Extron electronic sDTP HDMI 330 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

LR
LR
DTP HDMI 330 • Setup Guide
This guide provides quick start instructions for an experienced installer to set up and operate the
Extron DTP HDMI 330 digital video extender. The DTP HDMI 330 transmitter and receiver pair can
extend an HDCP-compliant HDMI signal up to 330 feet (100 m).
Installation
Step 1 — Mounting
Turn off or disconnect all equipment power sources and mount the Tx and Rx units as required.
DTP HDMI 330 Tx Rear Panel DTP HDMI 330 Rx Rear Panel
SIG LINK SIG

ملخص المحتوى في الصفحة رقم 2

DTP HDMI 330 • Setup Guide (Continued) Power connector — Connect an IEC power cord between the included 12 VDC g power supply and a 100-240 VAC, 50-60 Hz source. Connect the power supply to either unit as shown at right. Use the included tie-wrap to strap the cord to the Captive Screw captive screw connector. Connector Smooth Ridges NOTE: Only one power supply is required. A single power supply connected to either unit in the pair powers both units. A power supply is included with each tra