Inhaltszusammenfassung zur Seite Nr. 1
Start
Here!
Quick Start Guide next page -
DS
805
Optional Handset
and
Charge Base
Suits models -
DS815
DS825
DS845
DS875
QUICK START
GUIDE
Inhaltszusammenfassung zur Seite Nr. 2
INSTALLATION & SAFETY Choosing the best location for your telephone When choosing a location for your phone there are a number of appliances the phone should not be near, and areas you should avoid. ! CHOOSE - This symbol indicates Raise the Antenna a central location important operating and servicing instructions. AVOID - Television sets and AVOID - other electronic Microwave appliances ovens AVOID - Moisture AVOID - Computers AVOID - Other Cordless phones CHARGE - AVOID - the new phone moistur
Inhaltszusammenfassung zur Seite Nr. 3
ION fire, T860 This page is a very condensed version of the Owners Manual. It is designed to allow you to get your phone installed and operating as quickly as possible - however it does not attempt to explain any of the advanced features of the DS805. Start Here! Quick Start Guide Installing the Charge Base ! The AC Adaptor must remain plugged in and Plug the power cable into the Base switched on at all times. Unit, then into the wall power point. Use only the AC Press the power cable in
Inhaltszusammenfassung zur Seite Nr. 4
Registering your phone This additional Handset is able to be used in conjunction with models DS815, DS825, DS845 and DS875 cordless telephones. The new handset needs to be allocated a handset number and registered to the Main Base (DS815, DS825, DS845 & DS875). The Main Base has a telephone cord plugged into it and also has an Antenna, not to be confused with the additional charger(s). O P P P DS815 Main Base DS825 Main Base DS845 Main Base DS805 Charger The original handset supplied with the M
Inhaltszusammenfassung zur Seite Nr. 5
CONTENTS Installation & Safety i Quick Start Guide ii, iii Contents 1 Introduction 4 Welcome 4 Features 4 Included in your Package 5 Battery Maintenance 6 Preparing the Battery Pack 6 Battery use time (per charge) 6 When the Battery Charge becomes Low 6 Cleaning the Battery Contacts 6 Adjusting the Ringer and Earpiece Volume 7 Installing the Belt Clip 7 Headset Installation 7 Using Your New Phone 8 Making and Receiving Calls 8 Call Transfer 9 Redialling a Call 9 Travelling out of Range 10 Keyloc
Inhaltszusammenfassung zur Seite Nr. 6
* 6 9 # redial/p 1 7 4 CONTROLS & FUNCTIONS ! The DS805 is an optional handset and charger. It can only be used in 1 conjunction with a compatible telephone such as the DS815, 28/09 12:30 01 JIM STATEN DS825, DS845 and 02 9597 9035 DS875. memory flash/ reg vol talk cid def abc 2 3 ghi jkl mno 5 pqrs tuv wxy 8 oper tone 0 3 delete/ options select page 15 17 16 1 Headset jack 10 Flash/Reg key 2 Belt clip slot 11 CID key 3 Battery compartment 12 Volume control keys 4 Memory key
Inhaltszusammenfassung zur Seite Nr. 7
Charge Base 18 Charging contacts 19 Charge LED 20 Non functional key 21 AC power adaptor input 21 Rear Top 18 charge 19 20 900MHz DIGITAL SPREAD SPECTRUM 3
Inhaltszusammenfassung zur Seite Nr. 8
WELCOME Congratulations on your purchase of the Uniden DS805 extra handset. This phone is designed for reliability, long life and outstanding performance utilising the latest in 900MHz Digital Spread Technology. The DS805 is an optional handset and charger. It can only be used in conjunction with a compatible telephone such as the DS815, DS825, DS845 and DS875. FEATURES l 900MHz Digital Spread Spectrum Technology l Caller ID Function l 60 Number Caller ID Memories l Backlit Keypad l 3-Line, 16
Inhaltszusammenfassung zur Seite Nr. 9
* 6 9 # redial/p 1 7 4 INCLUDED IN YOUR PACKAGE TIP To get the most from your phone, please read this memory flash vol Owner’s Manual thoroughly. talk cid charge 2abc 3def Be sure to complete and mail ghi mno 5jkl the product consumer support pqrs tuv wxy 8 tone 0oper card. DIGITAL SPREAD SPECTRUM options select/ delete channel Handset Charge Base NOTE If any of these items are missing or damaged, contact your place of purchase. Rechargeable Battery AC Adaptor ! Refer to the CONTROLS & FUNCTIONS
Inhaltszusammenfassung zur Seite Nr. 10
BATTERY MAINTENANCE Battery use time (per charge) From fully charged Four and half hours continuous use. NOTE Ten days when the handset is in the standby mode. Use only the genuine A full charge will take at least 12 hours if ‘Battery Low’ is displayed - however the Uniden Battery supplied phone will be ready for a short call after one hour. with your phone. When the battery charge becomes low Replacement batteries are If the phone is not in use, “ Low Battery” flashes and none of the keys will
Inhaltszusammenfassung zur Seite Nr. 11
* 6 9 # redial/p 1 7 4 ADJUSTING THE RINGER AND EARPIECE VOLUME Ringer tone and volume The phone has four ringer tone and volume RINGER A HIGH combinations. In the standby mode, press or on the handset repeatedly. The display shows the setting. Earpiece volume TALK LOUD 1 Pressing or during a call will change the earpiece volume of the handset. The telephone will keep this setting for all calls and display the setting for each call. Loud H
Inhaltszusammenfassung zur Seite Nr. 12
* 6 9 # redial/p 1 7 4 MAKING AND RECEIVING CALLS Up to 7 Handsets may be registered to any one compatible Telephone Base such as the DS815, DS825, DS845 and DS875. One handset can talk to an outside line, while at the same time two other handsets may have an internal call with each other using the Page feature (see page 13). Basic phone operation When Handset When Handset On Base Off Base memory flash vol talk talk cid button 2 abc 3def ghi 5 jkl mno pqrs tuv wxy 8 tone 0oper options sel
Inhaltszusammenfassung zur Seite Nr. 13
CALL TRANSFER During a call, you can transfer the call to another optional handset (maximum 7 handsets). delete/page 1. Press NOTE ( 2. Press [handset No. 1 7 ] TRANSFER TO The handset number is shown on the HAND # (1 - 7) If the called handset is not right side of the display. answered within 20 talk 3. Press seconds, the call will return 4. Called handset rings. to the original handset. talk 5. Press on the called handset and Call REDIALLING A CALL NO
Inhaltszusammenfassung zur Seite Nr. 14
CALL WAITING/FLASH If the Call Waiting tone sounds during a call - Australia: Press , then to s flash/reg witch between callers. 2 New Zealand: Press to switch between callers. flash/reg TRAVELLING OUT OF RANGE During a call, noise will increase if you move your handset too far from your base unit. If the range limit of your base unit is exceeded, your call will terminate within 30 seconds. KEY LOCK / UNLOCK KEY LOCKED When the handset is in t
Inhaltszusammenfassung zur Seite Nr. 15
STORING PHONE NUMBERS AND NAMES Memory Dialling allows you to dial a number using just a few key strokes. You can store up to 29 phone numbers in the memory. MEMORY STORE 1. Press and hold until memory MEMORY Store is displayed. 01 EMPTY 02 EMPTY 2. Press or or enter a two-digit number to select the ( 0 1 2 9 memory location where you would like to STORE NAME store the number. select NOTE 3. Press
Inhaltszusammenfassung zur Seite Nr. 16
MAKING CALLS WITH MEMORY DIALING Memory Dialing from Standby memory 1. Press once, the handset displays 01 FRED your programmed memory locations. 02 JOHN SMITH 2. Press and or enter a two-digit 03 KAY JONES ( number to select the 0 1 2 9 memory location you would like to dial. talk 3. Press - the displayed number is TALK LOUD 1 dialled. 0295979035 Display a Memory Number or Name Use and
Inhaltszusammenfassung zur Seite Nr. 17
EDITING A STORED NAME AND PHONE NUMBER memory 1. Press and hold until MEMORY STORE MEMORY STORE is displayed. 01 FRED 2. Press and or enter a two-digit number 02 JOHN SMITH ( 0 1 to select the memor 2 9 y location you would like to edit. select 3. Press - the screen displays the EDIT MEMORY 01 memory location number you have selected. DELETE MEMORY 01 4. Press or to select ‘Edit Memo
Inhaltszusammenfassung zur Seite Nr. 18
ERASING A STORED NAME AND PHONE NUMBER memory 1. Press and hold until MEMORY MEMORY STORE STORE is displayed. 01 FRED 2. Press and or enter a two-digit 02 JOHN SMITH ( 0 number to select the 1 2 9 memory location you would like to edit. 3. Press - select the memory location EDIT MEMORY 02 number that you have selected is displayed. DELETE MEMORY 02 GO BACK EDIT MEMORY 02 4. Press to mov
Inhaltszusammenfassung zur Seite Nr. 19
CALLER ID You must subscribe to the Caller ID service from your local telephone company to use these features. When the telephone rings, the Caller ID feature allows you to view the caller’s name NOTE and phone number on the display before you answer the phone. The handset displays the phone number of the incoming call, the name, time and the number of calls. Caller ID information Additionally, you can dial the displayed number and store the information for memory may not be displayed until dia
Inhaltszusammenfassung zur Seite Nr. 20
Viewing the Caller ID Message List The Caller ID list stores information for up to 60 incoming calls-even unanswered calls. 1. Press - the summar cid y screen is displayed. HANDSET 1 The screen shows the number of new NEW 1 messages and total messages. TOTAL 3 2. Press to display the latest Caller ID message. 3. Press to see the next message, or press 5/11 12:30 PM 01 to see previous message. FRED cid 4. Press a
