Resumo do conteúdo contido na página número 1
Installation Instructions
Part No. 8528107
IMPORTANT:
Read and save COMMERCIAL
these instructions DRYER
IMPORTANT
GAS ELECTRIC
Installer: Leave Installation Instructions
with the owner.
120-volt, 60 Hz 120/240-volt, 60 Hz
Owner: Keep Installation Instructions for
future reference.
Save Installation Instructions for local
®
electrical inspector’s use.
COMMERCIAL
www.whirlpool.com
LAUNDRY
PRODUCTS
Resumo do conteúdo contido na página número 2
IMPORTANT SAFETY INSTRUCTIONS Before you start... WARNING — To reduce the risk of fire, electric shock, or injury to persons when Your safety and the safety of others are very important. using your appliance, follow basic precautions, including the following: We have provided many important safety messages in this manual and DANGER 1. Read all instructions before using the appliance. on your appliance. Always read and You can be killed or seriously obey all safety messages. 2. Do not dry article
Resumo do conteúdo contido na página número 3
The console houses the electronic exhaust airflow For exhaust systems not covered by control board. The board is factory set the exhaust length chart, see better good for a dry time of 45 minutes. Consult Whirlpool Service Manual, “Exhausting exhaust exhaust the Tech Sheet found inside the dryer airflow airflow Whirlpool Dryers,” Part No. 603197, toe panel to reset dry time and for available from your Whirlpool parts other options. distributor. The coin-slide mechanism, control The dryer must be
Resumo do conteúdo contido na página número 4
dryer exhaust vent dryer exhaust vent An exhaust hood should cap the A main exhaust vent can be used for outside end of the main vent to exhausting a group of dryers. Main Gas Dryer prevent exhausted air from returning exhaust vent should be sized to to the dryers. If an exhaust hood remove 200 CFM of air per dryer. cannot be used, the outside end of Gas requirements Large-capacity lint screens of proper the main duct should have a sweep design may be used in the main elbow directed downward. If
Resumo do conteúdo contido na página número 5
A 120-volt, 60-Hz, AC-only, 15- or C. Check that dryer is equipped H. If local codes and ordinances 20-ampere fused electrical supply is with the correct burner for the permit, it is recommended that new required. A time-delay fuse or circuit particular type of gas used. Burner flexible gas connector, design- breaker is recommended. information can be found on the certified by the AGA or CSA, be used It is recommended that a separate serial/rating plate in the door well of for connecting the d
Resumo do conteúdo contido na página número 6
Now Start... 10. Use a non-corrosive leak WARNING detection fluid to check for leaks. With dryer in laundry area. Bubbles around connections will indicate a leak. If a leak appears, shut off gas valve controls and adjust WARNING connections. Then check Excessive Weight Hazard connections again. Close toe panel. All connections must be wrench- Use two or more people to move and Electrical Shock Hazard tightened. install dryer. Disconnect power before Failure to do so can result in back or servici
Resumo do conteúdo contido na página número 7
Now Start... Electric Dryer WARNING Electrical WARNING requirements Excessive Weight Hazard Use two or more people to move If codes permit and a separate and install dryer. Electrical Shock Hazard ground wire is used, it is Disconnect power before recommended that a qualified Failure to do so can result in servicing. electrician determine that the ground back or other injury. path is adequate. Replace all parts and panels Important: Observe all governing With dryer in laundry area... before ope
Resumo do conteúdo contido na página número 8
WARNING - Improper connection of Direct wire (U.S. only) 7.U.S. installations: the equipment-grounding conductor Make electrical connection. can result in a risk of electric shock. Check with a qualified electrician or This dryer is manufactured with the WARNING service representative or personnel if cabinet-ground conductor you are in doubt as to whether the connected to the NEUTRAL (center) of appliance is properly grounded. Do the wiring harness at the terminal not modify the plug provided w
Resumo do conteúdo contido na página número 9
Four-wire connection... Four-wire receptacle POWER SUPPLY CORD 4. Remove center terminal block screw. 5. Remove appliance ground wire spade (green with yellow stripes) from terminals with external ground connector screw. upturned ends Fasten under center, silver-colored terminal block screw. 6. Connect ground wire (green) of 3/4" U.L.-listed NEUTRAL (white) power supply cord to external NEUTRAL strain relief ground conductor screw. Tighten screw. 7. Connect neutral wire (white or center) of pow
Resumo do conteúdo contido na página número 10
Three-wire connection... Three-wire receptacle Where local codes permit POWER SUPPLY CORD connecting cabinet-ground conductor to neutral wire: 4. Loosen or remove center spade terminal block screw. terminals with upturned ends 5. Connect the neutral wire (white or center) of power supply cord to ring the center, silver-colored terminal terminals screw of the terminal block. This blade connected Tighten screw. to this conductor. 6. Connect the other wires to outer terminal block screws. Tighten
Resumo do conteúdo contido na página número 11
Three-wire connection... Three-wire receptacle DIRECT WIRE OR Where local codes Do Not permit connecting cabinet-ground conductor to neutral wire: POWER SUPPLY CORD 9. After reattaching the terminal cover, connect a separate copper ground wire from the external Three-wire power supply cord must 4. Remove center terminal block ground connector screw to an have three, No.-10 copper wires and screw. adequate ground. match a three-wire receptacle of NEMA Type 10-30R. 5. Remove the appliance harness
Resumo do conteúdo contido na página número 12
Recessed area and Maintenance If dryer does not closet installation instructions operate properly... • Clean lint screen after each cycle. instructions Check the following to be sure that: • Keep dryer area clear and free from 1. Electric supply is connected. This dryer may be installed in a combustible materials, gasoline and recessed area or closet. For recessed 2. Circuit breakers are not tripped or other flammable vapors and liquids. area and closet installations, house fuses blown. • Do not
Resumo do conteúdo contido na página número 13
Product dimensions 29" (73.7 cm) dryer 25-1/2" (64.8 cm) 29" (73.7 cm) non-coin-operated models: 7-1/8" (18.1 cm) ELECTRIC 35" coin-operated (88.9 cm) 16" models: (40.6 cm) 7-7/8" (20 cm) 27-1/4" (69.2 cm) 4-3/4" 4" (10.2 cm) 13" (12.1 cm) dia. (33 cm) 1-1/4" (3.2 cm) GAS EXHAUST 18-3/8" 1" (46.7 cm) (2.5 cm) BACK VIEW SIDE VIEW 27" (68.6 cm) dryer 29-1/4" (74.3 cm) 26-1/2" (67.3 cm) 27" (68.6 cm) non-coin- ELECTRIC 14" operated models: (35.6 cm) 7-1/8" (18.1 cm) 37" coin-operated (94 cm) mo
Resumo do conteúdo contido na página número 14
Instructions d’installation Pièce n° 8528107 IMPORTANT : Lire et conserver SÉCHEUSE ces instructions. COMMERCIALE IMPORTANT GAZ ÉLECTRIQUE Installateur : Remettre les instructions d’installation au propriétaire. 120 volts, 60 Hz 120/240 volts, 60 Hz Propriétaire : Conserver les instructions d’installation pour consultation ultérieure. Conserver les instructions d’installation pour consultation par l’inspecteur local des ® installations électriques. APPAREILS DE www.whirlpool.com BUANDERIE COMM
Resumo do conteúdo contido na página número 15
Avant de commencer... INSTRUCTIONS DE SÉCURITÉ IMPORTANTES Votre sécurité et celle des autres est très importante. Avertissement – Pour réduire le risque d’incendie, choc électrique ou Nous donnons de nombreux dommages corporels lors de l’utilisation DANGER messages de sécurité importants de l’appareil, observer les précautions dans ce manuel et sur votre Risque possible de décès ou de fondamentales, dont les suivantes : appareil ménager. Assurez-vous de blessure grave si vous ne suivez 1. Lire
Resumo do conteúdo contido na página número 16
Ne pas évacuer l’air de la sécheuse CONSERVEZ CES INSTRUCTIONS TYPE DE BOUCHE DE DÉCHARGE dans le conduit d’évacuation d’un 10,2 cm 10,2 cm appareil à gaz, dans une cheminée, (4 po) (4 po) Afficher cet avertissement en un Nbre de un mur, un plafond ou un vide endroit très visible. coudes sanitaire. À 90° POUR VOTRE SÉCURITÉ Ne pas installer un conduit flexible dans Ne pas entreposer ni utiliser de les cavités fermées des murs, plafonds 10,2 cm l’essence ou d’autres produits (4 po) ou planchers.
Resumo do conteúdo contido na página número 17
conduit d’évacuation de sécheuse conduit d’évacuation de sécheuse Un conduit d’évacuation collectif peut être L’extrémité du conduit principal Sécheuse à gaz utilisé pour un groupe de sécheuses. Le d’évacuation devrait être dotée d’une conduit d’évacuation principal devrait bouche de décharge empêchant l’air être d’un diamètre suffisant pour évacuer d’évacuation de revenir vers les sécheuses. Spécifications 3 94,4 litres/sec (200 pi /m) d’air par Si une bouche de décharge ne peut être sécheuse.
Resumo do conteúdo contido na página número 18
Important : Respecter les prescriptions de C. Vérifier que la sécheuse est équipée H. Si les codes et règlements locaux tous les codes et règlements en vigueur. du brûleur convenable, correspondant au le permettent, on recommande L’appareil doit être alimenté par un circuit gaz spécifique qui alimente l’habitation. l’utilisation d’un conduit de raccor- électrique de 120 V (CA seulement), 60-Hz, L’information sur le brûleur se trouve sur la dement neuf flexible de conception protégé par un fusibl
Resumo do conteúdo contido na página número 19
Commencer... 10. Utiliser un liquide non corrosif de AVERTISSEMENT détection des fuites pour rechercher les fuites. La formation de bulles au niveau Avec la sécheuse dans la buanderie. d’une connexion indique la présence d’une fuite. En présence d’une fuite, fermer les robinets d’arrêt de la AVERTISSEMENT canalisation de gaz et ajuster les raccords. Vérifier de nouveau les raccords. Fermer le Risque de choc électrique Risque du poids excessif panneau de plinthe. Toutes les connexions Déconnecter
Resumo do conteúdo contido na página número 20
Commencer... Sécheuse électrique AVERTISSEMENT Spécifications de AVERTISSEMENT l’installation électrique Risque du poids excessif Utiliser deux ou plus de personnes Si on utilise un conducteur distinct de Risque de choc électrique pour déplacer et installer la sécheuse. liaison à la terre lorsque le code local le Déconnecter le courant électrique Le non-respect de cette instruction permet, il est recommandé qu’un avant d'entreprendre des travaux. peut causer une blessure au dos ou électricien qu
