Краткое содержание страницы № 1 
                    
                        LT-Z32/26SX4B/S / LCT1732-002A / All Cover
LT-Z32&26SX4BS_Eng.book  Page 1  Monday, September 6, 2004  10:30 AM
ENGLISH
LT-Z32SX4B
LT-Z26SX4B
LT-Z32SX4S
LT-Z26SX4S
INSTRUCTIONS
WIDE LCD PANEL TV
LCT1732-002A
Cover01                                                                                                                                                                                                                                                                                             
                    
                    Краткое содержание страницы № 2 
                    
                        ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book  Page 1  Monday, September 6, 2004  10:30 AM Thank you for buying this JVC LCD flat television. To make sure you understand how to use your new TV, please read this manual thoroughly before you  begin. (“LCD” stands for Liquid Crystal Display.) WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS  APPLIANCE TO RAIN OR MOISTURE. WARNING • Fingers may be trapped under the TV causing injuries.  Hold the TV at the botto
                    
                    Краткое содержание страницы № 3 
                    
                        ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book  Page 2  Monday, September 6, 2004  10:30 AM Pixel defects LCDs use collections of fine points (“pixels”) to display images. While there is no problem with  more than 99.99% of these pixels, please understand that a very small number of pixels may not  light, or may light all the time. Distance recommendations Avoid improper installation and never position the unit  where good ventilation is impossible. 200 mm 200 mm 150 mm
                    
                    Краткое содержание страницы № 4 
                    
                        ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book  Page 3  Monday, September 6, 2004  10:30 AM  Cleaning the screen The screen is coated with a special thin film to reduce reflection. If this film is damaged, uneven  colours, discolouration, scratches, and other problems that cannot be repaired may occur. Pay  attention to the following when handling the screen. • Do not use glue or adhesive tape on the screen. • Do not write on the screen. • Do not allow the screen to com
                    
                    Краткое содержание страницы № 5 
                    
                        ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book  Page 4  Monday, September 6, 2004  10:30 AM CONTENTS Setting up your TV ...................................5 PICTURE menu ...................................... 25 Installation.................................................. 5 PICTURE MODE...................................... 25 Using the stand.......................................... 5 BACK LIGHT............................................ 25 Removing the terminal cov
                    
                    Краткое содержание страницы № 6 
                    
                        ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book  Page 5  Monday, September 6, 2004  10:30 AM Setting up your TV • When you install the TV on the wall, only use a JVC wall mounting unit (optional) which is  designed for this TV. • Make sure that the TV is installed on the wall by a skilled installer. Installation Cautions for installation • Install the TV in a corner on a wall or on the floor so as to keep cords out of the way. • The TV will generate a slight amount of he
                    
                    Краткое содержание страницы № 7 
                    
                        ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book  Page 6  Monday, September 6, 2004  10:30 AM Setting up your TV  Cable holder A cable holder which is used to keep the  connection cables tidy is attached to the back  of the stand. Gently squeeze the left and right  of the cable holder and pull it to remove it from  the stand. After putting the cables in the cable  holder, attach it to the back of the stand again. cable holder Removing the terminal covers There are connect
                    
                    Краткое содержание страницы № 8 
                    
                        ENGLISH IN LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book  Page 7  Monday, September 6, 2004  10:30 AM Setting up your TV Connecting the aerial and  video cassette recorder (VCR) without terminal covers Caution • Turn off all the equipment including the  TV before connecting anything. • Aerial cable is not supplied. Use a good  quality 75-ohm coaxial cable. • Read the manual that came with the VCR  IN before connecting. If not connecting a VCR (follow 1): Connect an aerial cabl
                    
                    Краткое содержание страницы № 9 
                    
                        ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book  Page 8  Monday, September 6, 2004  10:30 AM Setting up your TV Connecting the power cord to Initial settings (Setup tour) the AC outlet When the TV is first turned on, it goes into  the initial settings mode, and you will see the  Insert the AC plug on the power cord from  JVC logo. Follow the instructions on the  the TV into AC outlet. screen display to make the initial settings. Caution • Operate only from the power sour
                    
                    Краткое содержание страницы № 10 
                    
                        ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book  Page 9  Monday, September 6, 2004  10:30 AM Setting up your TV • If the JVC logo does not appear this is  5 Press the 6 buttons to choose a  because your TV has already been  group. Then press the a button turned on for the first time:  The AUTO PROGRAM function starts.  use the “LANGUAGE”, “TELETEXT  The TV channels you receive are  LANGUAGE” and “AUTO  automatically stored in the programme  PROGRAM” functions to make the
                    
                    Краткое содержание страницы № 11 
                    
                        ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book  Page 10  Monday, September 6, 2004  10:30 AM TV buttons and functions Turn the TV on from standby  1 mode Press the A button or the CHANNEL  p buttons to turn the TV on from  standby mode. When the TV is turned on, the power lamp  lights blue. To turn the TV off: Press the A button again. The power lamp goes off. 2 Caution •The A button on the TV does not fully  isolate the TV from the AC supply. If  you are not going to u
                    
                    Краткое содержание страницы № 12 
                    
                        ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book  Page 11  Monday, September 6, 2004  10:30 AM Remote control buttons and functions 1 Muting button 2 Number buttons 31 button 4c button 1 ~ 52 button 64 button ! 77 buttons 85 button 2 96 p buttons 0 VCR/DVD/Teletext control buttons -p buttons =d (Favourite) button ~# (Standby) button 3 @ ! PIP/TV/DVD switch # @g (Text) button 4 # Colour buttons 5 $H button %a button $ 6 ^b button % &7 q buttons *f (Freeze) button 7 (X (Mul
                    
                    Краткое содержание страницы № 13 
                    
                        ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book  Page 12  Monday, September 6, 2004  10:30 AM Remote control buttons and functions • Since this TV is designed to make full use  Choose a TV channel and  of the resolution of the original video  watch images from external source, the motion may appear unnatural  when the video source is input with  devices progressive-scanning component signals. • If this happens, change the output setting   Use the number buttons: of the c
                    
                    Краткое содержание страницы № 14 
                    
                        ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book  Page 13  Monday, September 6, 2004  10:30 AM Remote control buttons and functions PR LIST: Adjust the volume The programme number (PR) and VIDEO  terminal list is displayed. Press the 7 q buttons to  Pressing the a button after choosing the  adjust the volume. programme number (PR) or VIDEO terminal  The volume level indicator appears and the  with the 7 buttons will display the  volume changes as you press the 7  chosen p
                    
                    Краткое содержание страницы № 15 
                    
                        ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book  Page 14  Monday, September 6, 2004  10:30 AM Remote control buttons and functions 16:9 ZOOM: ZOOM function This zooms up the wide picture (16:9 aspect  ratio) to the full screen.  You can change the screen size according to  the picture aspect ratio. Choose the optimum  one from the following ZOOM modes. • The ZOOM mode is fixed at FULL when  16:9 ZOOM SUBTITLE: you are using the TV as a PC screen. This zooms up the wide p
                    
                    Краткое содержание страницы № 16 
                    
                        ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book  Page 15  Monday, September 6, 2004  10:30 AM Remote control buttons and functions  Adjusting the visible area of the • When you set the CINEMA SURROUND  function to HIGH mode, there may be  picture slight volume distortion. If that occurs,  If subtitles or the top (or bottom) of the  please switch to LOW mode. The effect  picture are cut off, you can adjust the visible  of CINEMA SURROUND functions will  area of the pictur
                    
                    Краткое содержание страницы № 17 
                    
                        ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book  Page 16  Monday, September 6, 2004  10:30 AM Remote control buttons and functions To cancel the “Freeze” function: 12-pictures multi: Press the f button, the 6  p buttons or the number buttons. Still  pictures • The “Freeze” function does not work  while a sub-picture is displayed. Moving  picture • The still picture cannot be output from  D0058 the TV. • When set to 2-pictures multi, you can  • The “Freeze” function does 
                    
                    Краткое содержание страницы № 18 
                    
                        ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book  Page 17  Monday, September 6, 2004  10:30 AM Remote control buttons and functions • The BLUE BACK function does not • If you want to view the “Return Channel”  work when the “Multi-picture” and another TV channel alternately, first  function is being used. choose a channel other than the “Return  Channel”. And then press the  • The ZOOM function does not work  1 button to change the  when the “Multi-picture” function is  c
                    
                    Краткое содержание страницы № 19 
                    
                        ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book  Page 18  Monday, September 6, 2004  10:30 AM Remote control buttons and functions  Calling the favourite channel Favourite channel function 1 In the normal screen, press the d  You can register your favourite TV channels  (favourite) button (PR 1 – PR 99) in the number buttons 1 to 4. Then “FAVOURITE1-4?” appears. After registering, the channel can be called  by pressing the d (favourite) button and a  2 Press one of the n
                    
                    Краткое содержание страницы № 20 
                    
                        ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book  Page 19  Monday, September 6, 2004  10:30 AM Remote control buttons and functions Operating a JVC brand DVD  player These buttons will operate a JVC brand DVD  player. Pressing a button that looks the same  as the device’s original remote control button  has the same effect as the original remote  control. 1 Set the PIP/TV/DVD switch to the  DVD position When you are operating the DVD player,  set the switch to the DVD pos