Resumo do conteúdo contido na página número 1
DO NOT
DISCARD
Owner’s Manual
Installation and Operation
Models:
6000CMOD-IPI
8000CMOD-IPI
NOTICE
DO NOT DISCARD THIS MANUAL
• Important operating • Read, understand and follow • Leave this manual with
and maintenance these instructions for safe
party responsible for use
instructions included. installation and operation.
and operation.
WARNING
WARNING: If the information in these
HOT SURFACES!
instructions is not followed exactly, a fi re
Glass and other surfaces are hot during
or explosio
Resumo do conteúdo contido na página número 2
Read this manual before installing or operating this appliance. Please retain this owner’s manual for future reference. This owner’s manual should be retained for future A. Congratulations reference. We suggest that you keep it with your other Congratulations on selecting a Heat & Glo gas fi replace, an important documents and product manuals. elegant and clean alternative to wood burning fi replaces. The information contained in this owner’s manual, unless The Heat & Glo gas fi replace you h
Resumo do conteúdo contido na página número 3
Safety Alert Key: • DANGER! Indicates a hazardous situation which, if not avoided will result in death or serious injury. • WARNING! Indicates a hazardous situation which, if not avoided could result in death or serious injury. • CAUTION! Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury. • NOTICE: Used to address practices not related to personal injury. Table of Contents A. Congratulations . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Resumo do conteúdo contido na página número 4
13 Finishing A. Mantel and Wall Projections . . . . . . . . . . . . . . . . . . . . . . . 47 B. Facing Material . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 48 C. Finish and Sealing Joints . . . . . . . . . . . . . . . . . . . . . . . . . 48 D. Door Selection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 49 14 Appliance Setup A. Remove Fixed Glass Assembly . . . . . . . . . . . . . . . . . . . . 52 B. Remove the Shipping Materials . . . . . . . . . .
Resumo do conteúdo contido na página número 5
B. Limited Lifetime Warranty Hearth & Home Technologies Inc. LIMITED LIFETIME WARRANTY Hearth & Home Technologies Inc., on behalf of its hearth brands (”HHT”), extends the following warranty for HHT gas, wood, pellet, coal and electric hearth appliances that are purchased from an HHT authorized dealer. WARRANTY COVERAGE: HHT warrants to the original owner of the HHT appliance at the site of installation, and to any transferee taking ownership of the appliance at the site of installation within
Resumo do conteúdo contido na página número 6
B. Limited Lifetime Warranty (continued) WARRANTY CONDITIONS: WARRANTY EXCLUSIONS: - - - - - This warranty is void if: LIMITATIONS OF LIABILITY: 4021-645C 12-29-10 Page 2 of 2 6 Heat & Glo • 6000CMOD-IPI, 8000CMOD-IPI • 2241-900 Rev. H • 5/12
Resumo do conteúdo contido na página número 7
Listing and Code Approvals 1 1 C. BTU Specifi cations A. Appliance Certifi cation Maximum Minimum Orifi ce Models Input Input Size (U.S. or Canada) BTU/h BTU/h (DMS) MODELS: 6000CMOD-IPI, 8000CMOD-IPI US LABORATORY: Underwriters Laboratories, Inc. (UL) 28,000 19,000 40 (0-2000 FT) 6000CMOD-IPI TYPE: Direct Vent Gas Appliance Heater (NG) CANADA 25,200 17,100 41 STANDARD: ANSI Z21.50b-2009 • CSA 2.22b-2009 (2000-4500 FT) US 20,000 14,000 55 (0-2000 FT) 6000CMOD-IPI This product is listed to AN
Resumo do conteúdo contido na página número 8
Inspection Note: The following requirements reference various The state or local gas inspector of the side wall horizon- Massachusetts and national codes not contained in this tally vented gas fueled equipment shall not approve the document. installation unless, upon inspection, the inspector ob- serves carbon monoxide detectors and signage installed H. Requirements for the Commonwealth of in accordance with the provisions of 248 CMR 5.08(2)(a)1 Massachusetts through 4. For all side wall
Resumo do conteúdo contido na página número 9
User Guide Operating Instructions 2 2 • Install a switch lock or a wall/remote control with child A. Gas Fireplace Safety protection lockout feature. • Keep remote controls out of reach of children. WARNING • Never leave children alone near a hot fi replace, whether HOT SURFACES! operating or cooling down. Glass and other surfaces are hot during operation AND cool down. • Teach children to NEVER touch the fi replace. Hot glass will cause burns. • Consider not using the fi replace when child
Resumo do conteúdo contido na página número 10
CLEAR SPACE 3 FT. IN FRONT OF FIREPLACE C. Fan Kit (optional) F. Fixed Glass Assembly If desired, a fan kit may be added. Contact your dealer to See Section 14.G. order the correct fan kit. G. Remote Controls, Wall Controls and Wall D. Clear Space Switches WARNING! DO NOT place combustible objects in front Follow the instructions supplied with the control installed of the fi replace or block louvers. High temperatures may to operate your fi replace. start a fi re. See Figure 2.2. For specifi
Resumo do conteúdo contido na página número 11
• Locate the module selector switch. (See Figure 2.3). H. IPI Battery Tray/Battery Installation TM • Set the module selector switch to the OFF position. The IntelliFire Plus system has a battery backup option. Battery longevity and performance will be affected by the • Wait fi ve (5) minutes to allow possible accumulated gas service temperatures of this appliance. to clear. NOTICE: Batteries should only be used as a power source • Set the module selector switch to ON or REMOTE in the e
Resumo do conteúdo contido na página número 12
K. Lighting Instructions (IPI) FOR YOUR SAFETY LIGHTING READ BEFORE LIGHTING INSTRUCTIONS (IPI) WARNING: If you do not follow these instructions exactly, a fi re or explosion 1. This appliance is equipped with an ignition may result causing property damage, personal injury or loss of life. device which automatically lights the burner. DO NOT try to light the burner by hand. • Immediately call your gas supplier A. This appliance is equipped with an from a neighbor’s phone. Follow the interm
Resumo do conteúdo contido na página número 13
L. After Fireplace is Lit Initial Break-in Procedure • The fireplace should be run three to four hours continuously on high. • Turn the fi replace off and allow it to completely cool. • Remove fi xed glass assembly. See Section 14.G. • Clean fi xed glass assembly. See Section 3. • Replace the fi xed glass assembly and run continuously on high an additional 12 hours. This cures the materials used to manufacture the fi re- place. NOTICE! Open windows for air circulation during fi re- place break-in. •
Resumo do conteúdo contido na página número 14
Maintenance and Service 3 3 Remote Control Any safety screen or guard removed for servicing must be replaced prior to operating the fi replace. Frequency: Seasonally By: Homeowner When properly maintained, your fi replace will give you many years of trouble-free service. We recommend an- Tools needed: Replacement batteries and remote con- nual service by a qualifi ed service technician. trol instructions. • Locate remote control transmitter and receiver. A. Maintenance Tasks-Homeowner • Ve
Resumo do conteúdo contido na página número 15
• Confi rm there is no damage to glass or glass frame. Tools needed: Protective gloves, vacuum cleaner, whisk Replace as necessary. broom, fl ashlight, voltmeter, indexed drill bit set, and a manometer. • Verify that fi xed glass assembly is properly retained and attachment components are intact and not damaged. • Verify burner is properly secured and aligned with pilot Replace as necessary. or igniter. • Clean off burner top, inspect for plugged ports, corrosion Interior Ceramic Glass Panel
Resumo do conteúdo contido na página número 16
4. Remove the base pan by removing the screws circled C. Glass Refractory, Base Pan, Burner and in Figure 3.4. Valve Assembly Removal 5. Remove the burner assembly by removing the two It may become necessary to remove the glass panels, screws as shown in Figure 3.5. To disengage the burner base pan, burner and valve assembly. This task should from the orifi ce, slide the burner to the right and lift it out. be performed by a qualifi ed service technician. 6. See Figure 3.6 for valve assemb
Resumo do conteúdo contido na página número 17
D. Burner Identifi cation Appearance of valve components may vary. 6000CMOD-IPI (NG) 6000CMOD-IPI (LP) Figure 3.6 Valve Assembly Removal Figure 3.7 Valve Assembly Removal 8000CMOD-IPI (NG) 8000CMOD-IPI (LP) Figure 3.8 Valve Assembly Removal Heat & Glo • 6000CMOD-IPI, 8000CMOD-IPI • 2241-900 Rev. H • 5/12 17
Resumo do conteúdo contido na página número 18
Installer Guide Getting Started 4 4 A. Typical Appliance System NOTICE: Illustrations and photos refl ect typical installations and are for design purposes only. Illustrations/diagrams are not drawn to scale. Actual product may vary from pictures in manual VERTICAL TERMINATION CAP (SECTION 10.I) NON-COMBUSTIBLE ROOF FLASHING MAINTAINS MINIMUM CLEARANCE AROUND PIPE (SECTION 10.G) STORM COLLAR (SECTION 10.H) VENT PIPE PENETRATES ROOF PREFERABLY WITHOUT AFFECTING ROOF RAFTERS (SECTION 8.C)
Resumo do conteúdo contido na página número 19
B. Design and Installation Considerations D. Inspect Appliance and Components Heat & Glo direct vent gas appliances are designed to • Carefully remove the appliance and components from operate with all combustion air siphoned from outside of the packaging. the building and all exhaust gases expelled to the outside. • The vent system components and decorative doors and No additional outside air source is required. fronts may be shipped in separate packages. Installation MUST comply with loca
Resumo do conteúdo contido na página número 20
Framing and Clearances 5 5 NOTICE: Illustrations refl ect typical installations and are A. Selecting Appliance Location FOR DESIGN PURPOSES ONLY. Illustrations/diagrams When selecting a location for the appliance it is important to are not drawn to scale. Actual installation may vary due to consider the required clearances to walls (see Figure 5.1). individual design preference. WARNING! Risk of Fire or Burns! Provide adequate clearance around air openings and for service access. Due to
