Network Computing Devices 2190 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

2190
WARNING!
Do not inflate this assembly when it is
unrestricted. The assembly must be restricted by
the suspension or other adequate structure. Do
not inflate beyond 100 P.S.I. Improper use or
over inflation may cause property damage or
severe personal injury.
INSTALLATION INSTRUCTIONS
Congratulations - your new Air Helper Springs are quality Your kit includes separate inflation valves and air lines for
products capable of improving the handling and comfort of your each air helper spring

ملخص المحتوى في الصفحة رقم 2

WHEEL 
    NOTE:
       BRAKE-LINE BRAKE-LINE / AXLE BRACKET VENT TUBE CLIP                      FRAME BRACE 3/8” -16 x 4” HEX BOLTS
   DRILL TWO 7/16” HOLES 3/8” -16 FLANGED LOCK NUT UPPER BRACKET JOUNCE BUMPER BRACE 3/8” -16 AIR FLANGED HEX NUT FITTING AIR LINE 5/16” -18 FLANGED HEX NUT LEAF STACK J-BOLT 5/16” -18 INSTALLATION FLANGED LOCATION HEX NUT AIR JOUN

ملخص المحتوى في الصفحة رقم 3

STEP 1 - PREPARE THE VEHICLE FRAME FRAME RAIL BRACE Remove the positive battery cable. With the vehicle on a solid, level surface chock the front wheels. Raise the vehicle by the axle and remove the rear wheels. UPPER AIR SPRING After the removal of the wheels lower the vehicle so the axle rests on jack stands BRACKET LOWER rated to support your vehicles weight. This installation assumes that there is no BRACKET load in the bed of the truck. J-BOLT Your vehicle is equipped with rubber jounce

ملخص المحتوى في الصفحة رقم 4

Important: In order for the air spring to function properly, there must be AIR a minimum of 1/2" of clearance around the air spring. The right-side parking AIR HOSE SPRINGS brake-line must be tied to the brake-line bracket on the axle housing to prevent it from interfering with the normal operation of the left-side air spring see Figure "D". STEP 4 - INSTALL THE PASSENGER'S SIDE ASSEMBLY INFLATION VALVES Follow steps 2 - 5 for assembly and installation of the passenger's side assembly. Note: