Краткое содержание страницы № 1
OWNER’S MANUAL
Model SC-10030A
For 6 and 12-Volt Batteries
TM
®
ELECTRONIC
BATTERY CHARGER
amp amp
S L O W F A S T
12 30 CHARGE
2 CHARGE
amp
ENGINE
100
START
Fully Automatic
Microprocessor Controlled
Battery Charger with
Engine Starter plus
Battery Tester and
Alternator Tester
00-99-000828/0408
Краткое содержание страницы № 2
Краткое содержание страницы № 3
IMPORTANT: READ AND SAVE THIS SAFETY AND INSTRUCTION MANUAL. 1. IMPORTANT SAFETY INSTRUCTIONS 1.1 SAVE THESE INSTRUCTIONS – This manual contains important safety and operating instructions for battery charger Model SC-10030A. 1.2 Do not expose charger to rain or snow. 1.3 Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire, electric shock, or injury to per- sons. 1.4 To reduce risk of damage to electric plug and cord, pull by plug rathe
Краткое содержание страницы № 4
2. PERSONAL PRECAUTIONS 2.1 Consider having someone close enough by to come to your aid when you work near a lead-acid battery. 2.2 Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing, or eyes. 2.3 Wear complete eye protection and clothing protection. Avoid touching eyes while working near battery. 2.4 If battery acid contacts skin or clothing, wash immediately with soap and water. If acid enters eye, immediately flood eye with running cold water for at l
Краткое содержание страницы № 5
4. CHARGER LOCATION 4.1 Locate charger as far away from battery as DC cables permit. 4.2 Never place charger directly above battery being charged; gases from bat- tery will corrode and damage charger. 4.3 Never allow battery acid to drip on charger when reading electrolyte spe- cific gravity or filling battery. 4.4 Do not operate charger in a closed-in area or restrict ventilation in any way. 4.5 Do not set a battery on top of charger. 5. DC CONNECTION PRECAUTIONS 5.1 Connect and disconnect DC
Краткое содержание страницы № 6
6.7 When disconnecting charger, turn switches to off, disconnect AC cord, remove clip from vehicle chassis, and then remove clip from battery termi- nal. 6.8 See OPERATING INSTRUCTIONS for length of charge information. 7. FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE VEHICLE. A SPARK NEAR THE BATTERY MAY CAUSE BATTERY EXPLOSION. TO REDUCE RISK OF A SPARK NEAR BATTERY: 7.1 Check polarity of battery posts. POSITIVE (POS, P, +) battery post usually has a larger diameter than NEGATIVE (NEG, N, –) p
Краткое содержание страницы № 7
9. RECOMMENDED MINIMUM AWG SIz E FOR EXTENSION CORDS FOR BATTERY CHARGERS 9.1 AC input rating, AWG size of cord a Length of cord, feet (m) amperes But less 25 50 100 150 At least than (7.6) (15.2) (30.5) (45.6) 0 2 18 18 18 16 2 3 18 18 16 14 3 4 18 18 16 14 4 5 18 18 14 12 5 6 18 16 14 12 6 8 18 16 12 10 8 10 18 14 12 10 10 12 16 14 10 8 12 14 16 12 10 8 14 16 16 12 10 8 16 18 14 12 8 8 18 20 14 12 8 6 a If the input rating of a charger is given in watts rather than in amperes, the correspon
Краткое содержание страницы № 8
10. ASSEMBLY INSTRUCTIONS 10.1 Included with your battery charger are two cord wrap cleats for storage of the clamp cables. 10.2 To install, align the two tabs to correspond with the two receptacles and push until you hear a snap. 10.3 Wrap clamp cables after unplugging the power cord from the AC wall outlet and store your charger in a dry location. 11. USING ENGINE START Your battery charger can be used to jump start your vehicle if the battery is low. Follow these instructions on how to us
Краткое содержание страницы № 9
changed. The buttons are ignored. The digital display indicates the remaining cool down time in seconds. It starts at 180 and counts down to 0. The ENGINE START LED blinks once every second. During the cool down period, no current is delivered to the battery. After 3 minutes, the ENGINE START LED will stop blinking and will light continuously, indicating that another crank cycle can be started. The digital display will change from displaying the countdown back to displaying the battery vo
Краткое содержание страницы № 10
could take up to 10 hours. If desulfation fails, charging will be aborted and the digital display will blink. 12.5 COMPLETION OF CHARGING: • 12V or 6V Standard Battery: Charge completion is indicated by the CHARGED (green) LED; when lit, the charger has stopped charging and switched to the Maintain Mode of operation. • 12V AGM OR GEL CELL BATTERY: The CHARGED LED comes on when the battery is charged enough for normal use. After charging is complete, the CHARGED LED will be on and the volt
Краткое содержание страницы № 11
13.1 DIGITAL DISPLAY BUTTON Use this button to set the function of the digital display to one of the follow- ing: • BATTERY %: The digital display shows an estimate of the percent of charge of the battery connected to the charger battery clamps. • VOLTAGE: The digital display shows the voltage at the charger battery clamps in DC volts. • ALTERNATOR %: The digital display shows an estimated percentage of the output of the vehicle charging system connected to the charger bat- tery clamps as co
Краткое содержание страницы № 12
14. CONTROL PANEL GUIDE • 10 • SC-10030A CONTROL PANEL GUIDE MODE OF OPERATION Digital Display Initial power-up, battery not detected O O 0.0 No battery or reversed battery detected User selected User selected User selected 0(%) or 0.0(V) User selected Battery tester activated O 0~100 Battery tester with charged battery O O O User selected 100 Battery tester with no battery O User selected 0 User selected Voltage meter activated O 0.0~17.0 Alternato
Краткое содержание страницы № 13
15. USING THE BUILT-IN BATTERY TESTER OVERVIEW: This battery charger has a built-in battery tester that displays either an accurate battery voltage or an estimate of the battery’s relative charge based on the battery voltage and the Battery Council International scale. 15.1 TESTING SEqUENCE 1. There are four basic steps required to use the SC-10030A as a battery tester: 2. Connect the battery clamps (see sections 6 and 7). 3. Connect the charger power cord to a 120V AC wall outlet. 4. If n
Краткое содержание страницы № 14
• The CHARGING LED does not light in the battery test mode. • The CONNECTED LED lights when a properly connected battery is de- tected. • When the tester digital display is set to VOLTAGE, the CHARGED and CHARGING LEDs won’t light (it could be testing a battery or an alterna- tor). 15.7 INITIAL PERCENT CALCULATION When a battery % is calculated for the first time after connecting a battery, the digital display will show three dashes (“---”) for a period as long as several seconds while the t
Краткое содержание страницы № 15
• The CHARGED (green) LED will light if the output of the charging system is at the normally desired level. • The CHARGING LED does not light in the alternator test mode. • The CONNECTED LED lights if the tester detects a connection. • When the tester digital display is set to VOLTAGE, the CHARGED and CHARGING LEDs won’t light (it could be testing a battery or an alterna- tor). 16.3 ALTERNATOR TESTING NOTES • The alternator percent display can range from 0 to 199. • The DIGITAL DISPLAY cannot
Краткое содержание страницы № 16
There are some important facts to keep in mind when charging a battery. • When the display indicates 77% charged, the battery has been charged enough to start most vehicles and has already been charged as much as by many other battery chargers. • When the display indicates 85% charged, the battery has already been charged at least as much as by most other battery chargers. • The battery % shown in tester mode is an estimate based on the bat- tery voltage and the Battery Council International
Краткое содержание страницы № 17
18.3 Completing an interrupted charge: If the charging process has been interrupted and restarted after the charger displays a battery % of 85 or more, the charger could go straight to Maintain Mode. However, if the original charge was started using the MEDIUM TO LARGE BATTERY rate, the charge can often be completed using the SMALL BATTERY setting. 19. MAINTENANCE INSTRUCTIONS The charger is designed and built with high quality materials requiring only a minimum amount of care. 19.1 After u
Краткое содержание страницы № 18
20. TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION The battery is connected The charger is in tester Press the BATTERY and the charger is on, mode, not charger SIZE button to activate but isn’t charging. mode. charging and select a charge rate. Indicator lights are lit in You might have acciden- Make sure nothing is an erratic manner not tally activated a special touching the control explained in this manual. diagnostic mode. panel, then unplug the charger and plug it in again. The DIGIT
Краткое содержание страницы № 19
21. LIMITED WARRANTY SCHUMACHER ELECTRIC CORPORATION, 801 BUSINESS CENTER DRIVE, MOUNT PROSPECT, ILLINOIS 60056-2179 MAKES THIS LIMITED WARRANTY TO THE ORIGINAL PURCHASER AT RETAIL OF THIS PRODUCT. THIS LIMITED WARRANTY IS NOT TRANSFERABLE. Schumacher Electric Corporation warrants this battery charger for five years from date of purchase at retail against defective material or work- manship. If such should occur, the unit will be repaired or replaced at the option of the manufacturer. It i
Краткое содержание страницы № 20
• 18 •
