Bernard SPEC NC-1.1 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

™
Q Neck Coupler and Grip
Issued August 2008 • Index No. SPEC NC-1.1
MIG Welding Accessory
The Right Tool for the Job.
To improve comfort and minimize
downtime, we offer a wide variety
of interchangeable necks for greater
flexibility and better weld puddle
visibility.
Neck Coupler
• Part Number: QT-CPL
TM
• Designed to connect any two Q necks
• Provides flexibility and cost savings -
TM
Bernard Q Neck Coupler and
minimizes the need for special order
TM
Q Neck Grip for both fixed and

ملخص المحتوى في الصفحة رقم 2

Neck Coupler Installation Instructions 1. Install rubber insulator from coupler over the end of neck as shown. 2. Install coupler onto end of neck and torque to approximately 12ft-lbs. 3. After coupler is installed onto neck, slide rubber insulator over to cover exposed brass on coupler. 4. Install second neck into coupler and tighten by hand or with a wrench. 5. Install snap-on nut cover over locknut for hand tightened necks, or the rubber boot for wrench tightened necks. Nec