ملخص المحتوى في الصفحة رقم 1
DIVA T/A PC Card
User’s Guide
ملخص المحتوى في الصفحة رقم 2
Third Edition (March 1998) 206-146-03 DIVA T/A PC Card is a trademark of Eicon Technology Corporation. Microsoft, Windows, and Windows NT are registered trademarks of Microsoft Corporation. CompuServe is a registered trademark of CompuServe Incorporated. Hayes is a registered trademark of Hayes Microcomputer Products, Inc. Changes are periodically made to the information herein; these changes will be incorporated into new editions of the publication. Eicon Technology may make improveme
ملخص المحتوى في الصفحة رقم 3
Table of Contents Introduction.......................................................................................... 5 What You Will Need.......................................................................... 6 Ordering your ISDN Line Using EZ-ISDN/IOC ................................. 7 Connecting the Cables.......................................................................... 8 Installing the DIVA T/A Software ..................................................... 20 The Eicon DIVA T
ملخص المحتوى في الصفحة رقم 4
DIVA T/A Firmware Specifications .................................................. 86 DIVA T/A Hardware Specifications .................................................. 87 Customer Service ............................................................................... 88 Eicon Technology on the World Wide Web ..................................... 88 Eicon Technology on CompuServe .................................................. 88 International Regulatory Information and Conditions of Use...
ملخص المحتوى في الصفحة رقم 5
Introduction The DIVA T/A is an ISDN PC CARD (PCMCIA) modem available in S/T and U interface versions. It provides easy and affordable high- speed Basic Rate Interface (BRI) ISDN connection to the Internet or to your office LAN. With the DIVA T/A, Small Office Home Office (SOHO) users and telecommuters can combine the higher performance of ISDN with the simplicity of a terminal adapter. The DIVA T/A emulates a COM port on your computer, which complements your TCP/IP application (without the need
ملخص المحتوى في الصفحة رقم 6
What You Will Need To install and use of the DIVA T/A, you will need the following: Item Description DIVA T/A Package DIVA T/A PC Card DIVA T/A Software DIVA T/A S/T or integrated-NT1 cable ISDN cable (RJ45) DIVA T/A QuickStart Guide DIVA T/A Release Notes PC or Notebook Computer Equipped with a PC Card Type II slot. Remote Access Client Supplied as part of the operating platform or by Software Internet Service Provider. ISDN Basic Rate Line (BRI) Installed by your local telephone c
ملخص المحتوى في الصفحة رقم 7
Ordering your ISDN Line Using EZ-ISDN/IOC (North America only) We highly recommend that you use our toll free ISDN ordering service to make sure you get the correct ISDN line the first time. This service is free to our customers. Dial 1-888-800-DIVA. EZ-ISDN / IOC simplifies the ordering of your ISDN line. It lets you use simple codes to order pre-configured packages of ISDN features and services. The North American ISDN User’s Forum (NIUF) and Local Exchange Carriers (LEC) administer the a
ملخص المحتوى في الصفحة رقم 8
Connecting the Cables To install the DIVA T/A into your PC: 1 Push the ISDN S/T or U cable (see › in Figure 1) straight into the jack on the card. Push the connector locking tab toward your card. ` ISDN U (Integrated NT1) Cable Plug into ISDN jack ISDN S/T cable B and D LEDs ´ Insert into PC ISDN Cable DIVA T/A PC Card Figure 1. 2 Connect the other end of the cable to the ISDN cable (see fi in Figure 1) and the ISDN cable to an NT-1 (if required) or to the ISDN wall socket. Note: Some S/T co
ملخص المحتوى في الصفحة رقم 9
After Connecting the Cables Where AutoSPID is supported (check with your ISDN service provider), the DIVA T/A installation is totally Plug and Play. Continue at “What’s Next?” on page 10. If your ISDN line does not support AutoSPID, get the following information from your ISDN service provider before continuing the DIVA T/A installation: ISDN number(s). Your ISDN service provider should have provided you with one or two ISDN numbers. These numbers are required to configure the DIVA T/A. SPID
ملخص المحتوى في الصفحة رقم 10
What’s Next? After you have finished connecting the cables and gathering the required information, go to the section that corresponds to your platform and continue the installation. Pl atform What to do Windows 95 Cont inue on page 11 Windows 95 OSR2 Continue on page 13 Windows NT 4.0 Continue on page 15 Windows NT 3.51 Continue on page 18 Windows 3.x/WFW 3.11 Continue on page 19 DOS and OS/2 Continue on page 46 DIVA T/A PC Card User’s Guide 10
ملخص المحتوى في الصفحة رقم 11
Windows 95 Note: This install procedure is for the original release and Service Pack 1 (SP1) version of Windows 95. If you are using Windows 95 Service Release 2 (OSR2), go to page 13. To verify the version installed on your machine, go to Control Panel/System Properties and select the General tab. If you have the original or SP1 version of Windows 95, it should show as one of the two screens below: Note: If you are using Dial-Up Networking, make sure you are using version 1.2. If you are run
ملخص المحتوى في الصفحة رقم 12
4 In the Install From Disk window, enter the drive letter of your CD drive (or use the Browse button to locate your CD drive) and click OK. 5 Go to page 20 and continue at the section “Installing the DIVA T/A Software.” DIVA T/A PC Card User’s Guide 12
ملخص المحتوى في الصفحة رقم 13
Windows 95 (OSR2) Note: This install procedure is for Windows 95 Service Release 2 (OSR2). If you are using original release or Service Pack 1 (SP1) version of Windows 95, go to “Windows” on page 11. To verify the version installed on your machine, go to Control Panel/System Properties and select the General tab. If you have Windows 95 OSR2 installed, you should see the letter “B”, as below: Note: If you are using Dial-Up Networking, make sure you are using version 1.2. If you are running a pre
ملخص المحتوى في الصفحة رقم 14
5 Enter the drive letter of your CD drive (or use the Browse button to locate your CD drive) and click OK. 6 In the update Device Driver Window, click Finish. 7 Go to page 20 and continue at the section “Installing the DIVA T/A Software.” DIVA T/A PC Card User’s Guide 14
ملخص المحتوى في الصفحة رقم 15
Windows NT 4.0 Note: Before you begin installing the DIVA T/A, we suggest that the Remote Access Service (RAS), also known as Dial-Up Networking, be installed with at least one modem (any modem will do; it is only needed to install the DIVA T/A and can later be removed). 1 Shutdown Windows NT and turn off your PC. After connecting the cables (see “Connecting the Cables” on page 8), insert the DIVA T/A, label side up, into the PC Card slot. 2 Start your computer and allow Windows NT to start. 3 I
ملخص المحتوى في الصفحة رقم 16
5 Select Don’t detect my modem; I will select it from a list, then click Next. Important: Make sure that you select the choice above and do not let Windows NT choose its own modem driver. If you let Windows NT select the modem driver, you will not be able to communicate with the DIVA T/A. You will then have to delete the Windows NT installed modem and restart the install process again from Step 4. 6 From the Install New Modem windows, click Have Disk; when prompted, enter the path to the CD (
ملخص المحتوى في الصفحة رقم 17
7 Select the Eicon DIVA T/A, then click Next. 8 Select the appropriate COM Port the DIVA T/A is connected to. Click Next, then click finish. 9 Close the Modem Properties window. 10 After closing the Modem Properties window, you are prompted to configure Dial-Up Networking, as the install Modem list has changed. Click Yes to configure Dial-Up Networking. 11 From the Remote Access Setup window, remove any unused devices that use the same COM port as the DIVA T/A, and then click Add. 12 In the Ad
ملخص المحتوى في الصفحة رقم 18
Windows NT 3.51 If you are going to use the DIVA T/A with RAS, RAS must already be installed with at least one modem (any modem will do, it is only needed to install the DIVA T/A and will later be removed). If this is the case, follow the steps below. If you are not going to use RAS, continue at “Installing the DIVA T/A Software” on page 20. 1 Shutdown Windows NT and turn off your PC. After connecting the cables (see “Connecting the Cables” on page 8), insert the DIVA T/A, label side up, into t
ملخص المحتوى في الصفحة رقم 19
Windows 3.x/WFW 3.11 Note: If you are installing the DIVA T/A on a system without a CD drive, it is possible to make disks from the DIVA T/A CD on another machine. To create the disks, follow the instructions in the MAKEDISK.TXT file located in the \WIN16\MAKEDISK directory of your DIVA T/A CD. If you are going to use the DIVA T/A with RAS for WFW, RAS must already be installed with at least one modem (any modem will do, it is only needed to properly install the DIVA T/A and will later be remov
ملخص المحتوى في الصفحة رقم 20
Installing the DIV A T/A Software Note: there is no Setup Wizard for DOS or OS/2. If you are using DOS or OS/2, go to the section ‘Using the VT100 Configuration Tool” on page 46. T he DIVA T/A Setup Wizard installs all necessary DIVA T/A files on your system. These include: the DIVA T/A on-line documentation the Eicon DIVA Terminal Adapters Program, which includes the Configuration Wizard (Windows 95 and NT only) the Windows Configuration Tool (Windows 3.x & WFW 3.11) the DIVA T/A Uni
