Manual do usuário Dialogic DIALOG/4

Resumo do conteúdo contido na página número 1

JP 5
JP 6
®
®
IRQ 7
IRQ 6
IRQ 5
IRQ 4
I
RQ 3
2 9
IRQ /
SW 1:4
SW 1:3
1:2
SW
SW 1:1
JP 5
JP 6
Grounded Static-Dissipative
Set the Offset Address (SW1:1, 2, 3)
DIALOG/4 Physical Description
Wrist Strap
The default offset address for the DIALOG/4 board is
Part Function
JP101
0000H. If you need to change an offset address, set the
Ground
™ RJ-14 jack for interface with PBX or
J1–J2
DIALOG/4
switches 1, 2, and 3 on SW1 as follows:
SW1
CO lines
JP1 Jumper block to set interrupt level Offset SW1:1, 2,

Resumo do conteúdo contido na página número 2

4. Insert the board’s edge connector into the bus slot. Setting the Initial Hook Switch State (SW1:4) 5HJXODWRU\1RWLFHV 50$3URFHVV 5. Replace and tighten the retaining screw. SW1 switch 4 (SW 1:4 in Figure 2) sets the initial hook switch state for the DIALOG/4 board. This setting is United States Canadian Department of Communications Select a new slot and repeat steps 3–5 for each board If you suspect you have a problem board, you can return active only when the PC is powered on but the firmwa