Panasonic CS-A18CTP دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

AUT AU O FA AN N
T S SPEED PEED
HEA HEAT
L
COOL COO H H
D DR RY OFF ON OFF ON
A B
SELE T SET A EL A AL
A B
C /C NC M NU
TEMP OFF/ON
MODE SLEEP FAN SPEED
AUTO
TIMER AIR SWING
RESET
CS-A12CTP CU-A12CTP5 / CS-A18CTP CU-A18CTP5 / CS-A24CTP CU-A24CTP5
8 OperatingInstructions
SAFETY PRECAUTIONS
 Operation Precautions
 Installation Precautions
Before operating, please read the following
“Safety Precautions” carefully.
! Warning ! Warning
 To prevent personal injury, injury to others and This sign wa

ملخص المحتوى في الصفحة رقم 2

CS-A12CTP CU-A12CTP5 / CS-A18CTP CU-A18CTP5 / CS-A24CTP CU-A24CTP5  How to Insert the Batteries NAME OF EACH PART 1 Signal Transmitter  Remote Control 2 Operation Display Cooling Model H H 1 Gently press the place marked OPEN and slide the cover towards you. 2 Insert the batteries – Be sure the direction is correct. Heat Pump Model  About the batteries  Can be used for approximately one year.  Observe the following when replacing the batteries  Replace with new batteries of the same typ

ملخص المحتوى في الصفحة رقم 3

AUTO FAN SPEED COOL C DRY H H FAN OFF ON OFF ON SELECT SET/CANCEL A B TEMP OFF/ON SLEEP FAN SPEED MODE AUTO TIMER AIR SWING RESET CS-A12CTP CU-A12CTP5 / CS-A18CTP CU-A18CTP5 / CS-A24CTP CU-A24CTP5  Setting the Fan Speed  Automatic Operation  Press 4 to select:- • Press the Auto Airflow Direction Button 6. FAN – Low Fan Speed  Cooling / Soft Dry  Setting the Horizontal Airflow Direction FAN – Medium Fan Speed The louver will automatically swing up and down FAN – High Fan Speed to create the

ملخص المحتوى في الصفحة رقم 4

CS-A12CTP CU-A12CTP5 / CS-A18CTP CU-A18CTP5 / CS-A24CTP CU-A24CTP5 HELPFUL INFORMATION ENERGY SAVING AND OPERATION  Pre-season Inspection HINTS  Clean the air filters, re-insert and operate the air  Auto Operation conditioners.  Setting the Temperature  Approximately 10% of electricity can be saved. Press the Auto  Is the discharged air cold / warm?  Set the temperature higher or lower than the Operation is normal if 15 minutes after the start of Operation Button desired temperature. oper