Chamberlain ROI2 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

®
Model ROI2
Wireless Portable Indoor/Outdoor
Intercom
Overview
Call Mode: In Call Mode the intercom may only be
used to call the intercom network and will not be able
The Intercom has up to a 1000' range and allows
to hear conversation from within the network.
multiple simultaneous conversations, using a
To put intercom into Call Mode place
900 Mhz secure digital radio link. The intercoms form
Dipswitch #1 to the UP position.
an exclusive network and respond only to other
intercoms in the netw

ملخص المحتوى في الصفحة رقم 2

Mounting with Tape Programming Intercom The intercom must be programmed to at least one Step 1 other intercom to become a network or it can be programmed into an existing network. Create New Network Clean back of intercom and mounting surface using the alcohol wipe. Press the Learn button on the new intercom until a beep is heard. Within 5 seconds put the second Step 2 intercom into Learn Mode (refer to table below). INTERCOM LEARN MODE Press the Learn button until a beep is heard. OR Press and

ملخص المحتوى في الصفحة رقم 3

Secure Cover Troubleshooting Intercom does not function. Check batteries in Intercom. When you press the Talk button you should hear a tone. Ensure Intercom is connected to a network. See Assemble & Program. Intercom is not getting expected transmission range. Keep Intercom away from trees, metal objects and electrical wiring. Do not mount intercom on a tree, masonry, or metal surface. Secure cover with the two large black screws. Intercom beeps every ten minutes. The battery is low in the int

ملخص المحتوى في الصفحة رقم 4

FOR TECHNICAL SUPPORT DIAL OUR TOLL FREE NUMBER: 1-800-528-9131 www.chamberlain-DIY.com NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference