Manual do usuário Dukane DK140

Manual para o dispositivo Dukane DK140

Dispositivo: Dukane DK140
Categoria: Detector do radar
Fabricante: Dukane
Tamanho: 0.55 MB
Data de adição: 4/20/2013
Número de páginas: 25
Imprimir o manual

Baixar

Como usar?

Nosso objetivo é fornecer-lhe o mais rapidamente possível o acesso ao conteúdo contido no manual de instruções para Dukane DK140. Usando a pré-visualização online, você pode visualizar rapidamente o índice e ir para a página onde você vai encontrar a solução para seu problema com Dukane DK140.

Para sua conveniência

Se a consulta dos manuais Dukane DK140 diretamente no site não for conveniente para você, você tem duas soluções possíveis:

  • Visualização em tela cheia - Para visualizar facilmente o manual do usuário (sem baixá-lo para seu computador), você pode usar o modo de tela cheia. Para começar a visualização do manual Dukane DK140 no modo de tela cheia, use o botão Tela cheia.
  • Download para seu computador - você também pode baixar o manual Dukane DK140 em seu computador e mantê-lo em suas coleções. No entanto, se você não quer perder espaço no seu dispositivo, você sempre pode baixá-lo no futuro a partir de ManualsBase.
Dukane DK140 Manual de instruções - Online PDF
Advertisement
« Page 1 of 25 »
Advertisement
Versão para impressão

Muitas pessoas preferem ler os documentos não na tela, mas na versão impressa. A opção de imprimir o manual também foi fornecida, você pode usá-la clicando na hiperligação acima - Imprimir o manual. Você não precisa imprimir o manual inteiro Dukane DK140, apenas as páginas selecionadas. Respeite o papel.

Resumos

Abaixo você encontrará previews do conteúdo contido nas páginas subseqüentes do manual para Dukane DK140. Se você deseja visualizar rapidamente o conteúdo das páginas subseqüentes, você pode usá-los.

Resumos do conteúdo
Resumo do conteúdo contido na página número 1

DUKANE CORPORATION
SEACOM DIVISION
TECHNICAL MANUAL
UNDERWATER ACOUSTIC BEACON
MODELS DK100/DK120/DK130/DK140
April 13, 2004
REV 13
DUKANE CORPORATION ST. CHARLES, ILLINOIS 60174 PHONE: 630-762-4050 FAX: 630-762-4049
DOCUMENT NO. 03-TM-0037 © DUKANE CORPORATION
E-MAIL: seacom@dukcorp.com INTERNET: www.dukcorp.com/seacom
Page 1 of 24
03-TM-0037 REV 13

Resumo do conteúdo contido na página número 2

This manual should be read in its entirety prior to any installation, operation, testing or maintenance of the DK100/DK120/DK130/DK140 Underwater Acoustic Beacons. Page 2 of 24 03-TM-0037 REV 13

Resumo do conteúdo contido na página número 3

TABLE OF CONTENTS SECTION I................................................................................................................... 5 GENERAL INFORMATION..................................................................................... 5 1.1. INTRODUCTION. .......................................................................................................... 5 1.2. GENERAL DESCRIPTION. .......................................................................................... 5 S

Resumo do conteúdo contido na página número 4

6.6. BATTERY REPLACEMENT AND TESTING.............................................................. 18 6.7. BEACON OFF-CURRENT TEST. ............................................................................... 21 6.8. BATTERY DISPOSAL. ............................................................................................... 21 6.9. BEACON STORAGE. ................................................................................................. 21 6.10. BEACON OVERHAUL....................

Resumo do conteúdo contido na página número 5

SECTION I GENERAL INFORMATION 1.1. INTRODUCTION. shock and deep-water immersion. As shown on page 6 and 7, the DK Series beacons operate for 1.1.1. GENERAL. This manual contains the de- 30 days when immersed in water. See Figure 2. scription, theory, installation and maintenance for the DK100/DK120/DK130/DK140 Underwater Acoustic Beacon, hereafter referred to as the “DK Series”, manufactured by Dukane Corporation, Seacom Division, 2900 Dukane Drive, St. Charles, Illinois, 60174. See Figures 1 an

Resumo do conteúdo contido na página número 6

DK100/DK120 BEACON SPECIFICATIONS 37.5 kHz ± 1 kHz Operating Freuency............................................... Surface to 20,000 feet (6096 meters) Operating Depth.................................................... 10 milliseconds + 10% Pulse Length......................................................... Not less than 0.9 Pulse/Sec Pulse Repetition Rate............................................ 30 days (minimum) Operating Life....................................................... 6 Y

Resumo do conteúdo contido na página número 7

DK130/DK140 BEACON SPECIFICATIONS Operating Freuency............................................... 37.5 kHz ± 1 kHz Operating Depth.................................................... Surface to 20,000 feet (6096 meters) Pulse Length......................................................... 10 milliseconds + 10% Pulse Repetition Rate............................................ Not less than 0.9 Pulse/Sec Operating Life....................................................... 30 days (minimum) Ba

Resumo do conteúdo contido na página número 8

SECTION II INSTALLATION 2.4.2. The beacon is a battery-powered device 2.1. GENERAL. and installed shelf life is affected by higher than normal temperatures. Maximum temperature This section describes the installation of the must not exceed 160°F (71°C). beacon mounting kits and the installation of the DK Series beacons into these mounts. 2.4.3. Inadvertent actuation of the water switch by any source of water, such as rain, salt spray, 2.2. INSTALLATION CRITERIA OF THE melting ice or snow, head o

Resumo do conteúdo contido na página número 9

NOTE 2.6. INSTALLATION PROCEDURES FOR THE DK100/DK120 AND THE N30A26 The mounting bracket can be used as a tem- SERIES MOUNTING KIT. plate to mark for drilling the holes prior to the installation of beacon. Always remove 2.6.1. GENERAL. Model N30A26 Series beacon from mount prior to marking or drill- Mounting Kit (Cradle Type) is an aluminum ing. extrusion with a screw-attached securing plate that provides rugged mounting and protection of CAUTION the beacon within the aircraft. See Figure 3. T

Resumo do conteúdo contido na página número 10

C. Test the beacon as outlined in Section IV to 2.7.2. MOUNTING PROCEDURE insure operation prior to installation. A. Lay out four holes as shown in Figure 5. Position mounting kit carefully to avoid interfer- ence with other structures. Observe the clear- ances required as shown in Figures 5 and 6, and in established tool and maintenance clearances. B. Drill the four 0.272 inch (0.691 cm) (“I” drill) holes in the mounting surface as shown in Figure 5. Figure 4. Installation of N30A26 Series Moun

Resumo do conteúdo contido na página número 11

If vertical mounting is employed, the switch end should be facing downwards to reduce the accumulation of dirt, grease, and water on the switch end. Rotate the beacon in the mount, so that the markings and beacon replacement date label can be read. Figure 8. Securing Beacon in N30A21A Mounting Kit 2.7.3. INSTALLING BEACON INTO N30A21A MOUNTING KIT. Figure 6. N30A21A Mounting Kit A. Test the beacon as outlined in Section IV to and Beacon Overall Dimensions insure operation prior to installation.

Resumo do conteúdo contido na página número 12

NOTE 2.8. INSTALLATION PROCEDURES FOR THE DK130/DK140 AND THE N30A29 The mounting bracket can be used as a SERIES MOUNTING KIT. template to mark for drilling the holes prior to the installation of the beacon. 2.8.1. GENERAL. Model N30A29 Series Always remove the beacon from the mount Mounting Kit (Cradle Type) is an aluminum prior to marking or drilling. extrusion with a screw-attached securing plate that provides rugged mounting and protection of CAUTION the beacon within the aircraft. See Figu

Resumo do conteúdo contido na página número 13

B. Make sure that the beacon case and water 2.9.2. MOUNTING PROCEDURE. switch, are free of grease or film. If in doubt, wipe clean with mild detergent A. Lay out four holes as shown in Figure 11. Po- C. Test the beacon as outlined in Section IV to sition mounting kit carefully to avoid insure operation prior to installation. interferencewith other structures. Observe the clearances required as shown in Figures 11 and 12, and in established tool and maintenance clear- ances. B. Drill the four 0.

Resumo do conteúdo contido na página número 14

E. Insert the ends of the retainer straps through the 0.272 inch (0.691 cm) holes in the mounting surface. When horizontal mounting is used, position beacon with switch end forward. If vertical mounting is employed, the switch end should be facing downwards to reduce the accumulation of grease and dirt on the switch end. Rotate the beacon in the mount, so that the markings and beacon replacement date label can be read. Figure 14. Securing Beacon In F. Install a flat washer and nut on each end of

Resumo do conteúdo contido na página número 15

SECTION III OPERATION 3.1. THEORY OF OPERATION. 3.1.1. The DK Series beacon is a battery-oper- ated underwater acoustic pulse generator that is activated when the water switch is immersed in either fresh or salt water. Figure 15. Nominal Pulse Train 3.1.2. The water switch is part of a triggering will operate for a minimum of 30 days after circuit, which when actuated will initiate normal being immersed in the water. The beacon will pulsing of the beacon circuit. The signal is withstand depths t

Resumo do conteúdo contido na página número 16

SECTION IV TESTING 4.1. GENERAL. CODE MINIMUM ACCEPTABLE The DK Series beacon should be tested before VOLTAGE and after installation in the mounting kit and at recommended maintenance intervals. See Sec- A 3.55 VOLTS tions V and VI. B 2.97 VOLTS 4.2. BATTERY TESTING. Use a high impedance voltmeter (input imped- C 2.97 VOLTS ance of 10 M ohms) (not required when using TS100 or TS200 Test Set) to pe

Resumo do conteúdo contido na página número 17

SECTION V MAINTENANCE DK100/DK130 5.1. GENERAL. 5.4.3. Any situation that could possibly crush or penetrate the case of the beacon should be This section contains DK100/DK130 Beacon cleaning, beacon testing, battery testing, disposal avoided. and storage procedures. Initially beacons must be 5.5. BATTERY. tested at every installation or beacon change. The required schedule for battery replacement, WARNING available only at Dukane Corporation is every six years. REMOVAL OF BATTERY FROM BEA- CON W

Resumo do conteúdo contido na página número 18

SECTION VI MAINTENANCE DK120/DK140 6.1. GENERAL. 6.4.2. Any situation that could possibly crush or penetrate the case of the beacon should be This section contains DK120/DK140 Beacon avoided. cleaning, beacon testing, battery replacement and 6.5. BEACON DISASSEMBLY. testing, disposal and storage procedures. Initially beacons must be tested at every installation or battery change. The required schedule for Bat- Disassembly of the beacon is limited to battery tery Replacement and Off-Current Testi

Resumo do conteúdo contido na página número 19

G. Clean the threads, O-ring groove in the body and the threads on the cover by wiping them thoroughly with solvent. CAUTION FOREIGN SUBSTANCES IN LUBRI- CANT ON SEALING SURFACES MAY DAMAGE THREADS AND/OR AL- LOW WATER LEAKAGE THROUGH THE O-RING SEAL. SCRATCHES OR GOUGES ON SEALING SURFACES WILL ALSO CAUSE WATER LEAK- AGE. Figure 18. Battery End Cover Re- H. Carefully install a new O-ring on the battery moval With Vise Clamp and Span- cover. Apply a thin coating of O-ring lubricant ner Wrench

Resumo do conteúdo contido na página número 20

Figure 20. Beacon Exploded View Showing Relative Location of Battery and Related Parts WARNING J. Perform OFF-CURRENT TEST as outlined in Section 6.7. REPLACE BATTERY WITH AUTHO- RIZED REPLACEMENT PARTS K. Position rubber shock cushion around contact ONLY. USE OF AN UNAUTHO- spring and on the inside of the battery cover. RIZED BATTERY WILL VOID THE WARRANTY AND MAY CAUSE AN L. Replace the cover and tighten it until the INOPERATIVE OR DANGEROUS cover flange contacts the body or leaves less than


Manuais similares
# Manual do usuário Categoria Baixar
1 Dukane DK100 Manual de instruções Detector do radar 30
2 Dukane DK120 Manual de instruções Detector do radar 84
3 Dukane DK130 Manual de instruções Detector do radar 11
4 Edelbrock 1725 Manual de instruções Detector do radar 1
5 AVE - American Video EquipmentRG-2RS Manual de instruções Detector do radar 2
6 Beltronics 995 Manual de instruções Detector do radar 108
7 Beltronics pmn Manual de instruções Detector do radar 3
8 Beltronics GX65 Manual de instruções Detector do radar 9
9 Beltronics RX65 Manual de instruções Detector do radar 158
10 Beltronics 980 Manual de instruções Detector do radar 8
11 Beltronics RX45 Manual de instruções Detector do radar 3
12 Beltronics LP904 Manual de instruções Detector do radar 3
13 Beltronics E936CS Manual de instruções Detector do radar 1
14 Beltronics STi DRIVER Manual de instruções Detector do radar 12
15 Beltronics STi-R Manual de instruções Detector do radar 29