APC PDM3530L2130 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Electrical Hazard. To prevent arcing when removing an
APC Power Distribution Module (PDM) from the Modular

Power Distribution Unit (PDU), set all PDMs to OFF. Do not
remove the modules while they are still supporting the load.

Caution: PDMs must be replaced by trained personnel only.

Installation
Verify that all the breakers are in the OFF position.

Note: The PDM can be safely installed into a
InfraStruXure Power Distribution Module
powered rack.
Press the red button to release the

ملخص المحتوى في الصفحة رقم 2

Veritcal Rack Distribution Panel Horizontal Rack Distribution Panel How to install a PDM circuit breaker handle tie Note: A circuit breaker handle tie has been provided for some PDMs that may require them. Check local codes.           Locate the handle tie above the circuit breaker handles aligning the  two tabs between the three handles. Push the handle tie towards the circuit breaker handles until it snaps  into position. Check to make sure that the handle tie is secure.  The h