Manual do usuário APC 3-16kVA

Resumo do conteúdo contido na página número 1

USER CONFIGURABLE
Whenever possible, attach one top screw and one bottom screw into a wall stud. If stud
mounting is not possible, use an expandable wall anchor. Screws are not included; .25” x
Attention: When using an online UPS, put the UPS in automatic bypass mode before
2” lag bolts are recommended.
rotating the SBP switch.

x4
1. Normal: Power is directed from the utility outlet, through the Bypass Panel and UPS,
and to connected equipment. For use during normal UPS op

Resumo do conteúdo contido na página número 2

F. SBP10KRMT4U CONNECTING POWER TROUBLESHOOTING Use the chart below to solve minor SBP installation problems. Also, refer to the UPS User Warning: Do not modify inlets or outlets. The SBP and UPS plugs and receptacles Manual Troubleshooting section. For more complex issues, refer to www.apc.com. should match. For more information, contact APC. 1. Non-Hardwired Panels Problem and Solution Possible Cause 1. Plug SBP UPS output cord into UPS PDU panel.* UPS WILL NOT TURN ON AFTER ON