Inhaltszusammenfassung zur Seite Nr. 1
INSTRUCTION MANUAL
GUIDE FOR USING THE DISHWASHER AND THE WASHING PROGRAMS
Inhaltszusammenfassung zur Seite Nr. 2
Contents 1. Safety and operating instructions ___________________________ 2 2. Installation and hook-up___________________________________ 5 3. Description of the controls _________________________________ 9 4. Operating instructions ___________________________________ 18 5. Cleaning and maintenance _______________________________ 28 6. Troubleshooting ________________________________________ 32 Thank you for choosing one of our products. You are advised to read this
Inhaltszusammenfassung zur Seite Nr. 3
Safety instructions 1. Safety and operating instructions THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLIANCE: IT MUST ALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER. BEFORE USING THE APPLIANCE, CAREFULLY READ ALL THE INSTRUCTIONS CONTAINED IN THIS MANUAL. INSTALLATION MUST BE PERFORMED BY A QUALIFIED TECHNICIAN, IN COMPLIANCE WITH THE REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTIC USE, AND COMPLIES WITH THE EEC DIRECTIVES 73/23, 89/336 (INCLUDING 92/31
Inhaltszusammenfassung zur Seite Nr. 4
Safety instructions OBSOLETE APPLIANCES MUST BE RENDERED UNUSABLE. CUT OFF THE MAINS POWER CORD AFTER UNPLUGGING IT FROM THE WALL OUTLET, AND MAKE SAFE ANY COMPONENTS WHICH MIGHT BE DANGEROUS FOR CHILDREN (LOCKS, DOORS, ETC.). THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE 2002/96/EC ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE). BY ENSURING THIS PRODUCT IS DISPOSED OF CORRECTLY, YOU WILL HELP PREVENT POTENTIAL NEGATIVE CONSEQUENCES FOR THE ENVIRONMEN
Inhaltszusammenfassung zur Seite Nr. 5
Safety instructions LEANING OR SITTING ON THE DISHWASHER DOOR WHEN OPEN MAY CAUSE THE APPLIANCE TO OVERTURN, PUTING PEOPLE AT RISK. NEVER LEAVE THE DISHWASHER DOOR OPEN; PEOPLE MIGHT TRIP OVER IT. DO NOT DRINK THE WATER RESIDUES WHICH MAY BE PRESENT INSIDE THE DISHES OR DISHWASHER AT THE END OF THE WASHING PROGRAM AND BEFORE THE DRYING CYCLE. KNIVES OR OTHER SHARP-ENDED COOKING UTENSILS MUST BE PLACED IN THE CUTLERY BASKET BLADE-DOWN, OR LAID HORIZONTAL IN THE TOP BASKE
Inhaltszusammenfassung zur Seite Nr. 6
Installation instructions 2. Installation and hook-up Remove the polystyrene basket retainers. Position the appliance in the desired place of installation. The back or sides of the dishwasher may be placed up against walls or other furniture units. If the dishwasher is installed near a heat source, fit the special insulating panel to prevent overheating and malfunction of the appliance. To ensure stability, install integrated or built-under dishwashers only under co
Inhaltszusammenfassung zur Seite Nr. 7
Installation instructions 2.1 Water supply connection Preventing the risk of clogging or damage: if the water pipe is new or has not been used for a long time, before connecting to the water supply check that the water is clear and free of impurities, to prevent damage to the appliance. The dishwasher must always be connected to the water system with new hoses; old or used hoses must never be reused. CONNECTING TO THE WATER SUPPLY Connect the intake hose
Inhaltszusammenfassung zur Seite Nr. 8
Installation instructions 2.2 Electrical connection and precautions CHECK THAT THE VOLTAGE AND THE FREQUENCY OF THE MAINS MATCH THE RATINGS ON THE NAME PLATE OF THE APPLIANCE POSITIONED ON THE INNER EDGE OF THE DOOR. THE PLUG ON THE SUPPLY CORD AND THE CORRESPONDING SOCKET OUTLET MUST BE OF THE SAME TYPE AND MEET THE REGULATIONS IN FORCE. THE PLUG MUST BE ACCESSIBLE AFTER INSTALLATION. NEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY LEAD. I
Inhaltszusammenfassung zur Seite Nr. 9
Installation instructions FOR GREAT BRITAIN ONLY: THIS APPLIANCE MUST BE EARTHED. Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse to BS 1362 type and proceed as follows: 1. Remove the fuse cover A and fuse B. 2. Fit replacement 13A fuse into fuse cover. 3. Refit both into plug. The fuse cover must be refitted when changing a fuse a
Inhaltszusammenfassung zur Seite Nr. 10
User instructions 3. Description of the controls 3.1 Front panel All the dishwasher control are grouped on the front panel. 1 ON/OFF BUTTON 2 SELECTION PROGRAMS BUTTONS (P1...P5) 3 DELAY PROGRAM BUTTON (on some models only) 4 START/PAUSE BUTTON 5 POWER ON LIGHT 6 PROGRAMS LIGHTS 7 DELAY PROGRAM LIGHTS (on some models only) 8 PHASES/PROGRAM LIGHTS 9 NO SALT LIGHT (on some models only) 10 NO RINSE AID LIGHT (on some models only) 11 RECESSED DOOR HANDLE
Inhaltszusammenfassung zur Seite Nr. 11
User instructions DURATION CONSUMPTION PROGRESS PROGRAM SELECTION TYPE AND GRADE DIRT MINUTES WATER POWER PROGRAM (2) LITRES (1) KWh (2) PANS AND DISHES SOAK AWAITING COMPLETION OF Cold prewash 9’ 5 0,02 THE LOAD Wash at 38°C DELICATE DISHES WITH DELICATE Cold rinse 45 13 0,70 NORMAL DIRT Rinse at 58°C Wash at 55°C DISHES WITH NORMAL ECO (*) Cold rinse DIRT, WASHED 175’ ** ** EN 50242 Rinse at 66°C IMMEDIATELY AFTER USE Dry FAST Wash a
Inhaltszusammenfassung zur Seite Nr. 12
User instructions DURATION CONSUMPTION PROGRESS PROGRAM SELECTION TYPE AND GRADE DIRT PROGRAM MINUTES WATER POWER (2) LITRES (1) KWh (2) Cold prewash Wash at 45°C + DELICATE DISHES WITH DELICATE Cold rinse 59’ 12 0,90 NORMAL DIRT Rinse at 70°C Dry Cold prewash Wash at 55°C DISHES WITH NORMAL + DIRT, EVEN WITH DRIED-ON BIO Cold rinse 85’ 16 1,10 RESIDUES Rinse at 70°C Dry Cold prewash Wash at 65°C DISHES WITH NORMAL +
Inhaltszusammenfassung zur Seite Nr. 13
User instructions 3.2 Washing programs The dishwasher is equipped with a control panel, described in chapter "3. Description of the controls", from which it is possible to carry out all the power switch-on, switch-off and programming operations. Before starting a washing program make sure that: • The water supply tap is open. • The correct amount of detergent has been added to the dispenser. • The baskets have been correctly loaded. • The spray arms are able
Inhaltszusammenfassung zur Seite Nr. 14
User instructions SELECTION PROGRAM The program selection is possible through the relative buttons (2). When the button relating to the program required is pressed, the relative light will come on to confirm the operation. To run the last four programs in the table, first select the “main” program (P2, P3, P4, P5) and then the soak program P1. START PROGRAM To start the dishwasher, press the START/PAUSE button (4) for a few seconds, until the light of the fir
Inhaltszusammenfassung zur Seite Nr. 15
User instructions END PROGRAM When the program finishes, a buzzer sounds briefly and all the PHASES/PROGRAM lights (8) flash. Press any of the SELECTION PROGRAMS buttons (2), stops the light flashins, and the dishwasher is now ready to perform a new cycle; opening and shutting the door or switching the appliance off and on has the same effect. INTERRUPTION OF A PROGRAM In order to interrupt a running program it is necessary: • press the START
Inhaltszusammenfassung zur Seite Nr. 16
User instructions ANNULLING A PROGRAM To annul the program in progress, it must first be interrupted (see “INTERRUPTION OF A PROGRAM”). Now press buttons P1+P2 simultaneously and the first three program lights will come on. In case that the door is opened during the operation, to the next door closing it is going to be necessary to start the program as shown in paragraph “START PROGRAM”. The program will resume from the point in which it was interrupte
Inhaltszusammenfassung zur Seite Nr. 17
User instructions To reset or change the delay once the program has started: • press the START/PAUSE button (4) for a few seconds, until the PHASES/PROGRAM lights (8) come on; • press the DELAY PROGRAM button (3) several times “until the program delay” returns to zero (all the lights indicating the delay go out); • press the START/PAUSE button (4) to start the new program. To set the delay once the program has started, proceed as follows. If the program yo
Inhaltszusammenfassung zur Seite Nr. 18
User instructions TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT • Always try to run the dishwasher fully loaded. • Do not wash the dishes in running water. • Use the washing program that is most appropriate for each type of load. • Do not carry out any preliminary rinsing. • If available, connect the dishwasher to a hot water supply up to 60°C. • When possible, skip the drying cycle by leaving the door open when the washing cycle is complete; the air and the
Inhaltszusammenfassung zur Seite Nr. 19
User instructions 4. Operating instructions Once the dishwasher has been correctly installed, prepare for use as follows: • Adjust the water softening system; • Add the regenerating salt; • Add the rinse aid and detergent. 4.1 Using the water softening system The amount of scale contained in the water (water hardness index) can cause whitish staining on the dry dishes, which tend to become dull over time. The dishwasher is equipped with a
Inhaltszusammenfassung zur Seite Nr. 20
User instructions • Do not use table salt as it contains insoluble substances which, over time, may damage the water softening system. • When necessary, refill the regenerating salt container before starting the washing program. In this way, the excess saline solution will be immediately removed by the water; the prolonged presence of salt water inside the tank may lead to corrosion. Be careful not to confuse the salt and detergent packages; adding
