Epson 830pの取扱説明書

ページ1に含まれる内容の要旨

E
R
® ®
Epson PowerLite 830p
Quick Setup
Connect the projector
to your notebook
Locate the required cables:
1
Power cord VGA computer cable
Connect the computer cable to
2
the Computer 1/Component
port on the projector.
Connect the other end to your notebook’s video-out
3
or monitor port.
NOTE: If your notebook has a DVI connector, you need to either
use a DVI-to-VGA adapter with the included computer cable (see
your computer’s documentation), or purchase an optional DVI
Follow these instructio

ページ2に含まれる内容の要旨

Quick Setup EpsonPowerLite 830p Using the remote control Troubleshooting If this is your first time using the remote, 1 make sure its batteries are installed as shown. If you see a blank screen... If you see a blank screen or the No signal message after turning on your notebook, check the following:  Make sure the Power light on the projector is green and not flashing, and the lens cover is off.  Press the Computer/Component button on the projector to select Computer 1 as the image source. Pus