Resumo do conteúdo contido na página número 1
Owner’s Manual
1838
PC Programmable Multi-Door Access Controller
DoorKing, Inc.
120 Glasgow Avenue
Inglewood, California
90301
U.S.A.
Phone: 310-645-0023
Fax: 310-641-1586
www.doorking.com
P/N 1838-065 REV L, 3/10
Copyright 2003 DoorKing, Inc. All rights reserved.
Resumo do conteúdo contido na página número 2
Page 2 1838-065-L-3-10
Resumo do conteúdo contido na página número 3
Use this manual with the following models only. Model 1838 Access Controller, REV F or Higher DoorKing, Inc. reserves the right to make changes in the products described in this manual without notice and without obligation of DoorKing, Inc. to notify any persons of any such revisions or changes. Additionally, DoorKing, Inc. makes no representations or warranties with respect to this manual. This manual is copyrighted, all rights reserved. No portion of this manual may b
Resumo do conteúdo contido na página número 4
TABLE OF CONTENTS Preface Important Notices......................................................................................................................................................6 Important Information................................................................................................................................................7 Features ...........................................................................................................................
Resumo do conteúdo contido na página número 5
3.5 Device Codes 3.5.1 Programming Device Codes....................................................................................................33 3.5.2 Deleting Device Codes.............................................................................................................33 3.5.3 Enabling Facility Codes............................................................................................................33 3.5.4 Programming Facility Codes...............................
Resumo do conteúdo contido na página número 6
IMPORTANT NOTICE FCC - UNITED STATES This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to Part 15 of the FCC Rules and Regulations. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause h
Resumo do conteúdo contido na página número 7
IMPORTANT INFORMATION • Prior to beginning the installation of the access control system, we suggest that you become familiar with the instructions, illustrations, and wiring guidelines in this manual. This will help insure that you installation is performed in an efficient and professional manner. • The proper installation of the access controller is an extremely important and integral part of the overall access control system. Check all local building ordinances and building codes
Resumo do conteúdo contido na página número 8
FEATURES • Can provide service for up to 3000 system users. • Can store up to 8000 card, transmitter or digital PIN codes. • Can interface with DKS Remote Call Stations to provide telephone communication and entry control (P/N 1838-120, 1838-121). • System can be programmed with a PC by modem, RS-232 (requires 1818-040 RS-232 cable), via the internet using DKS Modem Server, via the internet using DKS Internet Server or by a LAN connection (LAN and internet server option requires 1830-17
Resumo do conteúdo contido na página número 9
SECTION 1 - INSTALLATION If you are going to use a telephone line with this controller, order it at least two weeks prior to the planned installation date. This will assure that a phone line is available when the unit is installed. The telephone company will require the following information from you: Type: Touch Tone, Loop Start Ringer Equivalence: 0.0 A Jack Type: RJ11C FCC Registration (US): DUF6VT-12874-OT-T DOC (Canada): 1736 4528 A Electrical Listing: Complies with U.L.
Resumo do conteúdo contido na página número 10
10.25 2.0 9.0 .5 10.0 1.1.1 Mount Information If used to control a door or pedestrian gate, try to locate the access controller as near as possible to the entry point. The unit should be mounted on a rigid wall to prevent excessive shock and vibration from closing doors or gates. Continuous vibration and shock from slamming doors or spring-loaded pedestrian gates will damage the circuit board. Under no circumstances should the unit be mounted directly to a moving door or gate. .625
Resumo do conteúdo contido na página número 11
1.2 Memory Chip Installation The access controller is shipped with two memory chips packaged in a separate box inside the shipping container. The memory chips must be installed for the system to operate. CAUTION!! Do not install the memory chips with power to the system turned on. Attempting to install the memory chips with power on will irrevocably damage the chips. Memory chips are a static sensitive component. Discharge any static electricity from your hands by touching a p
Resumo do conteúdo contido na página número 12
Page 12 1838-065-L-3-10
Resumo do conteúdo contido na página número 13
SECTION 2 – WIRING Prior to installing wiring to the access control system, we suggest that you become familiar with the instructions, illustrations, and wiring guidelines in this manual. This will help insure that you installation is performed in an efficient and professional manner. The wiring of the access control panel is an extremely important and integral part of the overall access control system. Use proper wire for the communication line, power wires, and be sure that the
Resumo do conteúdo contido na página número 14
2.1 WIRING GUIDELINES Do not run high voltage (115 V) power lines and communication lines in the same conduit. These should be in separate conduits at least six (6) inches apart. Be sure that all phone line wiring is twisted and completely isolated from ground. Use only the supplied 16.5 VAC (or U.L. listed equivalent) to power the access control system. Do not power any other devices (electric strikes, magnetic locks, lights, etc.) from this transformer. Do not run 16 VAC acce
Resumo do conteúdo contido na página número 15
2.2 TERMINAL DESCRIPTIONS MAIN DESCRIPTION 1 Phone Line Connection – 800 ft. maximum with 24 AWG wire; 1600 ft. maximum with 22 AWG wire. 2 Phone Line Connection – 800 ft. maximum with 24 AWG wire; 1600 ft. maximum with 22 AWG wire. 3 Earth Ground Only. 4 Switch Input. A closure between terminals 4 and 6 will cause the designated relay(s) to activate for the programmed strike time. The Postal Switch is connected here. 5 Microphone Input. 6 Common for switch input, A and Z input,
Resumo do conteúdo contido na página número 16
2.3 WIRING DETAIL 2.3.1 Controller Only 30 Series Controller Detail Wiring 6 DATA 1 WHT 1 1 20 ELEVATOR RS 232 Elevator DATA 0 GRN Central Office phone line - touch tone, loop start. 2 2 21 CONTROL 1 Connection Control COMMON BLK 3 22 3 2348-010 4 A switch closure across terminals 4 & 6 will activate relay 1 7 16 5 2 for its programmed strike time. 6 8 Battery Backup - separate batteries required for phone 3 system and weigand terminals. 16 Volt, 20 VA UL Listed Transformer. 4 For 18
Resumo do conteúdo contido na página número 17
2.3.2 Controller & Expansion Boards 1-8 30 Series Controller to 2351-010 Expansion Boards 1-8 Detail Wiring 1 1 RS 232 Elevator 2 2 Connection Control 3 3 4 12 5 6 14 13 12 11 7 10 7 10 LOCK LOCK PWR PWR DOOR DOOR LOCK LOCK 8 Board 1 Board 2 + 12 VDC 10 COMMON System Relay 3 System Relay 4 9 DATA 1 8 P2 P1 P2 P1 DATA 0 7 GRN GRN 6 5 6 5 WHT WHT 7 6 7 6 BLK BLK 6 16 VAC 8 8 RED RED 5 OUTPUT 9 9 10 10 6 6 RED RED RED RED + 4 NEG 12 VDC INPUT BLK BLK BLK BLK POS 12 VDC INPUT 3 7 7 To WHT WHT W
Resumo do conteúdo contido na página número 18
2.3.3 Controller & Expansion Boards 1-16 30 Series Controller to 2351-010 Expansion Boards 1-16 Detail Wiring 10 LOCK 10 LOCK 1 1 7 7 RS 232 Elevator PWR PWR 2 2 Connection Control 3 3 4 12 5 DOOR DOOR 6 LOCK LOCK P2 P1 P2 P1 6 5 6 5 7 6 7 6 8 8 9 9 10 10 11 + 12 VDC 14 RED RED 6 RED RED 6 COMMON 13 BLK BLK BLK BLK 7 7 DATA 1 12 WHT WHT WHT WHT To 8 8 DATA 0 11 GRN GRN GRN GRN Boards 9 9 BRN BRN BRN BRN 9-16 BLU BLU BLU BLU 17 17 13 13 12 12 13 13 14 16 VAC 14 16 VAC 2351-010 2351-010 PWR PWR 6
Resumo do conteúdo contido na página número 19
2.3.4 Controller and 1838-120 & 121 Remote Call Stations 1 1 RS 232 Elevator 2 2 Connection Control 3 3 4 5 6 5 Card Reader RED RED + 12 VDC 14 14 BLK BLK COMMON 13 13 12 8 WHT WHT DATA 1 12 12 GRN GRN DATA 0 11 11 10 9 GRN 8 10 Push To Call 7 9 8 PUR 7 WHT WHT Speaker 6 RED WHT GRN 5 4 Microphone 3 ORG 16 VAC OUTPUT 6 2 GRY 7 16 VAC OUTPUT 5 1 NEG 12 VDC INPUT 4 3 POS 12 VDC INPUT 3 16 VAC PWR 1838-120/121 2 4 6 INPUT LED Lights 1 Central Office phone line - touch tone, loop start. 13 1 A s
Resumo do conteúdo contido na página número 20
2.3.5 Controller and 1504-120 & 121 Remote Call Stations Aiphone LEM-1 Master 1 13 E 1 1 RS 232 Elevator 2 2 Connection Control 3 3 Aiphone 4 LEF 5 Master 6 1 13 E - 5 Card Reader RED RED + 12 VDC 14 14 BLK BLK COMMON 13 13 12 8 WHT WHT DATA 1 12 12 GRN GRN DATA 0 11 11 10 9 GRN 8 10 Push To Call WHT 7 9 8 + 47 uF Cap 14 PUR 7 WHT Speaker 6 5 4 3 ORG 16 VAC OUTPUT 6 2 7 GRY 16 VAC OUTPUT 5 1 NEG 12 VDC INPUT 4 3 POS 12 VDC INPUT 3 16 VAC PWR 1504-120/121 2 4 6 INPUT LED Lights 1 Central Office p
