ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
Warning! The Clarion OHM102/OHM153 overhead monitor systems are designed for strictly for rear seat entertainment. Viewing the monitor while operating a motor vehicle can result in serious injury and/or property damage. Clarion is not responsible for any injury and/or property damage as a result of the improper use or viewing of the monitor. Welcome! Thank you for purchasing the Clarion OHM102/OHM153 overhead monitor system. These monitors are engineered with advanced technological desi
ページ3に含まれる内容の要旨
Introduction The Clarion OHM102/OHM153 are exclusively designed for the ultimate in rear seat mobile video entertainment. With the built-in A/V switcher, any Clarion video source or game station can be enjoyed on these monitors. The built-in A/V switcher also incorporates PIP (picture in picture) and split screen operation. For added convenience, the front panel controls allows for menu, picture, source, and FM modulator selections. FCC Approval The OHM102/OHM153 has been tested and found
ページ4に含まれる内容の要旨
Table of contents Opening the Overhead Monitor . . . . . . . . . 4 Precautions . . . . . . . . . . . . . . . . . . . . . . . . 5 Care And Maintenance . . . . . . . . . . . . . . . 5 Operating OHM102/153 Monitor . . . . . . . . 6-9 Operating the Remote Control . . . . . . . . . .10-11 Operating the Headphones . . . . . . . . . . . . 12 Installation Instructions . . . . . . . . . . . . . . . 13-15 Complete System Diagram . . . . . . . . . . . . 16-17 Package Contents . .
ページ5に含まれる内容の要旨
Opening t Opening the Ov he Overhead M erhead Monit onito or r Press the “O Press the “OPEN” button t PEN” button to o rele release the overh ase the overhead mo ead monitor. Gently push do nitor. Gently push down o wn on n the bottom of the the bottom of the monitor u monitor un ntil it reache til it reaches the desi s the desir re ed d po position. The m sition. The monit onito or will turn on r will turn on automatically when it is full automatically when it is fully y open. open.
ページ6に含まれる内容の要旨
Precautions • These overhead monitor systems are designed for use in 12V DC negative ground vehicles. • Do not operate the overhead monitor system in ways other than described in this manual. Doing so may result in damage to the monitor system and/or vehicle, along with voiding the warranty. • SAFETYFIRST! These overhead monitor systems are designed for rear seat entertainment only. Do not install in/on dashboard or anywhere else that would allow the operator of the vehicle to view the mo
ページ7に含まれる内容の要旨
OPERATING OHM102/OHM153 MONITOR In the event a problem arises with the OHM102/OHM153 overhead monitor system, do not attempt to disassemble or repair the monitor yourself. Opening or attempting to service the monitor will void the warranty; instead contact a local Clarion dealer for assistance. Monitor Control Panel 1. PIP (Picture In Picture) button Press the PIP button to enable Picture In Picture or split screen operation. 2. MENU button Press the MENU button to access the monito
ページ8に含まれる内容の要旨
Closing the Overhead Monitor Gently push the backside of the monitor until it clicks into the overhead monitor housing. The monitor will turn off automatically when it is returned to the closed position. Note: Do not place any objects between the monitor and the monitor housing, this can result in serious damage to the monitor. Adjusting the Tilt and Swivel (OHM102 only) The monitor can be opened to a maximum of 110 degrees. Exceeding this point can cause serious damage to the monito
ページ9に含まれる内容の要旨
Note: The screen mode will set after 5 seconds, pending that the MODE button is not pressed. The display image may appear coarse or grainy when viewed in Zoom mode. Changing the Display Settings (Picture In Picture/Split Screen) The display setting can be adjusted by pressing the PIP (Picture In Picture) button on the control panel or remote control. This button selects between PIP and split screen viewing mode. In PIP mode, the second image can be displayed in any of the four corn
ページ10に含まれる内容の要旨
Selecting the AV Sources for Main and Sub Screen MAIN SCREEN Press the (DOWN Button) to select the desired AV source. The sources will be changed in following sequence: SUB SCREEN Press the (UP button) to select the desired AV source. The sources will be changed in following sequence: NOTE: Same video input cannot be viewed simultaneously. Dimmer Button: Press the DIMMER button to adjust the brightness of the screen. The brightness will change in the follo
ページ11に含まれる内容の要旨
OPERATING THE REMOTE CONTROL 1. Power button Press the Power button to turn ON/OFF the monitor. 2. FM button Press to turn ON/OFF the FM modulator (FM200 not included) 3. DIMMER button Press to adjust the brightness of the screen. 4. MENU button Press the MENU button to access the monitor adjustments. FM MOD ON/OFF>Brightness>Contrast>Saturation>Hue>Sub Size>Sub Position> Default Reset (Down button) MENU, then DOWN selects item to be adjusted. DOWN: Selects Main AV source. (
ページ12に含まれる内容の要旨
SUB POS button Press to select the location of the PIP (Picture In Picture) image. SIZE button Press to select the size of the PIP (Picture In Picture) image. INPUT button Press to select AV source for Sub Screen. Mode button Press to change the screen format: Normal, Full, Zoom, and Wide. Battery Installation 1. Slide the battery-retaining clip in, while sliding the battery tray out. 2. Insert the CR2025 lithium battery into the tray with the “+” facing upwards. 3. Sl
ページ13に含まれる内容の要旨
OPERATING THE HEADPHONES 1. Power switch Press to activate the headphones. The power on the headphones will turn off automatically, if an audio signal is not detected for over a minute. 2. Source selector switch Switches between the audio sources. 3. Volume adjustment switch Adjusts the volume of the sound in the headphones Note: • Headphones are not to be worn by the operator of the vehicle when driving. • Do not leave the headphones in a place subject to direct sunlight or ex
ページ14に含まれる内容の要旨
INSTALLATION INSTRUCTIONS About the Installation The installation of the OHM102/OHM153 overhead monitor system requires experience in both mechanical and electrical procedures. If you do not posses the necessary experience or tools to attempt this installation, contact a local Clarion dealer for assistance. Improper installation can result in damage to the monitor and/or the vehicle. This manual provides basic installation tips and techniques to aid in the installation of the OHM102/OH
ページ15に含まれる内容の要旨
4. Lower the vehicle’s headliner down to see if a roof support beam is available to screw the mounting bracket onto. If a support beam is not available to screw into, use a ¾” piece of plywood cut to the appropriate size. Attach the plywood to the roof of the vehicle using silicone allowing adequate drying time. 5. Screw the mounting bracket in the vehicle. DOUBLE CHECK THE LENGTH OF THE SCREWS PRIOR TO MOUNTING THE BRACKET. 6. Cut a 1” hole in the headliner along the backside of the
ページ16に含まれる内容の要旨
Roof Beam Headliner Screws (Not Provided) Metal Bracket (Included) Screws (Not Provided)
ページ17に含まれる内容の要旨
COMPLETE SYSTEM DIAGRAM DOME Light Control IR Transmitter A B OEM Head Unit Audio Output FM200 +12V +12V AV Input 4 AV Input 1 Ground Ground AV Input 2 Video Out AV Input 3 DVD(VS735) DVD(VS735) VMA7191 AV4 VCR(VDH910) Negative Positive Av3 GND Av2 Av1 IR Video L R Audio IR Video Power Plug L AV1 R AV2 Audio AV3 Video Out AV4 IR FM Module Video FM MOD L R Audio Video Audio-R Audio-L Antenna V/OUT +12V Av4
ページ18に含まれる内容の要旨
Connection Diagram Connection Diagram Please refe Please refer the to the con r the to the connectio nection n diag diagram on P ram on Page age 16 for the pro 16 for the proper per wirin wiring g co condition nditions for th s for the e OHM OHM102/O 102/OH HM153 ove M153 over rhe head monito ad monitor. If r. If you are u you are un ncert certain as to wh ain as to what the prop at the proper er con conn ne ec ction tions are s are plea please conta se contac ct a qualified t a qualified C
ページ19に含まれる内容の要旨
PACKAGE CONTENTS 1 OHM102 Or 1 OHM153 2 Audio Video RCA Accessories 2 Audio Video Din Cables 1 Convenient External Game Port 1 Audio Output Din Cable 1 Two-Pin Power Harness 1 Metal Mounting Bracket 4 Screws For Metal Mounting Bracket 1 Soft Black Rubber Gasket 1 Remote Control (RCL 123) TROUBLESHOOTING No Picture Press the POWER and SOURCE buttons to make sure the monitor is on and the proper input is selected. If there is still no picture press the PICTURE button. If
ページ20に含まれる内容の要旨
SPECIFICATIONS Supply: 12V DC (10V-16V) Test Voltage: 12V, negative ground Current Consumption: (OHM102) 1 Amp, (OHM153) 1.9 Amps Max Current Consumption: (OHM102) 1.1 Amps, (OHM153) 2 Amps Operating Temperature: (OHM102) 0 ~ 60 C, (OHM153) 0~50 C Storage Temperature: (OHM102) -30 C ~ 85 C (OHM153) -20 C ~ 60 C Video System: Auto NTSC and PAL Screen: (OHM102) 10.2” Diagonal (OHM153) 15.3” Diagonal Resolution: (OHM102) 800 X 480 (OHM153) 1280 X 768 Weight: (OHM102) 2.6lbs, (OHM
