Heath Zenith Motion Sensing Diecast Metal Lantern None دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

INSTALLING THE SWITCH
WARNING: Turn power off at the circuit breaker before wiring.
Single
• Remove the decorative coverplate (secured by two
screws).
• Remove Control Cover. (Press in with screwdriver.
Pole Motion
Swing out cover to remove.)
• Remove the existing switch (if this is a retrofit
application).
Sensing Switch • Connect the detector as shown in the diagram.
Before installing the detector into the box, make
The Single Pole Motion Sensing Switch detects motion to tur

ملخص المحتوى في الصفحة رقم 2

ADJUSTMENTS TROUBLESHOOTING SYMPTOM POSSIBLE CAUSE SYMPTOM POSSIBLE CAUSE TIME LIGHT LEVEL 1. Light does not Circuit breaker or fuse is Light does not 1. Incorrect wiring. There are 6 preset selections for the amount The sensor can be prevented from turning on lights come on. turned off. turn off. 2. MODE switch is set to of time the lights stay on: Test (5 seconds), 1, when there is already enough light in the room. Use a 2. If the lamp being con- ON instead of AUTO. 5, 10, 15, and 20 minutes.