Resumo do conteúdo contido na página número 1
Yankee
Pellet Stove
• Horizontal Or Vertical Vent
• Freestanding Stove
• Mobile Home Approved
• Class A Chimney Retrofit
• Hearth Stove into Existing
Masonry Chimney , Masonry
Fireplace, or Z.C. Fireplace
Tested and Listed by
Omni-Test Laboratories, Inc.
Beaverton, Oregon
Report # 028–S–42-2
ASTME-1509 1995, ULCC 1482
-- Please read this entire manual before installation and use of this pellet fuel-
burning room heater. Failure to follow these instructions could result in property
damage bodil
Resumo do conteúdo contido na página número 2
2 Introduction Introduction We welcome you as a new owner of a Yankee pellet heater. In purchasing a Yankee you have joined the growing ranks of concerned individuals whose selection of an energy system reflects both a concern for the environment and aesthetics. The Yankee is one of the finest home heaters the world over. This manual will explain the installation, operation, and maintenance of this pellet-burning heater. Please familiarize yourself with the Owner's Manual before operating y
Resumo do conteúdo contido na página número 3
Table of Contents 3 Introduction Operation (continued) Introduction......................................................2 Manual Mode.....................................................21 Important Information .........................................2 Auto Mode........................................................22 Restrictor Adjustment.........................................23 Safety Precautions Adjusting the Fan Speed......................................23 Safety Precautions ..........
Resumo do conteúdo contido na página número 4
Gas 4 Safety Precautions • Do not operate the • Contact your local building heater if you smell officials to obtain a permit smoke coming from and information on any the heater. Turn the installation restrictions or MODE switch to inspection requirements Ok "OFF", monitor your in your area. Notify your heater, and call your insurance company of this dealer. heater as well. • Never use gasoline, • The exhaust system must gasoline-type lantern fuel, be completely airtight and kerosene, charcoal
Resumo do conteúdo contido na página número 5
Table of Contents 5 • The heater will not operate • This heater must be during a power outage. If connected to a standard a power outage does 115 V., 60 Hz grounded occur, check the heater electrical outlet. Do not for smoke spillage and use an adapter plug or open a window if any sever the grounding plug. smoke spills into the room. Do not route the electrical cord underneath, in front of, or over the heater. • Keep foreign objects out • When installed in a mobile ? of the hopper. home, the
Resumo do conteúdo contido na página número 6
6 Specifications Heating Specifications: Approximate Maximum Heating Capacity (in square feet)* ........................................800 to 2,250 Sq. Feet Burn Rate (Pounds per Hour)**............................................................................1.7 to 5.5 Maximum Burn Time on Low Burn** ......................................................................47 Hours Hopper Capacity ..............................................................................................80 Po
Resumo do conteúdo contido na página número 7
Installation (For Qualified Installers Only) 7 Before You Begin READ THIS ENTIRE MANUAL BEFORE YOU INSTALL AND USE THIS HEATER. FAILURE TO FOLLOW THE INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE, BODILY INJURY, OR EVEN DEATH. Check with local building officials for any permits required for installation of this pellet heater and notify your insurance company before proceeding with installation. Packing List • Thermostat & Wire • Scraper Rod Tool • Brush • Fuses (2) Installation Option
Resumo do conteúdo contido na página número 8
8 Installation (For Qualified Installers Only) Clearances - Straight Installation Through the Wall Installations Interior Vertical Vents A A AAAAAAAA 3” Minimum A A A AAAAAA A 2” Minimum “Tee” A A A AAAAAA A 3” Minimum AAAAAAAA A AAAAAA A A AAAAAA A A AAAAAA A 9” Minimum A AAAAAA A A AAAAAA A 9” Minimum A AAAAAA A A AAAAAA A A AAAAAA A A AAAAAA A A AAAAAA A A AAAAAA A A AAAAAA A A AAAAAA A A AAAAAA A Floor Protection A AAAAAA A 6” Minimum 6” Minimum A AAAAAA A AAAAAAAA AAAAAAAA Clearances - Co
Resumo do conteúdo contido na página número 9
Installation (For Qualified Installers Only) 9 Venting the Pellet Stove • PELLET VENT MUST MAINTAIN A MINIMUM 3" CLEARANCE TO ANY COMBUSTIBLE (INSTALL VENT AT CLEARANCES SPECIFIED BY THE VENT MANUFACTURER). • DO NOT CONNECT THE PELLET VENT TO A VENT SERVING ANY OTHER APPLIANCE OR STOVE. • DO NOT INSTALL A FLUE DAMPER IN THE EXHAUST VENTING SYSTEM OF THIS UNIT. • USE AN APPROVED WALL THIMBLE WHEN PASSING THE VENT THROUGH WALLS AND A CEILING SUPPORT/FIRE STOP SPACER WHEN PASSING THE VENT THROUGH C
Resumo do conteúdo contido na página número 10
10 Installation (For Qualified Installers Only) Pellet Vent Type • Must be 4" diameter Type "L" (except for masonry fireplace installations) - or - connect the vent to a factory built type "A" chimney. All vent joints (including adapters, elbows, etc…) must be sealed with 500° F. RTV silicone. Installing the Pellet Vent Seal each vent section (including adapters, elbows, etc...) by injecting a liberal amount of 500° F. RTV silicone into the gap between sections. • Horizontal sections must
Resumo do conteúdo contido na página número 11
Installation (For Qualified Installers Only) 11 Mobile Home Requirements • Outside air is required (used for combustion) - see the directions below. • The heater must be bolted to the floor (Some states do not require b this; check with your local building Use the lag bolts (used department). See the illustration to secure the stove to to the right. the pallet) to screw the pedestal to the floor. • The heater must be grounded to the steel chassis of the mobile home (Some states do not requir
Resumo do conteúdo contido na página número 12
12 Installation (For Qualified Installers Only) Alcove Installation Requirements When the pellet stove is placed in a location where the ceiling height is less than 7' tall, it is considered an alcove installation. Because of the reduced height, the requirements listed below must be met. • Minimum height is 60" • Maximum depth is 48" • Minimum width is 43" • Minimum clearance of 9" on each side and 3" on back Baffle Installation Install the baffles included with the stove (see page 29 for detai
Resumo do conteúdo contido na página número 13
Installation (For Qualified Installers Only) 13 Installation Example: Direct "Through-the-wall" Installation Horizontal Rain Cap Type "L" Outside Air Vent 12” Minimum House Shield (used to protect exterior wall from soot discoloration) is HIGHLY RECOMMENDED AAAAAAAAAAAAA A AAAAAAAAAAAAA AA A Seal each vent AAAAAAAAAAAAA AA A section (including AAAAAAAAAAAAA A 3” Minimum Wall Thimble (note adapters, elbows, AAAAAAAA A 3” clearance etc...) by injecting a between vent and A AAAAAA A A com
Resumo do conteúdo contido na página número 14
14 Installation (For Qualified Installers Only) Installation Example: Interior Vertical Installation AAAAAAAAAAAA A 2” 3” AAAAAAAA A Minimum Minimum A AAAAAA A A “Tee” Outside A AAAAAA A A Air Type "L" Vent (optional) A AAAAAA A A A AAAAAA A A A AAAAAA A A 9” Minimum A AAAAAA A A A AAAAAA A A AAAAAA A Floor Protection 6” Minimum A AAAAAA A AAAAAAAA Vertical Cap 24” Minimum Storm Collar AAAAAAAAAAAAAA AAAAAAAAAAAAAARoof Flashing AAAAAAAAAAAAAA AAA Insulation AAAAAAAAAAAAAA A A A must mainta
Resumo do conteúdo contido na página número 15
Installation (For Qualified Installers Only) 15 Installation Example: Class A Chimney Retrofit AAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAA A 2” 3” Minimum Minimum A AAAAAA A A “Tee” A AAAAAA A A Outside Air Type "L" Vent A AAAAAA A A (optional) A AAAAAA A A A AAAAAA A A 9” Minimum A AAAAAA A A A AAAAAA A A A AAAAAA A Seal each vent Floor Protection A AAAAAA 6” Minimum A section (including AAAAAAAA adapters, elbows, etc...) by injecting a AAAAA liberal amount of 500° F. RTV A AAAAAA A silicone i
Resumo do conteúdo contido na página número 16
16 Installation (For Qualified Installers Only) Installation Example: Masonry Fireplace Hearth Stove Vertical Cap “L” Vent Cover Plate (non-combustible) Storm Collar Seal the cover plate with silicone. AAAAA AAAA Seal each vent AAAAAAAA AA AAAAA AAAAAAAAAA AAAA section (including AAAA AAAA AA A A AAAAA AAAA adapters, elbows, etc...) by injecting a A AA A AAAA AAAA AAAAAA AAAA A AA A liberal amount of A AA A AAAAAA AA A A AAAAAAA A AA A 500° F. RTV silicone into the gap AAAA AAAA AA A A A
Resumo do conteúdo contido na página número 17
Installation (For Qualified Installers Only) 17 Installation Example: Zero-Clearance (Metal) Fireplace Hearth Stove Vertical Cap Cover Plate (non-combustible) Storm Collar Seal the cover plate with silicone. “L” Vent Seal each vent section (including AA adapters, elbows, AA etc...) by injecting a liberal amount of AAAA AA AAAA 500° F. RTV A AA A AA A AA A silicone into the gap between sections. A AA A AA A AA A AAAA AA AAAA AAAA AA “L” Vent Flex Section AAAA AA AAAAA Allow room for the
Resumo do conteúdo contido na página número 18
18 Installation (For Qualified Installers Only) Installation Example: Freestanding Masonry Chimney Vertical Cap “L” Vent Cover Plate (non-combustible) Storm Collar Seal the cover plate with silicone. AAAA AAAA AAAAAAA AA AAAAAAA AA AAAAAAA AA AA AAAAAA AAAAAA AAAA AAAA AA AAAA AAA AAA AAAA AAAA Seal each vent A AA A AAAA AA AAAA A A AAAAA A AA A section (including adapters, elbows, A AA A AAAAAA AA AAAA A A AAAAAAAAA A AA A etc...) by injecting a AAAA AAAA AAAA AAAA AAA AAA AAAA AAAA libera
Resumo do conteúdo contido na página número 19
Operation 19 Safety Notice Read this entire manual (especially the "Safety Precautions" on pages 4 and 5) before using this stove. Failure to follow the instructions may result in property damage, bodily injury, or even death. ! Do not unplug the stove to turn it off. This stove relies upon electricity to push the flue gases out the pellet vent – unplugging it may lead to smoke entering your room. ! Failure to maintain your heater will lead to a restricted combustion air system, leading to poo
Resumo do conteúdo contido na página número 20
s t l e l 20 Operation Loading Pellets Lift the hopper lid to its vertical position. Pour pellets into the hopper until full. To Close the Hopper Lid: To Open the Hopper Lid: lift the lid, pull this bar forward, lift the hopper lid from this then lower the lid down. handle. These notches allow you to open the hopper lid to the level you wish. AAAAAAAAAAAAAAAAAAAA AAAAAAAAAAAAAAAAAAAA AAAAAAAAAAAAAAAAAAA AAAAA Make sure pellets AAAAAAAAAAAA AAAAA are not left on this AAAAAAAAAAAA AAAAA hea
