Dakota Digital Led Tail Lights LAT-NR112 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

INSTALLATION INSTRUCTIONS
LAT-NR112
LED Tail Lights for 1966 GTO

MAN#650245

Kit Includes:

Installation:

1. Remove the original bulb connectors from the bottom side of the housing.
2. Remove the plastic housing from the vehicle.
3. Remove the tail light lens by gently prying the housing away from the lens tabs.

4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is
recommended.
5. Remove the round mounting plate from the bottom of the

ملخص المحتوى في الصفحة رقم 2

6. Insert each new LED assembly through the hole where the original bulb and connector were located. Use caution when feeding the wires through the socket opening to avoid damaging the wire insulation. 7. Feed the wires through the large hole in the back plate and attach the back plate onto the back side of the housing. The flat side of the mounting plate should be toward the outside and the side with the slight raised center should go in towards the housing. This will align the

ملخص المحتوى في الصفحة رقم 3

LED light Vehicle harness Tail light Brown Brown Driver’s Turn Green Green Passenger’s Turn Green Yellow Ground Black Black or chassis 12. Repeat for the other side. 13. Test the tail lights, brake lights, and turn signals. If the turn signals do not flash you will need to upgrade your flasher. If you are replacing only the rear turn signals you should be able to use a heavy duty electronic flasher from your local parts store. If you are replacing both front and rear or do not have