Resumo do conteúdo contido na página número 1
AOC LM520
AOC LM520
15 inch TFT LCD Monitor
User’s
Manual
by Envision Peripherals, Inc.
www.aocmonitor.com
Before operating your monitor, please read this
manual thoroughly.
AOC LM520
1
v3_123102
Resumo do conteúdo contido na página número 2
For Your Safety AOC LM520 FCC Statement Notice This equipment has been tested and found to 1. The changes or modifications not expressly comply with the limits for a Class B digital device, approved by the party responsible for pursuant to Part 15 of the FCC Rules. These limits compliance could void the user's authority to are designed to provide reasonable protection operate the equipment. against harmful interference in a residential 2. Shielded interface cables and AC power cord, if inst
Resumo do conteúdo contido na página número 3
For Your Safety AOC LM520 adapter to ground the appliance safely. Do not Precautions defeat the safety purpose of the grounded plug. • Do not use the monitor near water, e.g. near a • Unplug the unit during a lightning storm or when bathtub, washbowl, kitchen sink, laundry tub, it will not be used for long periods of time. swimming pool or in a wet basement. This will protect the monitor from damage due to • Do not place the monitor on an unstable cart, power surges. stand, or table. I
Resumo do conteúdo contido na página número 4
For Your Safety AOC LM520 Special Notes on LCD Monitors General Notes The following symptoms are normal with an LCD • Do not install the monitor near heat sources monitor and do not indicate a problem: such as radiators or air ducts. • Due to the nature of the fluorescent light, the • Do not place monitor in direct sunlight or in screen may flicker during initial use. Turn off the areas with excessive dust, mechanical vibration Power Switch and then turn it on again to make or shock. sure
Resumo do conteúdo contido na página número 5
Before You Operate the Monitor AOC LM520 Installing & Removing the Base General Features: Package Contents • 38.1cm(15") TFT Color LCD Monitor The box that your monitor was shipped in should have included the following items: • Crisp, Clear Display for Windows 1. LM520 LCD Monitor • Supports Resolutions up to 1024 X 768 pixels 2. Power Cord @75Hz, (1024 x 768 @ 60Hz Recommended) 3. Windows 95/98/2000/ME/XP INF Driver Disk ® • EPA ENERGY STAR 4. Quick Start Guide • Ergonomic Design 5. Booklet (
Resumo do conteúdo contido na página número 6
Before You Operate the Monitor AOC LM520 Connecting the Wires Using the Power Cord Supplied 1. Connect the built-in video cable into the 15-pin Caution: Make sure the power cord is the correct connector on the back of your computer and type that is required in your area. This LCD tighten the two screws. monitor has a universal Power Adapter that allows operation in either 100/120V AC or 220/ 2. Connect the power cord into your LCD monitor's 240V AC voltage areas (no user adjustment is Power
Resumo do conteúdo contido na página número 7
Before You Operate the Monitor AOC LM520 Adjusting the Viewing Angle For optimal viewing, adjust the monitor's angle to • Do not touch the LCD screen when you your own preference. change the angle. It may cause damage or breakage. • Hold the stand firmly when you change the monitor's angle. • Be careful to avoid pinching your hand in the swivel base. • You can adjust the monitor's angle from -5° to 25°. AOC LM520 v3_123102 7
Resumo do conteúdo contido na página número 8
Before You Operate the Monitor AOC LM520 Preparing To Install An Optional Wall Mounting Arm (Not Supplied) This monitor can be attached to a wall mounting arm you can purchase separately. Disconnect power before performing this procedure. Follow these step. 1. Pull the screw covers off the back of the monitor. 2. Support the base and remove the screws. 3. Remove the base. 4. Follow the manufacturer’s instructions to assemble the wall mounting arm. See next page for further installation in
Resumo do conteúdo contido na página número 9
Before You Operate the Monitor AOC LM520 Install An Optional Wall Mounting Arm (Not Supplied) Follow these steps to finish installing the wall mounting arm: 1. Place the wall mounting arm onto the back of the monitor. Line up the holes of the arm with the holes in the back of the monitor. 2. Insert the 4 screws into the holes and tighten. 3. Insert the power cable into the slot on the back of the monitor. NOTE: AOC’s LM520 is compatible with the Ergotron line of mounting and arm solutions.
Resumo do conteúdo contido na página número 10
Operating Instructions AOC LM520 Front Panel Buttons Auto: Press this button to automatically set Power Button: Press this button to put the the H-Position, V-Position, Clock and Focus monitor into Off mode. The power indicator settings. light will turn orange. Press and hold this button again to restore the monitor to Shuttle Knob: Press this knob to open the normal operating mode. OSD window or select a highlighted function. Rotate this knob to switch functions or adjust On-screen Displa
Resumo do conteúdo contido na página número 11
Operating Instructions AOC LM520 Adjusting the OSD Settings 1. Press the Shuttle Knob button to open the 5. To save and exit, highlight the EXIT icon and OSD window. press Shuttle Knob or leave the monitor alone for 10 seconds. If you want to adjust any 2. Rotate the Shuttle Knob until the desired other function, repeat steps 2-4. function is highlighted. Note: When the OSD window is open, the input 3. Press the Shuttle Knob again to open the signal timing settings appear at the top. func
Resumo do conteúdo contido na página número 12
Operating Instructions AOC LM520 Plug & Play DDC1/2B Feature How to Install INF & ICM File This monitor is equipped with VESA DDC1/2B 1. Insert the Windows 95/98/2000/ME/XP INF capabilities according to the VESA DDC Driver Disk into your floppy drive. STANDARD. It allows the monitor to inform the 2. Follow the Add New Hardware Wizard host system of its identity and, depending on the instructions on the screen. level of DDC used, communicate additional 3. If the wizard asks for the location
Resumo do conteúdo contido na página número 13
Technical Support (FAQ) AOC LM520 Problem Possible Solution Power LED is not ON • Make sure the power cord is properly connected to a grounded power outlet and to the monitor. No Plug & Play • Confirm that your computer is Plug & Play compatible. • Confirm that your video card is Plug & Play compatible. • Inspect the video cable and make sure that none of the pins are bent. • Make sure the AOC monitor drivers are installed. (AOC monitor drivers are available at: www.aocmonitor.com) Picture is
Resumo do conteúdo contido na página número 14
Technical Support (FAQ) AOC LM520 Problem Possible Solution 1 2 Screen image is not • Adjust the CLOCK and FOCUS settings or press the AUTO button to centered or sized automatically re-configure the monitor’s settings. properly Picture has color • Adjust the settings for Red, Green and/or Blue colors or select a different defects (white does color temperature: C1 or C2. not look white) Poor brightness or • The life time of the back-light is limited. After 30,000 hours, the luminance of cont
Resumo do conteúdo contido na página número 15
Technical Support (FAQ) AOC LM520 Error Message Possible Solution Input not supported • Your computer has been set to an incompatible display mode. Right click on the desktop and choose Properties. Click the Settings tab then set your computer’s display mode to one of the settings listed in the resolution chart below. Unsupported mode • Your computer’s resolution is out of VESA specifications. try different video Right click on the desktop and choose Properties. Click the Settings tab then c
Resumo do conteúdo contido na página número 16
Appendix AOC LM520 Specifications Plug & Play VESA DDC1/ 2BTM LCD Driving TFT Color LCD Panel system Input Connector D-Sub 15-pin Size 15.0" (38.1 cm) Diagonal Input Video Signal Analog: 0.7 Vpp 75 OHM, Positive Pixel pitch (0.30 mm) (H) x Maximum Screen Size Horizontal: (0.30 mm) (V) 12.0" (304.1 mm) Vertical: Viewable 120° (H) 100° (V) 9.0" (228.1 mm) angle Input Response 30 milliseconds time Power Source 100~264 VAC, 47~63 Hz Video Red, Green, Blue Analog Interface Environmental Operatin
Resumo do conteúdo contido na página número 17
Appendix AOC LM520 Optimal Viewing Mode: 1024 x 768 @ 60Hz Specifications (continued) Front Panel Buttons Auto Shuttle Knob Power Power Indicator External Functions Contrast Controls: Brightness Focus Clock H-Position V-Position Language C1 C2 RGB Color temp. Reset Exit EPA ENERGY Yes STAR® Power Consumption 25 Watts (Maximum) Regulatory TCO99, UL, CSA, Compliance FCC, TÜV/GS, CE, Windows® XP Logo AOC LM520 17 v3_123102
Resumo do conteúdo contido na página número 18
Appendix AOC LM520 Factory Preset Timing Table Resolution Horizontal Vertical Standard (in pixels) Frequency Frequency VGA 720 × 400 31.47 kHz 70 Hz 640 × 480 31.47 kHz 60 Hz 640 × 480 35.00 kHz 66.6 Hz 640 × 480 37.50 kHz 75 Hz SVGA 800 × 600 37.879 kHz 60 Hz 800 × 600 46.875 kHz 75 Hz 832 × 624 49.725 kHz 75 Hz XGA 1024 × 768 48.363 kHz 60 Hz 1024 × 768 56.476 kHz 70 Hz 1024 × 768 60.02 kHz 75 Hz 1024 × 768 60.241 kHz 74.9 Hz AOC LM520 18 v3_123102
Resumo do conteúdo contido na página número 19
Appendix AOC LM520 Connector Pin Assignment Pin Number Description Pin Number Description 1 Red 9 +5V 2 Green 10 Detect Cable 3Blue 11 NC 4 Ground 12 DDC-Serial Data 5 Ground 13 H-Sync 6 R-Ground 14 V-Sync 7 G-Ground 15 DDC-Serial Clock 8 B-Ground AOC LM520 19 v3_123102
