Dakota Digital LED Tail Lights LAT-NR150 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

INSTALLATION INSTRUCTIONS
LAT-NR150
LED Tail Lights for 1970-72 Nova

MAN#650177

Kit Includes:

Installation:

1. Remove the tail light lens.

2. Remove the light bulb
3. Remove the original bulb connector from the back side of the housing.


4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is
recommended.
5. Remove the two screws and mounting plate from the side of the new LED assembly.

6. Insert the new LED assembly into the

ملخص المحتوى في الصفحة رقم 2

avoid damaging the wire insulation. 7. Feed the wires through the larger hole in the mounting plate and guide it to the bottom of the housing. The flat side of the mounting plate should be on the outside of the housing and the side with the slight raised center should go toward inside of the housing. This will properly align the mount in the original housing. 8. Now hold the LED assembly centered over the hole where the original bulb was and align the mounting plate from the bott

ملخص المحتوى في الصفحة رقم 3

11. Cut off the existing light socket as it will not be used. Do not strip the wires. Trim the wires from the LED assembly to the appropriate length once mounted, making sure wires are routed cleanly and securely. 12. Use the supplied moisture resistant pigtail connectors* to attach the wires from the new LED assembly to the existing vehicle harness. Insert appropriate wire from vehicle harness and mating LED assembly wire into a connector and crimp following instructions below. *For