Inhaltszusammenfassung zur Seite Nr. 1
640SEcdqs.book Page 1 Tuesday, December 5, 2000 4:46 PM
Inhaltszusammenfassung zur Seite Nr. 2
640SEcdqs.book Page 2 Tuesday, December 5, 2000 4:46 PM Contents Inhalt Table des matières 1 - - - - - English 27 - - - - Français 53 - - - - Deutsch
Inhaltszusammenfassung zur Seite Nr. 3
640SEcdqs.book Page 1 Tuesday, December 5, 2000 4:46 PM English Welcome to Polaroid Fun Your Polaroid Fun Flash 640 SE Digital Camera kit contains everything you need to take digital photos, save them to your computer, and manipulate them. Using the software in your kit, you can correct, edit, and play with your digital photos. You can also use Polaroid PhotoImpression 2000 Software with other TWAIN-compliant digital cameras and scanners. Your kit contains the following: • Polaroid Fun Fl
Inhaltszusammenfassung zur Seite Nr. 4
640SEcdqs.book Page 2 Tuesday, December 5, 2000 4:46 PM English Camera features ab c d f e a. Viewfinder b. Flash unit c. Lens d. Serial/USB cable connector port e. Tripod mount f. Battery compartment 2 Questions? Contact Polaroid Corporation at www.polaroiddigitalEU.com
Inhaltszusammenfassung zur Seite Nr. 5
640SEcdqs.book Page 3 Tuesday, December 5, 2000 4:46 PM English h i jklmn o g p g. LCD status display h. Power/status indicator light i. Flash indicator light j. Viewfinder k. Power button l. Flash button m.Self-timer button n. Shutter button o. Wrist strap slot p. Battery compartment Questions? Contact Polaroid Corporation at www.polaroiddigitalEU.com 3
Inhaltszusammenfassung zur Seite Nr. 6
640SEcdqs.book Page 4 Tuesday, December 5, 2000 4:46 PM English Inserting batteries Your kit includes four AAA batteries. 1. Open the battery door. 2. Insert four AAA batteries. Make sure that the battery terminals (+ and -) are properly positioned. 3. Close the battery door. Note: Replace the batteries when the power/status indicator light blinks, the LCD status display shows the battery-low message (bL), or the LCD status display does not turn on. Note: Replace all four batteries a
Inhaltszusammenfassung zur Seite Nr. 7
640SEcdqs.book Page 5 Tuesday, December 5, 2000 4:46 PM English Taking photos 1. Turn on the camera (a). The green power/ status light (b) on the back of the camera bc a is lit. If the green power/status light is not lit, check to make sure the batteries are properly loaded and do not need replacing. 2. Frame your subject(s) in the viewfinder (c). 3. Hold the camera steady; press and hold d the shutter button (d) until the camera beeps. The camera increases the picture counter in the LC
Inhaltszusammenfassung zur Seite Nr. 8
640SEcdqs.book Page 6 Tuesday, December 5, 2000 4:46 PM English Using sleep mode To save battery power, your digital camera b d c automatically shuts off after 45 seconds of inactivity. In this sleep mode, the LCD status display (a) turns off, the power/status indicator light (b) displays green, and the camera beeps every ten seconds. Press the power button (d) once to bring a the camera out of sleep mode. The LCD status display (a) turns on; the power/ status indicator light (b) displ
Inhaltszusammenfassung zur Seite Nr. 9
640SEcdqs.book Page 7 Tuesday, December 5, 2000 4:46 PM English Using the picture counter The picture counter is found on the LCD status display. The camera comes with 2 MB of internal memory, which typically stores 30 photos (640 x 480 pixel resolution). The number of photos that the camera actually stores depends on the complexity of the photos. 1. Turn on the camera (a). ab 2. Press the shutter button (b). The camera beeps and increases the picture counter in the LCD status display (
Inhaltszusammenfassung zur Seite Nr. 10
640SEcdqs.book Page 8 Tuesday, December 5, 2000 4:46 PM English Using the flash When you turn on your digital camera, it is in the No Flash (nF) mode. You can change the flash setting at any time. Note: If the batteries are very weak when you turn on the camera, the flash does not charge. The camera indicates when you may need to use the flash by displaying the Low Lighting message (LL) in the LCD status display. There are three flash settings: LCD icon Flash setting nF No Flash (flash of
Inhaltszusammenfassung zur Seite Nr. 11
640SEcdqs.book Page 9 Tuesday, December 5, 2000 4:46 PM English Changing the flash setting 1. Turn on the camera (a); it is in No d a c Flash (nF) mode. 2. Press the flash setting button (c) to change the setting. The LCD status display (b) shows the new setting. 3. If you turn on the Autoflash (AF) or Force Flash (FF) setting, the flash b charges for a few seconds. The flash indicator (d) lights yellow when the flash is charged and ready to take a photo. If the flash takes longer than
Inhaltszusammenfassung zur Seite Nr. 12
640SEcdqs.book Page 10 Tuesday, December 5, 2000 4:46 PM English Using the self-timer 1. Turn on the camera (a). 2. Set the camera into position to take a photo. 3. Look through the viewfinder (b) to bc a compose the photo. 4. Press the self-timer button (c). The camera beeps for 15 seconds, the beep speeds up and then stops just before the camera takes the photo. Note: You do not need to press the shutter button to take a self- timed photo. 10 Questions? Contact Pola
Inhaltszusammenfassung zur Seite Nr. 13
640SEcdqs.book Page 11 Tuesday, December 5, 2000 4:46 PM English Deleting photos You must delete photos from your camera or transfer photos to your computer when the camera’s memory is full. The memory is full when the picture counter does not increase after you take a photo (usually after you take 30 photos). See page 12 to learn how to transfer photos to your computer and page 17 to learn how to delete photos from the camera using the PhotoImpression 2000 software. Questions? Contact P
Inhaltszusammenfassung zur Seite Nr. 14
640SEcdqs.book Page 12 Tuesday, December 5, 2000 4:46 PM English Transferring photos to your computer To transfer your digital photos to your computer, first install the Polaroid PhotoImpression 2000 Software included in your kit. This software includes many fun and interesting features: • One-click fix technology that instantly improves any digital image. • A wide selection of digital special effects such as melting and swirling. • PhotoFantasy, which lets you put someone’s image inside on
Inhaltszusammenfassung zur Seite Nr. 15
640SEcdqs.book Page 13 Tuesday, December 5, 2000 4:46 PM English Installing PhotoImpression 2000 Software 1. Insert the PhotoImpression CD-ROM in your CD-ROM drive. If the installation program does not start automatically: a. Select Run from the Windows Start menu. b. Click Browse to locate your CD-ROM drive. c. Select Setup.exe from the CD-ROM. d. Click Open. e. Click OK. 2. Follow the instructions on your computer screen. 3. Click Finish to complete software installation. Note: Read the Re
Inhaltszusammenfassung zur Seite Nr. 16
640SEcdqs.book Page 14 Tuesday, December 5, 2000 4:46 PM English Connecting the digital camera to your computer 1. Turn off the camera, computer, and any peripheral devices. Note: You do not need to turn off a Windows 98 or Windows Me computer to connect the camera to its USB port. 2. Locate the serial/USB connector cable from your kit. Note: The serial/USB connector cable is actually two different cables in one, with one end split into two connectors. This allows you to choose to c
Inhaltszusammenfassung zur Seite Nr. 17
640SEcdqs.book Page 15 Tuesday, December 5, 2000 4:46 PM English 3. Connect the serial head of the cable (a) to the serial port on your Windows 95, Windows 98, or Windows Me computer. Or connect the USB head of the cable (b) to the USB port on your Windows 98 or Windows Me computer. c a b Note: If the connection between the USB head and the computer USB port is not tight, the USB head may eventually pull out of the port. Check that the USB head is fully plugged in every time you transfer
Inhaltszusammenfassung zur Seite Nr. 18
640SEcdqs.book Page 16 Tuesday, December 5, 2000 4:46 PM English 5. Turn on the camera. 6. Turn on the computer. Note: The computer can remain on when you plug the serial/USB connector cable into the computer’s USB port. 7. From the Start menu, select Programs\Polaroid\PhotoImpression 2000. The software launches. 16 Questions? Contact Polaroid Corporation at www.polaroiddigitalEU.com
Inhaltszusammenfassung zur Seite Nr. 19
640SEcdqs.book Page 17 Tuesday, December 5, 2000 4:46 PM English Transferring photos to your computer 1. Click Get Photo. Get Photo The Get Photo button lets you select an image from a variety of sources: Selection: Click on it to: Album Open an image file from a PhotoImpression 2000 album From File Open a recently used image or any image file on your computer Camera/Scanner Transfer a photo from your camera, scanner, or other TWAIN- compatible device Create New Create a new image file Scree
Inhaltszusammenfassung zur Seite Nr. 20
640SEcdqs.book Page 18 Tuesday, December 5, 2000 4:46 PM English 2. Click Camera/Scanner. The Select Source list appears. Acquire button Select Source list Camera/Scanner button 3. Select Polaroid Fun Flash 640 SE Camera. 4. Choose the destination album for your photos from the Select Album list. Note: To create a new album, select [New] and use the album named New Album1 or enter a different album name. 5. Click the Acquire button. The digital camera TWAIN software window opens. TWAIN s
