Manual do usuário Yamaha yfm 350

Resumo do conteúdo contido na página número 1

INSTRUCTION SUPPLEMENT FOR 1987-
LATER YAMAHA YFM350 WARRIOR



Removing stock carburetor and cables.




1. Remove seat and gas tank. Make sure fuel
petcock is in “off” position.


2. Remove throttle cable paying close attention
Twist Throttle Instructions
to routing, as the new cable(s) will need too

be routed the same.
1. Install the throttle cables into the supplied

throttle housing and place onto clean
3. Remove stock carburetor and stock throttle
handlebar end.

Resumo do conteúdo contido na página número 2

NOTE: Modification of the stock thumb 2. Install cable into cable wheel on carburetor throttle housing will be required in order to in the 4:00 position and secure cable into achieve wide open throttle. Figures 4 and 5 lower slot on cable bracket by replacing end will show the mods. piece and Phillips screw. See figure 6. Figure 4. Figure 6. Mod number one is to remove material on the outside throttle stop that limits the thumb lever travel. This may be sufficient to

Resumo do conteúdo contido na página número 3

NOTE: If flooding occurs, slowly open throttle to wide open and hold. With throttle still open engage starter until engine fires. For any questions regarding tuning or installation of Edelbrock products, please call our toll free tech line M-F 8:00am-12: 30pm, 1:30pm-5:00pm PST. 877-888-7504 ext.2. Edelbrock #3011 and #3150 Warrior Carburetor Specifications Bore Size: 36mm Tall X 32mm Wide Needle: 18E @ 12 Clicks Accelerator Pump Bypass: 2.5 turns out Alter