ملخص المحتوى في الصفحة رقم 1
ENGLISH FRANÇAIS ESPAÑOL
ITALIANO ESPAÑOL FRANÇAIS DEUTSCH
website http://www.lgservice.com
LG
LG Floor Standing-Type
Air Conditioner
OWNER'S MANUAL
IMPORTANT
• Please read this owner's manual carefully and thoroughly
before installing and operating your air conditioner.
• Please retain this owner's manual for future reference after
reading it thoroughly.
ملخص المحتوى في الصفحة رقم 2
Floor Standing- Type Air Conditioner Owner’s Manual TABLE OF CONTENTS FOR YOUR RECORDS Write the model and serial numbers here: Safety Precautions.................3 Model # Serial # Operating Instructions...........9 You can find them on a label on the side of each unit. Dealer's Name Date Purchased Care and Maintenance .........24 Staple your receipt to this page in the event you need it to prove date of purchase or for warranty issues. Before you call READ THIS MANUAL for service ..........
ملخص المحتوى في الصفحة رقم 3
Safety Precautions Safety Precautions To prevent injury to the user or other people and property damage, the following instructions must be followed. Incorrect operation due to ignoring instruction will cause harm or damage. The seriousness is classified by the following indications. This symbol indicates the possibility of death or serious injury. WARNING This symbol indicates the possibility of injury or damage. CAUTION Meanings of symbols used in this manual are as shown below. Be sure
ملخص المحتوى في الصفحة رقم 4
Safety Precautions Do not modify or extend the Do not install, remove, or re- Be cautious when unpacking power cable. install the unit by yourself and installing the product. (customer). • There is risk of fire or electric • There is risk of fire, electric • Sharp edges could cause injury. shock. shock, explosion, or injury. Be especially careful of the case edges and the fins on the condenser and evaporator. For installation, always contact the Do not install the product on a Be sure the in
ملخص المحتوى في الصفحة رقم 5
Safety Precautions Do not allow water to run Do not store or use flammable Do not use the product in a into electric parts. gas or combustibles near the tightly closed space for a product. long time. • It may cause There is risk of fire, • There is risk of fire or failure of • Oxygen deficiency could occur. failure of the product, or electric product. shock. When flammable gas leaks, If strange sounds, or small or Stop operation and close the window turn off the gas and open a smoke comes fro
ملخص المحتوى في الصفحة رقم 6
Safety Precautions When the product is not be used for a long Take care to ensure that nobody could step time, disconnect the power supply plug or on or fall onto the outdoor unit. turn off the breaker. • There is risk of product damage or failure, or • This could result in personal injury and product unintended operation. damage. CAUTION Installation Always check for gas Install the drain hose to Keep level even when (refrigerant) leakage after ensure that water is drained installing the p
ملخص المحتوى في الصفحة رقم 7
ENGLISH Safety Precautions Do not block the inlet or Use a soft cloth to clean. Do Do not touch the metal parts of outlet of air flow. not use harsh detergents, the product when removing the solvents, etc. air filter. They are very sharp! • It may cause product failure. • There is risk of fire, electric shock, • There is risk of personal injury. or damage to the plastic parts of the product. Do not step on or put Always insert the filter securely. Do not insert hands or other anyting on the pr
ملخص المحتوى في الصفحة رقم 8
Prior to Operation Prior to Operation Preparing for Operation 1. Contact an installation specialist for installation. 2. Plug in the power plug properly. 3. Use a dedicated circuit. 4. Do not use an extension cord. 5. Do not start/stop operation by plugging/unplugging the power cord. 6. If the cord/plug is damaged, replace it with only an authorized replacement part. Usage 1. Being exposed to direct airflow for a long time may be hazardous to your health. Do not expose occupants, pets, or plants
ملخص المحتوى في الصفحة رقم 9
ENGLISH Operating Instructions Operating Instructions Features and Specifications 1. Design for cooling 6. 3 cooling speeds 2. Super energy efficiency 7. Removable air filter 3. Micom control 8. Anti-Bacteria filter 4. Whisper quiet operation 9. 3 minutes delay circuit 5. Wireless remote control Air Outlet Vent Air Intake Vent (Rear) Remote Signal Receptor Air Outlet Vent Air Intake Vent Piping Owner's Manual 9
ملخص المحتوى في الصفحة رقم 10
Operating Instructions Indoor Unit Controls and Indicators 7 9 6 5 2 1 8 11 10 4 3 1. START/STOP BUTTON 6. COOLING OPERATION LAMP Operation starts when this button is pressed and stops when the button is pressed again. 7. SOFT DRY OPERATION LAMP 2. OPERATION MODE SELECTION 8. OUTDOOR UNIT OPERATION LAMP BUTTON Used to select the operation Mode. 9. AUTO OPERATION LAMP 3. ROOM TEMPERATURE SETTING 10. OFF TIMER OPERATION LAMP BUTTONS Used to select the room temperature. 11. TURBO-Z OPERATION LAMP 4
ملخص المحتوى في الصفحة رقم 11
ENGLISH Operating Instructions Features of the Remote Control- Door Closed START/STOP BUTTON 1 Operation starts when this button is pressed and stops when the button is pressed again. ROOM TEMPERATURE 2 SETTING BUTTONS Used to select the room temperature. 4 5 INDOOR FAN SPEED 3 SELECTOR 3 1 Used to select fan speed in 3 steps low, high, super high. 2 TURBO-Z 4 Used to start or stop the speed Flip-up door cooling. (Speed cooling operates (closed) super high fan speed in cooling mode.) AUTO AIRF
ملخص المحتوى في الصفحة رقم 12
Operating Instructions Features of the Remote Control- Door Opened ON OFF ON/OFF TIMER BUTTONS 1 Used to set the time of starting and stopping operation. TIME SETTING BUTTONS 2 Used to adjust the time. TIMER SET/CANCEL BUTTONS 3 Used to set the timer when the desired SET CANCEL time is obtained and to cancel the Timer operation. SIMPLE OFF TIMER SET ON OFF 4 BUTTON 1 4 Each time the button is pressed, the mode 2 5 is changed in the following process. SET CANCEL Time set (1, 2, 3, 4, 5, 6, 7 hurs
ملخص المحتوى في الصفحة رقم 13
ENGLISH Operating Instructions Remote Control Preparation 1. How to mount onto a wall Use the screws to secure the holder to the wall or attach the holder side of indoor unit. 2. To insert the remote control to the holder. Insert Pull How to insert batteries • Do not use rechargeable batteries 1. Remove the cover from the back of the such batteries as different from remote controller. standard dry cells in shape, • Slide the cover according to the arrow dimensions, and performance. direction.
ملخص المحتوى في الصفحة رقم 14
Operating Instructions How to use the Operation Mode Button • Each time the Operation Mode Selection Button is pressed, the Operation Mode is shifted in the arrow direction. Cooling Operation Auto Operation Soft Dry Operation Open the door on the remote control. Each time the button is pressed, the operation mode is shifted in the direction of the arrow. Cooling Auto Soft Dry How to use the Fan speed Button • Each time the Fan speed Button is pressed, the Fan speed is shifted in the arrow direc
ملخص المحتوى في الصفحة رقم 15
ENGLISH Operating Instructions Cooling Operation Mode Press the Start/Stop Button. 1 Press the Operation Mode Selection Button. 2 Press the Operation Mode Button on the remote controller. Select Cooling Operation. ON OFF SET CANCEL Set the temperature lower than the room temperature. 3 The temperature can be set within a range of 60°F~86°F by 1°F. To raise the temperature To lower the temperature Set the Fan Speed. 4 Low High Super High Fan speed is on Low. Fan speed is on High Fan speed is on S
ملخص المحتوى في الصفحة رقم 16
Operating Instructions Soft Dry Operation Press the Start/Stop Button. 1 Press the Operation Mode Selection Button. Press the Operation Mode Button on the remote controller. 2 Select Soft Dry Operation. ON OFF SET CANCEL Set the temperature lower than the room temperature. 3 The temperature can be set within a range of 60°F~86°F by 1°F. To raise the temperature To lower the temperature 16 Floor Standing-Type Air Conditioner
ملخص المحتوى في الصفحة رقم 17
ENGLISH Operating Instructions Auto Operation Mode Press the Start/Stop Button. 1 Press the Operation Mode Selection Button. Press the Operation Mode Button on the remote controller. 2 Select Auto Dry Operation. ON OFF SET CANCEL Set the temperature upper or lower than the standard temperature. The temperature can be set within a range of by 1 level. 3 Cold Cool Proper Warm Hot (This indication will be shifted to the initial Auto Mode Display state after 4 seconds.) To raise the temperature. To
ملخص المحتوى في الصفحة رقم 18
Operating Instructions Turbo-Z Operation Press the Start/Stop Button. 1 Press the TURBO-Z button to operate the speed cooling mode and the unit will operate in 2 super high fan speed in cooling mode. To cancel the TURBO-Z mode, press the TURBO-Z button again or the Auto Swing Direction Control Button (Up & Down, Left & Right) or Operation Mode Button and the unit will operate in 3 High. Fan speed on cooling mode. ON OFF ON OFF SET CANCEL SET CANCEL or or or NOTICE ❏ During the TURBO-Z function a
ملخص المحتوى في الصفحة رقم 19
ENGLISH Operating Instructions Press °C ↔ °F Switching Button. Press the Start/Stop Button. 1 Press the Operation Mode button and Low temperature setting buttons simultaneously for 3 seconds. 2 The unit will respond with beep. After 3 second, it will shift Press °C ↔ °F Switching Button. 3 ON OFF SET CANCEL Auto restart In case the power comes on again after a power failure, Auto Restarting Operation is the function to operate procedures automatically to the previous operating conditions. Owner'
ملخص المحتوى في الصفحة رقم 20
Operating Instructions Fan Operation Mode Press the Start/Stop Press Fan Operation Button. Button. 1 2 ON OFF SET CANCEL Set the Fan Speed. 3 ❑ Each time the Button is pressed, the Fan Speed mode is shifted. Fan speed is on Low. Fan speed is on High Fan speed is on Super High Airflow Direction Procedure ON OFF Press the Start/Stop Button. Press this button to make 1 2 the vertical louver auto SET CANCEL swing in right and left directions. Press this button to make the horizontal louver auto swin
