Inhaltszusammenfassung zur Seite Nr. 1
INSTRUCTION MANUAL
G GU UIID DE E F FO OR R U US SIIN NG G T TH HE E D DIIS SH HW WA AS SH HE ER R A AN ND D T TH HE E W WA AS SH HIIN NG G P PR RO OG GR RA AM MS S
Inhaltszusammenfassung zur Seite Nr. 2
Contents 1. Safety and operating instructions ___________________________ 2 2. Installation and hook-up___________________________________ 5 3. Description of the controls _________________________________ 9 4. Operating instructions ___________________________________ 15 5. Cleaning and maintenance _______________________________ 26 6. Troubleshooting ________________________________________ 30 Thank you for choosing one of our products. You are advised to read this
Inhaltszusammenfassung zur Seite Nr. 3
Safety instructions 1. Safety and operating instructions THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLIANCE: IT MUST ALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER. BEFORE USING THE APPLIANCE, CAREFULLY READ ALL THE INSTRUCTIONS CONTAINED IN THIS MANUAL. INSTALLATION MUST BE PERFORMED BY A QUALIFIED TECHNICIAN, IN COMPLIANCE WITH THE REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTIC USE, AND COMPLIES WITH THE EEC DIRECTIVES 73/23, 89/336 (INCLUDING 92/31
Inhaltszusammenfassung zur Seite Nr. 4
Safety instructions OBSOLETE APPLIANCES MUST BE RENDERED UNUSABLE. CUT OFF THE MAINS POWER CORD AFTER UNPLUGGING IT FROM THE WALL OUTLET, AND MAKE SAFE ANY COMPONENTS WHICH MIGHT BE DANGEROUS FOR CHILDREN (LOCKS, DOORS, ETC.). THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE 2002/96/EC ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE). BY ENSURING THIS PRODUCT IS DISPOSED OF CORRECTLY, YOU WILL HELP PREVENT POTENTIAL NEGATIVE CONSEQUENCES FOR THE ENVIRONMEN
Inhaltszusammenfassung zur Seite Nr. 5
Safety instructions LEANING OR SITTING ON THE DISHWASHER DOOR WHEN OPEN MAY CAUSE THE APPLIANCE TO OVERTURN, PUTING PEOPLE AT RISK. NEVER LEAVE THE DISHWASHER DOOR OPEN; PEOPLE MIGHT TRIP OVER IT. DO NOT DRINK THE WATER RESIDUES WHICH MAY BE PRESENT INSIDE THE DISHES OR DISHWASHER AT THE END OF THE WASHING PROGRAM AND BEFORE THE DRYING CYCLE. KNIVES OR OTHER SHARP-ENDED COOKING UTENSILS MUST BE PLACED IN THE CUTLERY BASKET BLADE-DOWN, OR LAID HORIZONTAL IN THE TOP BASKE
Inhaltszusammenfassung zur Seite Nr. 6
Installation instructions 2. Installation and hook-up Remove the polystyrene basket retainers. Position the appliance in the desired place of installation. The back or sides of the dishwasher may be placed up against walls or other furniture units. If the dishwasher is installed near a heat source, fit the special insulating panel to prevent overheating and malfunction of the appliance. To ensure stability, install integrated or built-under dishwashers only under co
Inhaltszusammenfassung zur Seite Nr. 7
Installation instructions CONNECTING TO THE WATER SUPPLY Connect the intake hose to a cold water supply with ¾” gas thread, inserting the filter A supplied with the dishwasher. Take care to screw the hose firmly into place with your hands and then complete by tightening about ¼ of a turn with pliers. In dishwashers equipped with the ACQUASTOP device, the filters is already fitted inside the threaded ring. The dishwasher can also be connected to a hot
Inhaltszusammenfassung zur Seite Nr. 8
Installation instructions 2.2 Electrical connection and precautions CHECK THAT THE VOLTAGE AND THE FREQUENCY OF THE MAINS MATCH THE RATINGS ON THE NAME PLATE OF THE APPLIANCE POSITIONED ON THE INNER EDGE OF THE DOOR. THE PLUG ON THE SUPPLY CORD AND THE CORRESPONDING SOCKET OUTLET MUST BE OF THE SAME TYPE AND MEET THE REGULATIONS IN FORCE. THE PLUG MUST BE ACCESSIBLE AFTER INSTALLATION. NEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY LEAD. IN THE EV
Inhaltszusammenfassung zur Seite Nr. 9
Installation instructions FOR GREAT BRITAIN ONLY: THIS APPLIANCE MUST BE EARTHED. Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse to BS 1362 type and proceed as follows: 1. Remove the fuse cover A and fuse B. 2. Fit replacement 13A fuse into fuse cover. 3. Refit both into plug. The fuse cover must
Inhaltszusammenfassung zur Seite Nr. 10
User instructions 3. Description of the controls 3.1 Front panel All the dishwasher control are grouped on the front panel. Programming and option selection are only possible with the door closed. 1 ON/OFF BUTTON 2 ON/OFF LIGHT 3 START/PAUSE BUTTON 4 START/PAUSE LIGHT 5 ½ LOAD WASH LIGHT 6 RECESSED DOOR HANDLE On the pages which follow the operating status of the indicator lights will appear as follows: Light off Light on Light flashing 9
Inhaltszusammenfassung zur Seite Nr. 11
User instructions PROGRAMS TABLE DURATION CONSUMPTION PROGRESS PROGRAM SELECTION TYPE AND GRADE DIRT PROGRAM MINUTES WATER POWER (2) LITRES (1) KWh (2) PANS AND DISHES IN WAITING OF SOAK Cold prewash 15 6 0,03 COMPLETING THE LOAD Wash at 45°C DELICATE DISHES Cold rinse LIGHT 70 15 1,15 WITH LIGHT DIRT Rinse at 70°C Dry Cold prewash BIO PANS AND DISHES DIRTY Wash at 50°C 180 ** ** (*) AND WITH DRY RESIDUALS Rinse at 64°C Dry Co
Inhaltszusammenfassung zur Seite Nr. 12
User instructions 3.2 Washing programs The dishwasher is equipped with a control panel, described in chapter "3. Description of the controls", from which it is possible to carry out all the power switch-on, switch-off and programming operations. Before starting a washing program make sure that: • The water supply tap is open. • The correct amount of detergent has been added to the dispenser. • The baskets have been correctly loaded. • The spray arms are able
Inhaltszusammenfassung zur Seite Nr. 13
User instructions PROGRAMMING All programming operations are only possible with the door closed. To select a new program, the dishwasher must be in the "Program start" state described above. Turn the PROGRAM SELECTOR (5) to the program of your choice (see "PROGRAMS TABLE"). START PROGRAM Press the START/PAUSE button (3) for a few seconds, until the START/PAUSE light (4) starts to flash. A beep confirms the operation. PROGRAM SEQUENCE For the entire duration
Inhaltszusammenfassung zur Seite Nr. 14
User instructions TO CHANGE A PROGRAM To change the running program it is necessary: • to interrupt the running program (see “INTERRUPTION OF A PROGRAM”); • select the new program; • to press again the START/PAUSE button (3) to make start the new program. ANNULLING A PROGRAM To annul the program in progress, it must first be interrupted (see “INTERRUPTION OF A PROGRAM”). Turn the PROGRAM SELECTOR (5) to any point on the "empty" sector (with no
Inhaltszusammenfassung zur Seite Nr. 15
User instructions TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT • Always try to run the dishwasher fully loaded. • Do not wash the dishes in running water. • Use the washing program that is most appropriate for each type of load. • Do not carry out any preliminary rinsing. • If available, connect the dishwasher to a hot water supply up to 60°C. TO CUT DOWN ON DETERGENT CONSUMPTION! … AND PROTECT THE ENVIRONMENT The phosphates contained in dishwasher de
Inhaltszusammenfassung zur Seite Nr. 16
User instructions 4. Operating instructions Once the dishwasher has been correctly installed, prepare for use as follows: • Adjust the water softening system; • Add the regenerating salt; • Add the rinse aid and detergent. 4.1 Using the water softening system The amount of scale contained in the water (water hardness index) can cause whitish staining on the dry dishes, which tend to become dull over time. The dishwasher is equipped with
Inhaltszusammenfassung zur Seite Nr. 17
User instructions • Do not use table salt as it contains insoluble substances which, over time, may damage the water softening system. • When necessary, refill the regenerating salt container before starting the washing program. In this way, the excess saline solution will be immediately removed by the water; the prolonged presence of salt water inside the tank may lead to corrosion. Be careful not to confuse the salt and detergent packages; adding detergen
Inhaltszusammenfassung zur Seite Nr. 18
User instructions WATER HARDNESS TABLE WATER HARDNESS SETTING German Degrees (°dH) French Degrees (°dF) 0 - 4 0 - 7 Setting N. 1 NO SALT 5 - 15 8 - 25 Setting N. 1 16 - 23 26 - 40 Setting N. 2 24 - 31 41 - 60 Setting N. 3 32 - 47 61 - 80 Setting N. 4 48 - 58 81 - 100 Setting N. 5 Contact your local water board for information on the hardness of your water supply. 4.2 Using the rinse aid and detergent dispensers The detergent and rinse aid dispense
Inhaltszusammenfassung zur Seite Nr. 19
User instructions ADDING THE RINSE AID The rinse aid helps the dishes dry faster and prevents the formation of scale deposits and staining; it is automatically added to the water during the final rinse cycle, from the container situated on the inner side of the door. To add rinse aid: • Open the door. • Rotate the container cap anticlockwise by ¼ of a turn and remove it. • Add the rinse aid until the container is full (approximately 140 cc). The optical level ind
Inhaltszusammenfassung zur Seite Nr. 20
User instructions ADDING THE DETERGENT To open the detergent dispenser cap, lightly press the button P. Add the detergent and close the cap carefully. During the washing cycle, the dispenser will be opened automatically. • When a program with hot prewash is selected (see program table), extra detergent must be placed in the cavity G/H (depending on models). • Use only detergents specially formulated for dishwashers. For optimal washing resu
