Philips MCD395/12 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

1
Quick Start Guide
2
User Manual
MCD395
Quick Start Guide
What’s in the Box?
You should find these items upon opening the box.
Remove the plastic
USB/ USB/
protective sheet
Remote control with
Quick Start Guide
Composite Video Cable
battery
FM antenna User Manual
MCD395 QUG_Eng 1 2010.4.2, 12:33

ملخص المحتوى في الصفحة رقم 2

1 Connect the speaker cables. 2 Connect the FM antennas. Tip 3 See the User Manual for other TV connection options. Connect the composite video cable to a TV. 4 Connect the power cords of the system and TV. FM wire antenna A A To listen to the sound of this DVD Player through your TV, use the audio cables (white/ Speaker Speaker red-not supplied) to connect LINE OUT (right) (left) (L/R) jacks of the DVD Player to the R L + corresponding AUDIO IN jacks on the TV. – SPEAKER 4Ω AUDIO OUT L R A

ملخص المحتوى في الصفحة رقم 3

Setting the clock Important! – To set clock in the Eco Power mode, press and hold ECO POWER/STANDBY-ON on the set for 3 seconds or more to switch to normal standby mode first before proceeding with the procedures below. 1 In standby mode, press and hold CLOCK on the system. 2 When the hour digits flash, turn the VOL control on the front panel or press VOL +/- on the remote to set the hours. 3 Press CLOCK again and the minute digits flash. Then turn the VOL control on the front panel or press VO

ملخص المحتوى في الصفحة رقم 4

Playing a disc 1 Press OPEN•CLOSE 0 to open the disc tray and load in a disc, then press the same button again to close the disc tray. ➜ Make sure the label side of the disc is facing up. 2 Playback will start automatically. If not pressÉÅ. 3 To stop playback, press 9. Programming and tuning to radio stations 1 Press SOURCE (TUNER on the remote) to select tuner source. 2 Press PROG/ANGLE for more than two seconds to program all available stations in order of waveband. 3 Press PRESETí/ë until the