Chief Manufacturing FSR Series دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

INSTALLATION INSTRUCTIONS
SMALL FLAT PANEL STATIC WALL MOUNT
Model: FSR Series
Specifications:
• Designed for installation on single wood studs or
drywall (1/2" minimum thickness); either option
provides ±1/2" lateral shift.
• Weight capacity of 45 lbs (20 kg) for wood stud or
drywall installation.
BEFORE YOU BEGIN
WARNING: It is the installer’s responsibility to make sure all components are properly assembled and installed using
the instructions provided. Failure to read, thoroughly under

ملخص المحتوى في الصفحة رقم 2

Model: FSR Series Installation Instructions IMPORTANT WARNINGS AND CAUTIONS! WARNING: A WARNING alerts you to the possibility of serious injury or death if you do not follow the instructions. CAUTION: A CAUTION alerts you to the possibility of damage or destruction of equipment if you do not follow the corresponding instructions. WARNING: It is the installer’s responsibility to make sure the structure to which this unit is attached can support five times the combined weight of all equipmen

ملخص المحتوى في الصفحة رقم 3

Installation Instructions Model: FSR Series TOOLS REQUIRED FOR INSTALLATION PARTS • Drill After unpacking carton, inspect and verify contents (See Figure 1). If any listed parts are missing or damaged, • 1/8" drill bit (wood stud installation) contact Chief Customer Service at 1-800-582-6480. • 3/8" drill bit (drywall installation) • Hammer (drywall installation) • Phillips screwdriver, #2 NOTE: Other tools may be required depending on your Table 1: Parts method of installation. Item Descr

ملخص المحتوى في الصفحة رقم 4

Model: FSR Series Installation Instructions INSTALLATION INSTALL MOUNT TO DRYWALL The FSR may be installed on either a single wood stud, or drywall (1/2" minimum thickness). WARNING: Drywall must be 1/2" minimum thickness. Failure to provide adequate structural strength for this INSTALL MOUNT TO SINGLE WOOD STUD unit can result in serious personal injury or damage to 1. Determine approximate mounting location, keeping in equipment! mind the display size. 1. Determine approximate mounti

ملخص المحتوى في الصفحة رقم 5

Installation Instructions Model: FSR Series collapsed anchors (20). Tighten until secure (See Figure 4). Button location for 100mm x 100mm (20) pattern (4 places) (4 places) (30) (4 places) Button location for 75mm x 75mm pattern (4 places) Anchor Screw (4 places) NOTE: Display not shown for clarity. (10) Figure 6: Install Display to Plate 3. Close latching flag by rotating flag counterclockwise Figure 4: Installation to Drywall on plate (10) (See Figure 7). NOTE: An optional padlock may b

ملخص المحتوى في الصفحة رقم 6

Model: FSR Series Installation Instructions 6