ASA Electronics MS160 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

ملخص المحتوى في الصفحة رقم 2

ملخص المحتوى في الصفحة رقم 3

RESET BUTTON A RESET button is located on the front of the chassis. The re-set circuitry is provided to protect the microprocessor circuitry and should only be activated under the following circumstance: If there is a malfunction of the switches on the unit or the CD player, pressing the RESET button may clear the system and return to normal MOD BUTTON Pressing this button to cyclically change function Radio-CD-Aux-Radio START BUTTON (M1) Pressing

ملخص المحتوى في الصفحة رقم 4

APPLICATION NOTES WIRING DIAGRAM This note will discuss DC Power sources and how they relate to 12 volt (Figure 2) products. CONNECTIONS General Specifications Our general specification for the voltage range of operation is 10 to AUX INPUT CONNECTOR 16 volts DC . UNIT ANTENNA OPTIONAL Voltage CD CHANGER The voltage of a fully charged battery ( engine not running ) is (ACC56M) BLUE POWER ANT approximately 12.5 VDC. Once a load

ملخص المحتوى في الصفحة رقم 5

APPLICATION NOTES TROUBLESHOOTING CHART AM/FM RECEPTION ANTENNA CABLE AM/FM RADIOS Some boats have more than one Increasing the antenna lead AM/FM radio.The best way to insure cable ( adding extensions ) will Symptom good reception is to supply a reduce sensitivity of AM with Cause Possible Solution separate antenna for each radio. electronic tuned radios. Check circuit fuse at source Other options available to supply No Power No