Nosso objetivo é fornecer-lhe o mais rapidamente possível o acesso ao conteúdo contido no manual de instruções para LG Electronics GCC-4480B. Usando a pré-visualização online, você pode visualizar rapidamente o índice e ir para a página onde você vai encontrar a solução para seu problema com LG Electronics GCC-4480B.
Se a consulta dos manuais LG Electronics GCC-4480B diretamente no site não for conveniente para você, você tem duas soluções possíveis:
Muitas pessoas preferem ler os documentos não na tela, mas na versão impressa. A opção de imprimir o manual também foi fornecida, você pode usá-la clicando na hiperligação acima - Imprimir o manual. Você não precisa imprimir o manual inteiro LG Electronics GCC-4480B, apenas as páginas selecionadas. Respeite o papel.
Abaixo você encontrará previews do conteúdo contido nas páginas subseqüentes do manual para LG Electronics GCC-4480B. Se você deseja visualizar rapidamente o conteúdo das páginas subseqüentes, você pode usá-los.
English Deutsch Français Italiano Español
CAUTION : The laser used in the CD-RW/DVD-ROM drive can damage your eyes. Do not attempt to open the cover. To reduce the risk of electric shock, do not remove cover (or back). No user-serviceable parts inside. Refer servicing to qualified service personnel. Use of controls or performance of procedures other than those specified herein may result in hazardous radiation exposure. WARNING : To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture Industry Cana
This product is manufactured to comply with the radio interference requirements of EEC DIRECTIVE 89/336/EEC, 93/68/EEC and 73/23/EEC. CAUTION - INVISIBLE LASER RADIATION WHEN OPEN AVOID EXPOSURE TO BEAM. VARNING-OSYNLIG LASERSTRÄLNING NÄR DENNA DEL ÄR ÖPPNAD STRÄLEN ÄR FARLIG. CLASS 1 LASER PRODUCT KLASSE 1 LASER PRODUKT LUOKAN 1 LASER LAITE KLASS 1 LASER APPARAT This unit uses CD-ROM discs with the following mark When you use this unit as a CD player, use compact discs with the following mark T
TM DirectCD v2.5b(s) Contents Introduction Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Important Precautions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 System Environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Location and Function of Controls . . . . . . . . . . . . . . . . . . . 5 Installation Installing the Drive . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Device Drivers . . . . . . . .
TM DirectCD v2.5b(s) Introduction Thank you for Features purchasing this CD-RW/DVD- • Enhanced-IDE (ATAPI) interface. ROM Drive. • Power tray loading and ejection of disc. (The disc can also be ejected manually.) • Combination CD-R/RW and DVD-ROM Drive functions into one drive. • Supports UDF for easy writing to CD-RW discs. • Supports Region playback control Phase II. • Supports Windows 95, 98, 2000, ME & XP/NT4.0. • Supports Mt.Rainier. • Automatic buffer underrun error prevention technology-
TM DirectCD v2.5b(s) Introduction Important Precautions Follow these precautions when handling the drive or discs. • Please take notice that the manufacturer of this equipment does not Precautions offer any warranty against data loss due to inappropriate installation or handling, or direct or indirect damages. • Please take notice that the manufacturer will bear no responsibility for direct or indirect damages caused by the use of this product or its malfunction. • Please take notice that the
TM DirectCD v2.5b(s) Introduction System Environment Computer This unit can be operated in the system environment explained here. 350MHz (or faster) Pentium (for high speed, System CPU 500MHz or faster recommended) requirements Memory Windows 95/98 : 64MB or greater. Windows NT Workstation Ver. 4.0: 64MB or greater (128MB or over recommended) Windows 2000:64MB or greater(128MB or over recommended) 75MB or more free space. Hard disk (The free space needed for writing depends on the quantity of d
TM DirectCD v2.5b(s) Introduction Location and Function of Controls Front Panel 6 5 12 3 4 1.Headphone Jack 2.Volume Control 3.Emergency Eject Hole 4.Stop/Eject Button 5. Disc Tray 6.Drive activity indicator (Read/Write) Rear Panel 1 2 3 4 5 1. Digital Audio Output Connector 2. Analog Audio Output Connector 3. Jumper Connector This jumper determines whether the drive is configured as a master or slave. Changing the master-slave configuration takes effect after power-on reset. 4.
WRITE WRITE R RE EA AD D R RE EA AD D TM DirectCD v2.5b(s) Installation Installing the Drive Before Before installing the drive, please note the following points. You will need the following: Installation • A screw driver of a suitable size to fit the securing screws for the drive unit. • The manual for the computer, so you can find the mounting positions for the IDE controller cable. Turn off all peripheral appliances of the computer and the computer itself, and disconnect their power cord
TM DirectCD v2.5b(s) Installation Before installation, set the jumper connector on the rear panel. Jumper Setup The drive can be connected as the Master or Slave on an EIDE (ATAPI) interface. When several (up to four) EIDE devices are connected, each must be set in a unique way. Specific knowledge of hardware and software is necessary to install the drive. NOTE : If two peripheral devices with the same settings are both con- nected to the Primary or to the Secondary EIDE bus, the host computer
DA IG UID TIA O L AA NU AD LIO O G INTERFACE POWER D G R G L C S M 39 1 +5 GND +12 S L A 40 2 DIGITAL ANALOG INTERFACE POWER AUDIO AUDIO +5 GND +12 D G R G L CS S L M A 3 49 0 12 DIGITAL ANALOG AUDIO AUDIO INTERFACE POWER D G R G L C S M 39 1 +5 GND +12 S L A 40 2 TM DirectCD v2.5b(s) Installation The CD-RW/DVD-ROM drive connects to the motherboard of the host PC Connection computer using an IDE interface cable.You may connect the CD-RW/DVD- ROM Drive as a Slave or Master device, depending on
DI GI TAL ANALOG AUDI O AUDI O INTERFACE POWER DG3 R G L CS M 9 1 +5 GND +12 S L A 40 2 DIGITAL ANALOG AUDIO AUDIO INTERFACE +POW 5 G ER +12 D G R G L C S SL M A 3 49 0 12 ND DIGIT L AN LOG AUDIA O AU ADIO INTERFACE POWER D G R G L C S M 39 1 +5 GND +12 S L A 40 2 TM DirectCD v2.5b(s) Installation To install the drive as a Slave, change the jumper setting on the rear To Install as a panel to SL. Slave Drive Master drive (Booting hard disk) Slave drive (CD-RW/DVD-ROM drive) (Jumper set to SLave)
TM DirectCD v2.5b(s) Installation Connect the 40-pin IDE cable to the back of the CD-RW/DVD-ROM Connecting Drive, making sure the coloured (red) stripe on the IDE cable is the Interface connected to pin 1 on the CD-RW/DVD-ROM drive. Pin 1 is closest to Connector the Power Connector. NOTE : Generally, the IDE connector is keyed and will only fit one way. Pin1 Red-edge Connecting If the computer is using a sound card, the drive is connected to the sound card with an audio cable. The supplied anal
TM DirectCD v2.5b(s) Installation Device Drivers When using Windows 95/98/2000/Me/XP or Window NT Workstation Ver.4.0, no special device driver is required. Your system, upon Power On and bootup after installing and connecting the new CD-RW/DVD-ROM drive, will recognize and load native software drivers automatically. The DOS and Windows 3.1 users can download the DOS Device drivers anytime via internet. For your information, please consult the following internet sites: http://www.lge.com http:/
TM DirectCD v2.5b(s) Operation How to Use the Discs When using CD-ROM discs, CD-R discs, DVD discs or CD-RW discs, don’t attach any stickers or labels to the discs. Using discs with them attached not only causes read and write errors, but data on the disc may be lost due to damage to the disc itself. The Discs in this unit operate at a very high speed! DO NOT use damaged, cracked or warped discs. The drive’s optical unit may be damaged if they break. DO NOT use non-standard discs. NON-standard
TM DirectCD v2.5b(s) Appendix Troubleshooting Before calling for service, check this list. Before • The drive doesn’t have power. Requesting • Is the power supply cable from the host computer plugged in? Service • Is the Power Connector to the drive securely attached? • The system doesn’t start. • Are the Primary and Secondary connections and the Master and Slave settings correct? • Is the total length of the IDE cable 18 inches or less? • Is each connector completely attached? Movement of the
Specifications Items CD/DVD/CD-RW General Supported Discs *Read Function CD-ROM, CD-ROM XA, Audio CD, Mixed Mode (Audio and Data Combined), CD-I FMV, Video CD, Photo CD (Single and Multi -Session), CD-Plus/CD-Extra, CD-Text DVD-Single/Dual, DVD-R/RW, DVD+R/RW *Write Function CD-ROM, CD-ROM XA, Audio CD, CD-I FMV, Video CD, CD-Plus/CD-Extra Disc Diameter 12cm/ 8cm, standard size CD's Host Interface E-IDE/ATAPI Read/Write Speed Write (CD-R) : 4X, 8X, 16X, 24X, 32X, 40X, 48X Write (CD-RW) : 4X, 10
© Copyright 2002 Caution! LG Electronics U.S.A. Inc. The disc rotates at high speed in the drive unit. 1000 Sylvan Ave. Use of worn, damaged, or non-standard CD-ROM discs Englewood Cliffs NJ 07632 can only adversely affect the drive and cause the disc to U. S. A. shatter or crush while in use. or http://www.lgeus.com Disc crush can only occur when you use a damaged CD-ROM disc in the drive. It is an extremely rare LG Electronics Canada Inc. occurrence, but there are steps which can be taken
|#||Manual do usuário||Categoria||Baixar|
|1||LG Electronics GSA-H54LI||Computer Drive||20|
|2||LG Electronics THE POWER WITHIN 430447||Computer Drive||26|
|3||LG Electronics GGW-H20N||Computer Drive||17|
|4||LG Electronics SUPER MULTI GCC-H21N||Computer Drive||21|
|5||LG Electronics GMA-4020B||Computer Drive||20|