Inhaltszusammenfassung zur Seite Nr. 1
Start
Here!
Quick Start Guide - next page
DS
815
Digital Spread Spectrum
provides the longest range,
the clearest sound
and the best privacy.
QUICK START
GUIDE
Inhaltszusammenfassung zur Seite Nr. 2
INSTALLATION & SAFETY Choosing the best location for your DS815 When choosing a location for your phone there are a number of appliances the phone should not be near, and areas you should avoid. ! CHOOSE - This symbol indicates a central location important operating and servicing instructions. AVOID - Television sets and AVOID - other electronic Microwave appliances ovens AVOID - Moisture AVOID - Computers AVOID - Other Cordless phones CHARGE - the new phone for 15 - 20 hrs and raise the DON’T -
Inhaltszusammenfassung zur Seite Nr. 3
This page is a very condensed version of the Owners Manual. It is designed to allow you to get your phone installed and operating as quickly as possible - however it does not attempt to explain any of the advanced features of the DS815. Start Here! Quick Start Guide Installing NOTE Use only the Uniden AC the Base Unit Adaptor supplied with Plug the phone jack into the Base Unit, then into the telephone this unit. connector to the wall. Make sure the AC Plug the power cable into the Base Adaptor
Inhaltszusammenfassung zur Seite Nr. 4
ION fire, T860 Installing the Handset Battery Press the battery cover and slide it off. Connect the battery plug to the socket at the rear of the battery compartment. Make sure the plug is the right way round. The RED and BLACK battery wires must match the RED and BLACK printed on the phone case for the plug to fit properly. Press firmly until it clicks into place. Position the battery in the compartment and slide the cover into place. NOTE Place the handset on the base Unit and charge it
Inhaltszusammenfassung zur Seite Nr. 5
CONTENTS i Installation & Safety ii, iii Quick Start Guide 1 Contents Controls & Functions 2, 3 Introduction 4 Welcome 4 Features 4 Included in your Package 4 Battery Maintenance 5 Battery use time (per charge) 5 When the Battery Charge becomes Low 5 Cleaning the Battery Contacts 5 Adjusting the Ringer and Earpiece Volume 6 Installing the Belt Clip 6 Headset Installation 6 Using Your New Phone 7 Making and Receiving Calls 7 Call Transfer 8 Redialling a Call 8 Travelling out of Range 9 Keylock /
Inhaltszusammenfassung zur Seite Nr. 6
* 6 9 # redial/p 1 7 4 CONTROLS & FUNCTIONS 1 28/09 12:30 01 JIM STATEN 02 9597 9035 memory flash/ reg vol talk cid abc def 2 3 ghi jkl mno 5 pqrs tuv wxy 8 tone oper 3 0 options delete/ select page 15 16 17 1 Headset jack 10 Flash/Reg key 2 Belt clip slot 11 CID key 3 Battery compartment 12 Volume control keys 4 Memory key 13 Numeric keypad 5 Talk key 14 Delete/Page key 6 Redial/Pause key 15 Select key 7 Handset aerial 16 Handset Microphone 8 Handset speaker 17 Opti
Inhaltszusammenfassung zur Seite Nr. 7
18 Charging contacts 19 Base unit aerial 20 Status LED 21 Page key 22 Telephone line 23 DC In 9V 24 Registration key 22 23 24 Rear of Base Unit Top of Base Unit 19 18 status 20 page 21 900MHz DIGITAL SPREAD SPECTRUM 3
Inhaltszusammenfassung zur Seite Nr. 8
WELCOME Congratulations on your purchase of the Uniden DS815 cordless telephone. This phone is designed for reliability, long life and outstanding performance utilising the latest in 900 MHz Digital Spread Spectrum Technology. FEATURES l 900MHz Digital Spread Spectrum Technology l Multi-Handset operation l Caller ID Function l 60 Number Caller ID Memories l Backlit Keypad l 3-Line, 16 Character Backlit Handset Display l 32 Digit Redial l 3 Redial Memories l Flash l Pause l 10 Days Standby Batter
Inhaltszusammenfassung zur Seite Nr. 9
BATTERY MAINTENANCE Battery use time (per charge) From fully charged Four and half hours continuous use. NOTE Ten days when the handset is in the standby mode. Use only the genuine A full charge will take at least 12 hours if Low Battery is displayed - however the Uniden Battery supplied phone will be ready for a short call after one hour. with your phone. When the battery charge becomes low Replacement batteries are If the phone is not in use, Low Battery flashes and none of the keys will oper
Inhaltszusammenfassung zur Seite Nr. 10
* 6 9 # redial/p 1 7 4 ADJUSTING THE RINGER AND EARPIECE VOLUME Ringer tone and volume The phone has four ringer tone and volume RINGER A HIGH combinations. In the standby mode, press or on the handset repeatedly. The display shows the setting. Earpiece volume Pressing or during a call will change the TALK LOUD 1 earpiece volume of the handset. The telephone will keep this setting for all calls and display the setting for each call. Loud
Inhaltszusammenfassung zur Seite Nr. 11
* 6 9 # redial/p 1 7 4 MAKING AND RECEIVING CALLS Basic phone operation When Handset When Handset On Base Off Base 28/09 12:30 01 JIM STATEN 02 9597 9035 memory flash vol talk cid talk button 2 abc 3def ghi 5 jkl mno pqrs tuv wxy 8 tone 0oper options select/ delete channel To answer 1. 1. INCOMING CALL INCOMING CALL a call (phone ringing) talk 2. Press 2. Pick up handset. TALK LOUD 1 3. 3. TALK LOUD 1 - - Auto talk answers the call as soon as the handset is picked
Inhaltszusammenfassung zur Seite Nr. 12
CALL TRANSFER During a call, you can transfer the call to another optional handset (maximum 7 handsets). delete/page 1. Press TRANSFER TO NOTE ( 1 7 HAND # (1 - 7) 2. Press [handset No. ] The hanset number is shown on the right side of If the called handset is not the display. answered within 20 talk 3. Press seconds, the call will return 4. Called handset rings and cal is transferred. to the original handset. REDIALLING A CALL The last three phone numbers dialed ca
Inhaltszusammenfassung zur Seite Nr. 13
Redial from talk mode TALK LOUD 1 talk 1. Press NOTE redial/p 2. Press - the last number dialed will be displayed and redialed. Only the last number dialed can be accessed TALK LOUD 1 95979035 after talk has been pressed. TRAVELLING OUT OF RANGE During a call, noise will increase if you move your handset too far from your base unit. If the range limit of your base unit is exceeded, your call will terminate within 30 seconds.
Inhaltszusammenfassung zur Seite Nr. 14
STORING PHONE NUMBERS AND NAMES Memory Dialing allows you to dial a number using just a few key strokes. You can store up to 29 phone numbers in the memory. MEMORY STORE Since each step must be completed within 10 01 EMPTY seconds, it may be advisable to review these instructions before starting. 02 EMPTY memory 1. Press and hold until MEMORY STORE is displayed. STORE NAME 2. Press or or enter a two digit NOTE number (
Inhaltszusammenfassung zur Seite Nr. 15
MAKING CALLS WITH MEMORY DIALLING Memory Dialling from Standby memory 1. Press once, the handset displays 01 FRED your programmed memory locations. 02 JOHN SMITH 2. Press and or enter a two-digit 03 KAY JONES number ( ) to select the memor 0 1 2 9 y location you would like to dial. talk 3. Press - the displayed number is TALK LOUD 1 dialled. 0295979035 Display a Memory Number or Name Use a
Inhaltszusammenfassung zur Seite Nr. 16
EDITING A STORED NAME AND PHONE NUMBER memory 1. Press and hold until MEMORY STORE MEMORY STORE is displayed. 01 FRED 2. Press and or enter a two-digit number 02 JOHN SMITH ( ) to select the memor 0 1 2 9 y location you would like to edit. select 3. Press - the screen displays the EDIT MEMORY 01 memory location number you have selected. DELETE MEMORY 01 4. Press or to select ‘Edit Memo
Inhaltszusammenfassung zur Seite Nr. 17
0 1 2 9
Inhaltszusammenfassung zur Seite Nr. 18
REGISTRATION The original handset supplied with the Main Base is already registered as handset 1, this leaves handset numbers 2 - 7 available. It is very important to allocate each handset a different number to enable functions such as Call Transfer. Registration Process Follow this process for each additional handset (DS805) that needs to be registered to the Main Base If a handset is registered at or for registering your Main Handset. any time as handset 1, all 1. Remove the handset from its
Inhaltszusammenfassung zur Seite Nr. 19
CALLER ID You must subscribe to the Caller ID service from your local telephone company to use these features. When the telephone rings, the Caller ID feature allows you to view the caller’s name NOTE and phone number on the display before you answer the phone. The handset displays the phone number of the incoming call, the name, time and the number of calls. Caller ID information may Additionally, you can dial the displayed number and store the information for memory not be displayed dialing.
Inhaltszusammenfassung zur Seite Nr. 20
Viewing the Caller ID Message List The Caller ID list stores information for up to 60 incoming calls-even unanswered calls. 1. Press - the summar cid y screen is displayed. HANDSET 1 The screen shows the number of new NEW 1 messages and total messages. TOTAL 3 2. Press to display the latest Caller ID message. 3. Press to see the next message, or press 5/11 12:30 PM 01 to see previous message. FRED cid 4. Press a
