Resumo do conteúdo contido na página número 1
C
N
E
R
G
T
I
INSTALLER/CONSUMER
SAFETY INFORMATION
PLEASE READ THIS MANUAL
BEFORE INSTALLING AND
USING APPLIANCE
WARNING!
Direct Vent / Natural
IF THE INFORMATION IN THIS
MANUAL IS NOT FOLLOWED
Vent Gas Heater
EXACTLY, A FIRE OR EXPLO-
SION MAY RESULT CAUSING
Models: 2465, 2466
PROPERTY DAMAGE, PER-
SONAL INJURY OR LOSS OF
LIFE.
FOR YOUR SAFETY
Installation and service must
be performed by a qualified
installer, service agency or
the gas supplier.
WHAT TO DO IF YOU SMELL GAS:
• Do not
Resumo do conteúdo contido na página número 2
Dutchwest Direct Vent / Natural Vent Gas Heater Table of Contents PLEASE READ THE INSTALLATION & OPERATING INSTRUCTIONS BEFORE USING APPLIANCE. Thank you and congratulations on your purchase of a Dutchwest stove. IMPORTANT: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible fire hazard and will void the warranty. Installation & Operating Instructions ..........................................................
Resumo do conteúdo contido na página número 3
Dutchwest Direct Vent / Natural Vent Gas Heater General Information The Dutchwest Direct Vent/Natural Vent Room Heater, WARNING: Operation of this heater when not con- Model Nos. 3070, 3071, 3072 and 3073, is a vented gas nected to a properly installed and maintained venting appliance listed to the ANSI standard Z21.88b-2001 and system can result in carbon monoxide (CO) poisoning CSA-2.33b-2001 for Vented Room Heaters, and CSA 2.17- and possible death. M91, Gas-Fired Appliances For Use a
Resumo do conteúdo contido na página número 4
Dutchwest Direct Vent / Natural Vent Gas Heater Dutchwest Direct Vent / Natural Vent Dimensions Refer to Page 6 for Flue Collar Centerline Dimensions 6���" (172mm) C L Valve Inlet 24 ���" (622mm) 28 ���" (721mm) Valve C L 4 ���" Inlet (111mm) 12���" 23" (318mm) (584mm) 17" (419mm) Fig. 1 Dutchwest dimensions. 1935 Dutchwest Attention DV/NV dimensions The Dutchwest stove is shipped from the factory as a Direct Vent Gas Heater. This heater may be convert- 5/15/03 ed into a Natural Vent unit
Resumo do conteúdo contido na página número 5
Dutchwest Direct Vent / Natural Vent Gas Heater Installation Requirements The installation must conform with local codes or, in Direct Vent System Only the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54 - latest edition. (EXCEP- TION: Do not derate this appliance for altitude. Main- tain the manifold pressure at 3.5” w.c. for Natural Gas, and 10” w.c. for Propane). A D In Canada, installation must be in accordance with the B current CSA B-149.1 Installation Co
Resumo do conteúdo contido na página número 6
Dutchwest Direct Vent / Natural Vent Gas Heater Parallel Installation: Wall Centerline from Floor Minimum Clearance and Flue Centerline, Direct Vent and Natural Vent C L C A D A C L B Stove Clearances A: 4” (102 mm) ST128c B: 4” (102 mm) ST131c Pipe Centerlines C: 15 ¹⁄₂” (395 mm) A D: 9” (229 mm) ST128b Effective Minimum Fig. 3 Parallel installation, minimum back and side clear- Wall Thimble 57 ¹⁄₂” (1461 mm) (CFM Pipe) Stardance ances and flue centerlines. ST131c Centerline 53 ¹⁄
Resumo do conteúdo contido na página número 7
Dutchwest Direct Vent / Natural Vent Gas Heater Horizontal Termination - Gas Specifications Direct Vent ONLY Max. Min. Input Input The vent must rise vertically a minimum of 24” (610mm) Model Fuel Gas Control BTU/h BTU/h off the top of the unit, before the first elbow. The hori- 2465 Nat Millivolt 28,000 20,000 zontal run may extend up to 20’ (6m) and include a vertical rise of up to 40’ (12m). (Fig. 7) Horizontal 2466 Prop Millivolt 28,000 19,000 termination must also meet the crit
Resumo do conteúdo contido na página número 8
Dutchwest Direct Vent / Natural Vent Gas Heater Vent Termination Clearances Vertical Termination - Direct Vent ONLY A vertical vent system must terminate no less than 8’ When planning the installation, consider the location (2.44m) and no more than 40’ (12m) above the appli- of the vent terminal and clearances. Some of the most ance flue collar. A 2 ¹⁄₄” restrictor plate (supplied) must common clearances to keep in mind are shown in Fig- be used where specified in all vertically terminated vent
Resumo do conteúdo contido na página número 9
Dutchwest Direct Vent / Natural Vent Gas Heater Venting Termination Clearances Your stove is approved to be vented either through the There must not be any obstruction such as bushes, side wall, or vertical through the roof. garden sheds, fences, decks or utility buildings within 24” from the front of the termination hood. • This unit does not require any opening for in- spection of vent pipe. Do not locate termination hood where excessive snow or ice build up may occur. Be sure to check vent
Resumo do conteúdo contido na página número 10
V Operable Dutchwest Direct Vent / Natural Vent Gas Heater General Venting Information - Termination Location INSIDE CORNER DETAIL G V N H N A D E L C B ����� B V B V ������ V Fixed Operable Closed F V B M V B J X B I X V K A CFM145a AREA WHERE TERMINAL IS NOT PERMITTED V VENT TERMINATION X AIR SUPPLY INLET 1 2 Canadian Installations US Installations A = Clearance above grade, veranda, porch, 12” (30cm) 12” (30cm) CFM145a DV Termin Location deck, or balcony 5/01/01 Rev. 12/05/01 B =
Resumo do conteúdo contido na página número 11
Dutchwest Direct Vent / Natural Vent Gas Heater Termination Clearances Termination clearances for buildings with combustible and noncombustible exteriors. Inside Corner Outside Corner Alcove Applications* D C C F = Combustible G = 6" (152 mm) Combustible V G 6" (152 mm) Noncombustible V E 2" (51 mm) Noncombustible O V F 2" (51 mm) Balcony - Balcony - with no side wall with perpendicular side wall E = Min. 6” (152 mm) for non-vinyl sidewalls Min. 12” (305 mm) for vinyl sidewalls O
Resumo do conteúdo contido na página número 12
Dutchwest Direct Vent / Natural Vent Gas Heater (1) Finishing plate (CG) Venting Requirements and Options - (1) Finishing collar (CG) Direct Vent ONLY (4) Polished Brass flue pipe rings Through the Wall Vent Kit 7TFSDVSK Approved Vent System Components (1) 90-Degree Elbow (CG) The Dutchwest Heater must be vented to the outdoors (1) 24” Straight pipe (CG) through an adjacent exterior wall or through the roof. The (1) 48” Straight pipe (CG) venting system must be comprised of the appropriate lis
Resumo do conteúdo contido na página número 13
Dutchwest Direct Vent / Natural Vent Gas Heater • Remove retaining nut from shaft of rheostat. (if Install the Optional Fan preinstalled) If you are installing the optional convection Fan Kit • Insert the rheostat through the hole in the back #2767 (FK26), continue here. If you are not installing a of the left side of the valve bracket, aligning the Fan Kit, go to Page 14, Venting System Assembly. locator pin with the smaller hole in that bracket. 1. The fan kit includes a Blower Assembly
Resumo do conteúdo contido na página número 14
Dutchwest Direct Vent / Natural Vent Gas Heater 5. Install the Outer Adapter Pipe. Apply a 1/4” bead Venting System Assembly - Direct Vent of cement around the inside wall of the pipe, about General Information 1” from the end. Insert the pipe over the stove flue collar, keeping the vertical seam oriented to the back The Dutchwest is approved for installation only with the of the stove. Also, be sure to align holes on the pipe vent components listed on Page 12. Follow the vent with the hol
Resumo do conteúdo contido na página número 15
Dutchwest Direct Vent / Natural Vent Gas Heater Side Wall Termination Assembly Install the Vent Adapter Pipe (Simpson Dura-Vent Components) 1. Locate the vent opening on the wall. Refer to Fig- ure 5, Page 6, to determine the opening centerline. 1. Install the Restrictor Plate. Consult the ‘Vent Run It may be necessary to first position the stove and Specifications’ on Page 8 to determine whether the measure to find the hole location. Depending on restrictor plate is needed. If so, put the re
Resumo do conteúdo contido na página número 16
Dutchwest Direct Vent / Natural Vent Gas Heater For DuraVent pipe only: Install vent pipe by align- ing the locking system together, sliding the pipes together and twisting clockwise. • Install 90° elbow. Twist lock as before. • Slide the wall plate over horizontal run before at- taching the horizontal run to the elbow. Fasten wall X plate to wall. 4. For CFM Vent Pipe only: If necessary, measure to determine the vertical length (X) of pipe required from the adapter pipe to the wall cutou
Resumo do conteúdo contido na página número 17
Dutchwest Direct Vent / Natural Vent Gas Heater Vent Termination Below Grade Recessed Wall Install Snorkel Kit #7FSDVSKS when it is not possible Firestop to meet the required vent termination clearances of 12” (305mm) above grade level. The snorkel kit will allow Finishing installation depth of down to 7” (178mm) below grade Collar Sheet Metal level. The seven inches is measured from the center of Screws and Bracket the horizontal vent pipe as it penetrates the wall. If the venting syst
Resumo do conteúdo contido na página número 18
Dutchwest Direct Vent / Natural Vent Gas Heater 8. Install appropriate pipe sections until the vent run Venting System Assembly - Natural Vent reaches above the flashing. The enlarged ends of General Information the vent sections always face downward. The Dutchwest Heater is shipped from the factory as 9. Install the storm collar and seal around the joints. a Direct Vent Heater. It may be converted to a Natural (Fig. 31) Vent heater by installing the Model Z31D00 FSDHAG 10. Add additional
Resumo do conteúdo contido na página número 19
Dutchwest Direct Vent / Natural Vent Gas Heater Attach the first section of venting to the draft hood. De- Left Log Right Log pending on the length of the individual venting sections and the lengths of the decorative pipe (if installed), you may need to slip the decorative pipe over the venting sections before attaching upper sections to lower ones. The sections of decorative pipe should be oriented with their seams (if any) toward the wall; sections usually do not need to be fastened at ea
Resumo do conteúdo contido na página número 20
D DUTCH UTCHW WEST EST Est. 1974 Dutchwest Direct Vent / Natural Vent Gas Heater In the U.S.; Gas connection should be made in ac- Air Shutter Adjustment Instructions cordance with current National Fuel Gas Code, ANSI Z223.1/NFPA 54. Since some municipalities have To adjust the air shutter, the following procedures additional local codes, be sure to consult your local should be followed: authority. 1. Remove stove front. Lift stove front up and then In Canada; consult the local authority an
