Manual do usuário Hunter Fan MODEL TYPE A 41535-01

Resumo do conteúdo contido na página número 1

®
Installation Instructions
For Hunter Low Profile Ceiling Fan
Read And Save These Instructions
Caution!
Step 2: Inspection of Fan
1. Read entire instructions before beginning installation.
A. Unpack the fan carefully to avoid any damage to the
2. To avoid possible electrical shock, be certain electric-
components.
ity is shut off at main panel before wiring.
B. Check for any shipping damage to the motor assem-
3. All wiring must be in accordance with national and lo-
bly and the fan blades. If

Resumo do conteúdo contido na página número 2

OUTLET BOX 2 x 4 BRACE B. Bring electrical cable into the outlet box and attach with an approved connector. Make certain that wiring meets all national and local electrical codes. Wire leads should extend at least 6" beyond outlet box for ease in mak- ing connections. See Figure 3. CEILING PLATE HANGER BRACKET FLAT WASHER MOUNTING SCREWS CONNECTOR 6" MIN. LEAD LENGTH FIGURE 6 FIGURE 3 Step 5: Hanging of Motor Step 4: Installation of Ceiling Plate Caution: Do not lift motor by wires. A. I

Resumo do conteúdo contido na página número 3

Step 6: Final Wiring A. Connect electrical supply leads to the leads from mo- tor, using approved connectors. See Figure 9. ASSEMBLY SCREWS 1. Connect black electrical supply lead to the black motor FAN HOUSING lead and the black with white stripe motor lead (see note). 2. Connect the white electrical supply lead to the white motor lead. FIGURE 10 3. Connect the ground wire to the green leads. NOTE: If a separate wall switch will be used to control a light- Step 8: Attaching and Balancing t

Resumo do conteúdo contido na página número 4

B. Remove the screws from the motor hub. Insert one of these screws in hole in blade bracket. Use a screw- driver to hold in place. Align blade holes with mounting holes in hub, by turning screw and readjusting blade bracket until screw mates with threaded hole in hub. Do not tighten until both screws have been put in blade bracket. Repeat for all blades. See Figure 13. C. A blade balancing kit has been provided with your fan. Should the fan wobble in operation, you may use this kit to correct t

Resumo do conteúdo contido na página número 5

Step 11: Operation of Fan A. Turn electrical service on at main panel. B. Switch operates in this sequence: “high,” “medium,” “low,” “off.” Pull chain slowly to operate. Also, release the chain slowly so as to prevent chain from flying up into blades, possibly resulting in damage to blades or pull chain. The breakaway connector is designed to separate from the chain at a predetermined force. If this separation occurs, simply reinsert connector. It can be reused again and again. C. Motor is elec