Havis-Shields 1996-2008 Crown Victoria Swing-Out Dash Monitor Mount S-DMM-XXX-CV-SO دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

INSTALL INSTRUCTIONS S-DMM-XXX-CV-SO
1996-2008 CROWN VICTORIA
SWING-OUT DASH MONITOR MOUNT
**Does not work on 2008 Police Package Crown Vic with optional CD player**
TOOLS REQUIRED:
• Ratchet Wrenches
• Sockets - 7mm, 7/16”, 9/16”
• Open End Wrenches - 7/16”, 9/16”
• Phillips Screwdriver
• T-20 Torx Driver
• AM/FM (DIN) Removal Tool
HARDWARE:
QTY: DESCRIPTION: PART #:
1 3/8”-16 x 1 Hex Bolt GSM33028B
2 3/8” Flat Washer GSM31007B
1 3/8” Nylock Nut GSM30018B
4 1/4-20 Hex Flange Serrated Nut GS

ملخص المحتوى في الصفحة رقم 2

Installation: OEM Dash Remove AM/FM Radio, Center Dash Trim, Prior to installation. HVAC Controls. (7mm Socket & DIN Tool) #1 #2 #3 Remove 4 screws at lower end of the upper Remove mounting brackets from new dash dash panel. (7mm socket) monitor mount assembly. Pull out upper dash and tuck #2 bracket Hole in #2 bracket will line up with large behind dash panel. hole in dash steel frame. Reattach upper dash panel. 2 S-DMM-XXX-CV-SO_INST_3-08a

ملخص المحتوى في الصفحة رقم 3

Attach #2 bracket to dash frame with 3/8” Tighten 3/8 bolt. hex bolt, washers, and nut. (9/16 socket and wrench) Slip #1 bracket over plastic AM/FM radio Reattach center dash trim and run computer support. wires. Run computer wiring through notch (top Attach monitor mount to #1 and #2 brackets passenger side) and place monitor mount into with 1/4” bolts provided. dash cavity. 3 S-DMM-XXX-CV-SO_INST_3-08a

ملخص المحتوى في الصفحة رقم 4

Position assembly and tighten bolts. Attach top & bottom dash clamps (#3 bracket) with #8x1” phillips machine screws. Dash mount installed. Check computer Attach computer wiring and monitor adaptor wiring length and fi nd AM/FM wiring. bracket. Note: Some computers require wiring to be Determine desired position of monitor. connected prior to attaching adaptor bracket. 4 S-DMM-XXX-CV-SO_INST_3-08a

ملخص المحتوى في الصفحة رقم 5

Attach monitor bracket to dash mount with Position and wire tire wiring. 1/4” nuts. Wiring complete. Connect AM/FM radio harness and antenna cable. Check radio operation. Snap radio into mount bracket. Dash monitor mount and console installation complete. 5 S-DMM-XXX-CV-SO_INST_3-08a