Blue Sea Systems PN 8408 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

WARNING
Marine Electrical Products
] These instructions are intended to provide assistance with the
AC & DC Power Distribution Panel
installation of this product, and are not a substitute for a more
comprehensive understanding of electrical systems. We strongly
PN 8408 / PN 3408 / PN 8508 / PN 3508
recommend that a competent electrical professional perform the
Specifications
installation of this product.
Material: 0.125" 5052-H32 aluminum alloy
] If either the panel front or

ملخص المحتوى في الصفحة رقم 2

DC Installation (continued) 3. Install battery bank voltage monitor wires 6. Installation of Backlight System The panel is supplied with a digital meter and switch to monitor the Connect the yellow negative wire to the panel negative bus. Do not voltage of three separate sources, usually the batteries. Connect a confuse with the AC neutral bus. minimum 16 A WG red wire from each source to be monitored to each of To activate the label lights by the boat’s battery switch, connec

ملخص المحتوى في الصفحة رقم 3

Panel Mounting and Testing 1. Apply branch circuit labels and mount panel ] Using a multimeter where the power source is connected to the panel Apply a label for each circuit from the label set provided. If the verify: appropriate label is not included, extended label sets are available PN 8408 / PN 3408—120 V olt AC through retail suppliers, and over 500 individual labels are available a. 120 volts between hot and neutral directly from Blue Sea Systems. Please go to www.bl

ملخص المحتوى في الصفحة رقم 4

9089 Rev . 006 Page 4 of 4 0.5 TO 2 AMP FUSES ADDITIONAL BREAKER REQUIRED IF GREATER THAN 10 FEET 1 TO 2 AMP FUSE Wiring Diagram AC/DC Power Distribution Panel with AC & DC Digital Multimeters PN 8408 / PN 3408 shown for reference