Rane RPM 26z دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

HARDWARE MANUAL RPM 26z
PROGRAMMABLE MULTIPROCESSOR
RPM 26z
PROGRAMMABLE
MULTIPROCESSOR
12 LOCK A B 1 2 3 4 5 6 24
INPUT AES3 OUTPUT PRESET VIP ETHERNET STATUS POWER
QUICK START
This section is intended to help you make the physical connec-
Now click on the Poll button in the toolbar. A device name
tions and software manipulations necessary to get up and run-
and IP address should appear under the Live folder in the
ning with your sleek new RPM 26z. If you don’t read the entire
Project window

ملخص المحتوى في الصفحة رقم 2

Front Panel Description RPM 26z PROGRAMMABLE MULTIPROCESSOR 12 LOCK A B 1 2 3 4 5 6 24 INPUT AES3 OUTPUT PRESET VIP ETHERNET STATUS POWER 1 2 1 3 4 5 6 7 1 Signal/Overload LED meters indicate the presence of significant audio signal or overload for Inputs and Outputs. These 3-color meters indicate the available headroom once the analog signal has been converted to digital: -4 dBFS (red, near clipping), -12 dBFS (yellow, high normal level), and -48 dBFS (green, low level). The analog signal lev

ملخص المحتوى في الصفحة رقم 3

Audio Connections Digital (AES3) Input For each Input or Output Euroblock connector: AES3 is a popular 2-channel (stereo) digital audio interface com- • Connect the (positive) audio line to the ‘+’ terminal. monly found on professional digital audio equipment (digital • Connect the (negative) audio line to the ‘–’ terminal. mixers, DAT machines, etc.). Each channel of the AES3 digital • Connect the cable shield to the ground terminal. stream is treated independently within the RPM 26z. For

ملخص المحتوى في الصفحة رقم 4

Remote Level Control Using Potentiometers VIP CONNECTION The VIP inherently prefers linear taper 10 kΩ potentiometers, (examples for VIP pin 1) which provide a nice audio taper “feel” for the end user. When used with suitable twisted pair wiring, the 10 kΩ value also of - pin 1 REF fers acceptable noise immunity and very long cable lengths. pin 1 20 kΩ (linear) AMX and Crestron Control There are two ways to control a Drag Net device from an AMX GND GND or Crestron system. Use either Ethernet