Cloud B ME-1 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

ME-1
Remote Mic Input Plate
Installation Guide
Introduction
The ME-1 is a remote mic input plate for use with the Cloud DCM-1 Digitally Controlled
Mixer, and cannot be used with any other Cloud product. This document provides
information on how to connect ME-1s into a DCM-1-based audio system. Further
information on configuring the DCM-1 itself for use with ME-1s can be found in the
DCM-1 Installation and User Guide.
The ME-1 allows connection of two separate microphones into a DCM-1-based

ملخص المحتوى في الصفحة رقم 2

Introduction - continued The two microphone channels are identical. The mic input connector is a 3-pin latching female XLR, wired to the industry-standard pinout: PIN FUNCTION 1 Ground 2 Signal ‘hot’ (+, phase) 3 Signal ‘cold’ (-, antiphase) Phantom power (12v) can be activated by a rear jumper (see below), permitting the use of either dynamic or condenser microphones. Between -85dB and +60dB of gain adjustment is available with the faceplate control to suit most types of microphone; when th

ملخص المحتوى في الصفحة رقم 3

Connect to an unused Microphone Input Microphone Inputs ME-1 DCM-1 1 3 2 4 LINK OUTPUT Extension Ports Connect to 1 3 Output socket 2 4 Screened CAT-5 cable PIN USE CAT-5 CORE 1 8 1 Mic sum (cold) White + Orange 2 Mic Sum (hot) Orange 1 8 3 Sense White + Green 4 DC +ve Blue 5 0v White + Blue 1 8 6 DC -ve Green 7 n/u White + Brown 1 8 8 n/u Brown Connecting Multiple ME-1s Multiple ME-1s may be “daisy-chained” together to provide additional input points, normally in the same zone. Signals applied

ملخص المحتوى في الصفحة رقم 4

ME-1 ME-1 ME-1 Additional LINK OUTPUT LINK OUTPUT LINK OUTPUT input plates ZONE 1 ME-1 ME-1 To DCM-1 Microphone Inputs (one per zone). Additional LINK OUTPUT LINK OUTPUT input plates ZONE 2 Note that it is not possible to intermix ME-1s with either Cloud LE-1 or BE-1 remote line input plates in this manner. Phantom Power Channel 1 Channel 2 12 volt phantom power may be enabled on either input (TOP VIEW) channel. The installer should determine Channel 1what type of Channel 2 (TOP VIEW) Phanto