, NEWS, and INFO) from a different you have selected station. The unit continues tuning in to the current station. • The function only works when you are listening to a « preset FM RDS stations providing the data. Whe
Resumo do conteúdo contido na página número 19
Playing Back Discs Continued This unit has been designed to play back the following 3 Close the disc cover gently. discs—CD, CD-R, and CD-RW. CD 4 Press 3/8 CD. When playing a CD-R or CD-RW The unit automatically turns on and the User-edited CD-Rs (CD-Recordable) and CD-RWs first track of the disc starts playing. (CD-ReWritable) can be played only if they are Track number Elapsed playing time already “finalized.” REC • Usually you can play back your original CD-Rs or CD-RWs recorded in music
Resumo do conteúdo contido na página número 20
Basic Disc Operations Programming the Playing Order of the Tracks—Program Play While playing a disc, you can do the following operations. You can arrange the order in which tracks play before you start playing. You can program up to 20 tracks. To stop playing for a moment During play, press 3/8 CD. CD On the remote control ONLY: While pausing, the elapsed playing time 1 Load a disc. flashes on the display. • If the current playing source is not the CD To resume playing, press 3/8 CD again. playe
