Havis-Shields Pentax Printer Mount '96-08 Ford Crown Victoria C-3610-CV دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

INSTALL INSTRUCTIONS C-3610-CV
PENTAX PRINTER MOUNT ‘96-08 FORD CROWN VICTORIA


TOOLS REQUIRED:
Power Drill Phillips Screwdriver
Drill Bit Set Wire Crimping Tool

HARDWARE:
QTY DESCRIPTION PART #
3 #10 X ½” Sheet metal screw GSM33194
3 #10 X ¾” Sheet metal screw GSM33195
5 #8 X 3/8” Black torx screw CM86508
1 #10 X ½” Machine screw GSM33118

REMOVE:
1. Using Phillips screw driver, remove existing inner plastic glove box assembly.
(Do not remove glove box door)

INST

ملخص المحتوى في الصفحة رقم 2

• Place latch “L” bracket on the glove box door – mark and drill a 5/32” pilot hole. (“L” bracket is attached to slide rail and can be accessed through opening in housing) Mount bracket using (1) #10 X ½” Sheet metal screw. Check and adjust slide rail bolt as needed. 4. Pentax Printer: • Put printer into housing. • Plug in the power and data cable to printer. • Run data cable to Monitor or CPU. (Depending on application) • Run power and ground to a 12volt battery or ignition so