ملخص المحتوى في الصفحة رقم 1
La Crosse Technology®
WS-811561
IT915 MHz
Atomic Digital Clock and Temperature
Station with Wireless Solar-Powered
Outdoor Temperature Sensor
Wireless Weather Instruments by
La Crosse Technology®
La Crosse Technology, Ltd.
www.lacrossetechnology.com
2809 Losey Blvd. S
La Crosse, WI 54601
Phone 608-782-1610
Table of Contents
Table of Contents ....................................................... 1
Inventory of Contents ..........................
ملخص المحتوى في الصفحة رقم 2
Setting the Time Alarm ............................................... 6 Battery Replacement Information ............................... 7 Installation Notes ........................................................ 8 Mounting the Units ...................................................... 9 Online Resources ..................................................... 10 Care and Maintenance ............................................. 10 Troubleshooting .........................................
ملخص المحتوى في الصفحة رقم 3
TX61U-IT Wireless Solar-Powered Outdoor Sensor: • The TX61U-IT sensor sends the collected outdoor temperature to your existing wireless display by way of a 200 Ft wireless signal. • High-efficiency modern solar panel maintains full charge with minimal light • Stores solar power for continuous operation • Batteries are a built-in (non-replaceable) Alkaline power cell • Wall hanging or free standing • Outdoor measurement range: -39.8°F to 139.8°F (-39.9°C to 59.9°C) with 0.1°C reso
ملخص المحتوى في الصفحة رقم 4
automatically. When the battery voltage charges to 2.5V, the LCD will turn on and the transmission of signal will start again. 2. Install Batteries into Wireless Display Insert 2 new "AA", 1.5 volt ALKALINE batteries into the wireless display according to the polarity marked on the battery compartment. Make sure to do this within 2 minutes of performing the start up process for the TX61U-IT. (Diagram on page 3) Once the batteries are properly installed in the wireless display, the
ملخص المحتوى في الصفحة رقم 5
attempted at the full hour between 12:00 am to 6:00 am. For best reception, place the display with the front or back facing Colorado. After a successful reception, no more reception attempt would be made until the following day. If the display is in an area of your home where the WWVB signal cannot be received, you can set the date and time manually. In either case, the Time Zone must be set manually. Note: The "SET" button is used to enter SET mode. The display will exit SET
ملخص المحتوى في الصفحة رقم 6
4. Set Time - Hour: Press the “SET” button a fourth time and the Hours digits will flash. Use the “PLUS“ button to select the correct hour. 5. Set Time - Minute: Press the “SET” button a fifth time and the Minutes digits will flash. Use the “PLUS“ button to select the correct minute. 6. Set Date - Year: Press the “SET” button a sixth time and the Year digits will flash. Use the “PLUS“ button to select the correct year. 7. Set Date - Month: Press the “SET” button a seventh ti
ملخص المحتوى في الصفحة رقم 7
The Minutes digits of the Alarm Time will flash. Use the “PLUS” button to set the minutes. You can hold the "PLUS" button in to speed up the setting of minutes by using five minute increments. Press the "ALARM" button to confirm your minutes setting and to end the setting procedure. 4. To activate or deactivate the daily alarm: Briefly press the “ALARM” button once. When the alarm is active the clock displays the alarm icon below the word "TIME", when the alarm is deactivated, the
ملخص المحتوى في الصفحة رقم 8
Installation Notes Point the TX61U-IT solar panel toward the best available light source to recharge the batteries, but avoid a location in direct sun as it will cause incorrect temperature readings. We recommend facing the solar panel East to catch the early morning sun, and placing under an eave or overhang to avoid overhead sun. The TX61U-IT sensor uses internal rechargeable batteries to store the collected solar power. The sensor features a high-efficiency solar panel that ma
ملخص المحتوى في الصفحة رقم 9
the outdoor temp, this means that the sensor is either located too close or too far from the wireless display. Please adjust the location of the TX61U-IT sensor and try again. If it fails again, please restart the set up procedure (see below). Mounting the Units The TX61U-IT Sensor The sensor can be set on a table or mounted onto a wall using the included screws. Mounting the Sensor with Screws 1. Remove the mounting bracket from the TX61U-IT sensor. 2. Place the mounting
ملخص المحتوى في الصفحة رقم 10
Online Resources Visit the WS-811561 page online at: http://www.lacrossetechnology.com/811561 Care and Maintenance Extreme temperatures, vibration and shock should be avoided as these may cause damage to the unit and give inaccurate readings. Precautions shall be taken when handling the batteries. Injuries, burns, or property damage may be resulted if the batteries are in contact with conducting materials, heat, corrosive materials or explosives. The batteries shall be taken out
ملخص المحتوى في الصفحة رقم 11
• Ensure correct polarity Ensure that the wireless display has fresh batteries and are installed using correct polarity as shown inside the battery compartment (+). Sensor Location: Before permanently fixing the TX61U-IT sensor wall bracket, temporarily place both the sensor and the wireless display in their desired locations, then check that the outdoor temperature reading is being received. In the event that the signal is not received, relocate the TX61U-IT sensor (remembering the
ملخص المحتوى في الصفحة رقم 12
surface; (4) damage resulting from failure to follow instructions contained in your owner’s manual; (5) damage resulting from the performance of repairs or alterations by someone other than an authorized La Crosse Technology, Ltd authorized service center; (6) units used for other than home use (7) applications and uses that this product was not intended or (8) the products inability to receive a signal due to any source of interference.. This warranty covers only actual defects within
