Epson 830p دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

E
R
® ®
Epson PowerLite 830p
Quick Setup
Connect the projector
to your notebook
Locate the required cables:
1
Power cord VGA computer cable
Connect the computer cable to
2
the Computer 1/Component
port on the projector.
Connect the other end to your notebook’s video-out
3
or monitor port.
NOTE: If your notebook has a DVI connector, you need to either
use a DVI-to-VGA adapter with the included computer cable (see
your computer’s documentation), or purchase an optional DVI
Follow these instructio

ملخص المحتوى في الصفحة رقم 2

Quick Setup EpsonPowerLite 830p Using the remote control Troubleshooting If this is your first time using the remote, 1 make sure its batteries are installed as shown. If you see a blank screen... If you see a blank screen or the No signal message after turning on your notebook, check the following:  Make sure the Power light on the projector is green and not flashing, and the lens cover is off.  Press the Computer/Component button on the projector to select Computer 1 as the image source. Pus