Manual do usuário Monte Carlo Fan Company 5AYR54 Series

Resumo do conteúdo contido na página número 1

Owner’s
Manual
Ceiling Fan Installation Instructions
Total fan weigh
with light
For 5AYR54 Series Fans
READ AND SAVE THESE INSTRUCTIONS
Quality Ceiling fans

Resumo do conteúdo contido na página número 2

Installation SAFETY TIPS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: READ AND SAVE THESE INSTRUCTIONS 1. Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70- 1999), including fire-rated construction. 2. Use this unit only in the manner intended by the manufacurer. If you have any questions contact the manufacturer. 3. After making the wire connections,

Resumo do conteúdo contido na página número 3

8 7 9 Install keeper into cross pin. Tighten 2 downrod set screws and Thread leadwires, safety cable, yoke lock nuts. cover and canopy through downrod. Safety cable installation 10 11 12 Safety Cable Lag Screw Remote Transmitter Dip swtiches safety cable washer Remote Receiver Dip switches lock 3” lag washer screw Set dip switches on the Remote Transmitter and Fan and light kit combinations over 35 lbs, Remote Receiver to the same settings. This must be in both flush and downrod mode the safety

Resumo do conteúdo contido na página número 4

21 19 20 Take plate with glass and place over the 2 screws and twist to hold in Attach blade arms to blades using Tighten all 3 screws securely. place. Replace screw removed. the blade arm screws and washers provided. 23 24 22 The screws, washers and motor pads are pre-installed to the blade holders. Attach Loosen 2 screws and remove 1 FOR LIGHT KIT INSTALL SKIP blade assembly to motor and tighten THIS STEP. Attach center cover screw to allow bottom fan plate to screws securely. be installed. p

Resumo do conteúdo contido na página número 5

32 31 HAND HELD INSTALL 33 WALL MOUNT INSTALL Place face plate over battery compartment and Attach front cover to wall control Install wall control unit to outlet box buttons. Place remote over 2 pins on front with screws provided. Snap battery using machine screws provided. cover. Attach cover of remote by placing over 4 cover in place. pins and snaping into place.

Resumo do conteúdo contido na página número 6

Remote Control Transmitter Features: FAN REVERSE LED LIGHT (Press once to change direction of MEDIUM SPEED the fan)Fanmust be running to reverse. HIGH SPEED LOW SPEED FAN OFF SETTING UPLIGHT ON/OFF SET- (Turns fan off only) TING AND DIMMER (Press and hold to dim light infinitively) DOWNLIGHT ON/OFF SETTING AND DIMMER (Press and hold to dim light infinitively) FAN SPEED Depress “l dot” for low speed, “2 dots” for medium or “3 dots” for high. To turn fan off press square”. LIGHT DIMMER To turn li

Resumo do conteúdo contido na página número 7

Trouble Shooting If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet. Warning: Before servicing or cleanin

Resumo do conteúdo contido na página número 8

9/21/04 REV.0 New made from 5AHR manual