Inhaltszusammenfassung zur Seite Nr. 1
Inhaltszusammenfassung zur Seite Nr. 2
Important Safety Instructions The lightning flash with an arrowhead symbol, within the WARNING equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to cause an electric shock. The exclamation point within the equilateral triangle is WARNING: TO REDUCE THE RISK OF ELECTRIC intended to alert the user to the presence of important SHOCK, DO NOT REMOVE COVER (OR BACK). NO operating and
Inhaltszusammenfassung zur Seite Nr. 3
Important Safety Instructions 1. Read Instructions - All the safety and operating instructions should be read before the appliance is operated. 2. Retain Instructions - The safety and operating instructions should be retained for future reference. 3. Heed Warnings - All warnings on the appliance and in the operating instructions should be adhered to. 4. Follow Instructions - All operating and use instructions should be followed. 5. Water and Moisture - The appliance should not be used near water
Inhaltszusammenfassung zur Seite Nr. 4
Table of Contents Important Safety Instruction ..................... 1-2 Repeat Playback ........................................ 22 Repeating a title/chapter (DVD) ............................ 22 Disc Formats ................................................ 4 Repeating a single track/whole disc (CD) ........... 22 Before You Start ........................................... 5 Repeating a specific section (DVD) ...................... 22 Using the remote control .................................
Inhaltszusammenfassung zur Seite Nr. 5
Disc Formats The Unit can playback. DVDs [8cm(3")/12cm(5”) disc] Compatible Audio CD-Gs Audio CDs [12cm(5”) disc] [8cm(3")/12cm(5”) disc] GRAPHICS Region Management Information Region Management Information: This Unit is designed and manufactured to respond to the Region Management Information that is encoded on DVD discs. If the Region number printed on the DVD disc does not correspond to the Region number of this Unit, this Unit cannot play that disc. 1 The region number of this Unit is 1. Dis
Inhaltszusammenfassung zur Seite Nr. 6
Before You Start Using the Remote Control • Point the Remote Control at the REMOTE SENSOR located on the Unit. • When there is a strong ambient light source, the performance of the infrared REMOTE SENSOR may be degraded, causing unreliable operation. • The recommended effective distance for remote operation is about 16 feet (5 meters). To install Batteries 1.Open the battery door. 2.Insert two "AA" or UM-3 size batteries. Battery Replacement When batteries become weak, the operating distance of
Inhaltszusammenfassung zur Seite Nr. 7
Parts and Functions Remote Control 1) STANDBY / ON button Turns the Unit on and puts it in standby mode. STANDBY/ON MUTE 2) RETURN button FUNCTION RETURN Return to the normal operation after using the SETUP 1 menu. GOTO 2 3) Number (0 - 9) and (+10) buttons Use when creating programs, and entering a parental level password. To select numbers over 9, press +10 3 button and then the second no. for example, to enter 18, press +10 and then 8. 4) KARAOKE button VOCAL Turn on/off the Karaoke function
Inhaltszusammenfassung zur Seite Nr. 8
Parts and Functions Remote Control 17) FUNCTION button 17 Display the FUNCTION screen where you can check STANDBY/ON MUTE or change various setting. FUNCTION RETURN 18 18) MUTE button To mute the sound. GOTO 19) GOTO button 19 Skip directly to a specific location on a DVD disc. 20) VOCAL CANCEL button Change the Vocal mode. 21) MIC EFFECT button VOCAL KARAOKE MIC EFFECT MEMORY CANCEL Change the voice effect. 20 22) / CURSOR buttons Use to highlight selections on a menu screen and 21 make adjus
Inhaltszusammenfassung zur Seite Nr. 9
Inhaltszusammenfassung zur Seite Nr. 10
Parts and Fucntions Top Panel 25 26 27 OPEN 25) Handle 27) OPEN button 26) Disc tray Use to open the disc tray. Open the tray by pressing OPEN button. Place a disc on the disc tray, label side up. Rear Cabinet 30 31 28 32 29 33 34 35 28) VIDEO IN (VCR) jack 32) AUDIO OUT (R/L) jacks 29) AUDIO IN (R/L) jacks 33) DIGITAL AUDIO OUT jack 30) VIDEO OUT jack 34) Cord holder 31) S-VIDEO OUT (DVD) jack 35) Power cord - 9 -
Inhaltszusammenfassung zur Seite Nr. 11
Display Display Information The DVD displays the information shown below on the TV screen and on the Unit's DVD display depending on the operation status. Display Examples TV Screen Remarks " " appears when the tray is closed and: If no disc is loaded 1)There is no disc in the tray. when the Main Unit No Disc 2)The disc type is not playable in this Unit. is switched on. 3)The disc is not loaded correctly (upside-down, etc.) Tray open Close Tray closed Loading... Loading Stop Stop Stopped The dis
Inhaltszusammenfassung zur Seite Nr. 12
Inhaltszusammenfassung zur Seite Nr. 13
Inhaltszusammenfassung zur Seite Nr. 14
Setup or Coaxial Antenna Jack Some TVs do not have an RCA or S-Video jack, they only have a coaxial antenna jack. In order to connect this Unit to these TVs, you must purchase an RF modulator (available in the Audio/Video department of most electronics retailers or at http://www.18002526123.com) and follow the instructions included with it. Notes : • Connect the Unit to your TV directly. If you connect the Unit through a VCR, the playback picture will be distorted because DVD discs are copy prot
Inhaltszusammenfassung zur Seite Nr. 15
DVD CD CDG Playing a Disc Basic playback This owner’s manual explains the basic instructions of this DVD Unit. Some DVD discs are produced in a manner that allows specific or limited operation during playback. As such, the DVD Unit may not respond to all operating commands. This is not a defect in the DVD Unit. Refer to the instruction notes of discs. “ ” may appear on the TV screen during operation. A “ ” means that the desired operation is not permitted by the DVD Unit or the disc. Playing a
Inhaltszusammenfassung zur Seite Nr. 16
Playing / Recording a Tape Playing a Tape 1.Press the STOP/EJECT button and load a cassette into the cassette compartment. 2.Press the PLAY Y button to begin playback. Pausing playback Press the STOP/EJECT button. To interrupt playback Press the PAUSE button. To resume play, press the PAUSE button again. To fast wind Press the REW (Rewind) button. or F.FWD (fast forward) button. Press the STOP/EJECT button to stop winding at the desired position. When the tape reaches its end During fast wind o
Inhaltszusammenfassung zur Seite Nr. 17
Playing a Disc DVD CD Fast Forward/Fast Reverse 1.Press SEARCH button on the remote control when a disc is playing. • The disc begins fast scan at x2 speed. • Four speeds are available [for the SEARCH button on remote control only]. Each time SEARCH button is pressed, the speed of fast scan changes in the following sequence: 2.Press the PLAY Y button when you reach the desired point to resume playback at normal speed. DVD Slow-motion play 1.Press the SLOW or SLOW W button in the play m
Inhaltszusammenfassung zur Seite Nr. 18
DVD Playing a Disc Angle selection Some DVDs contain scenes which have been shot from a number of different angles. For these discs, the same scene can be viewed from each of these different angles. 1. While you are playing a DVD with different angles recorded, press the ANGLE button to view the number of the current angle. 2.Press the ANGLE button repeatedly to change the scene to the next angle in those recorded. • About two seconds later, playback continues from the new angle you selected. •
Inhaltszusammenfassung zur Seite Nr. 19
DVD Basic playback Special Functions DISPLAY function Using DISPLAY, you can check and change the current settings of the following items: ANGLE, AUDIO and SUBTITLE. • While the disc is playing, press the DISPLAY button to display the screen shown below. Elapsed time: Elapsed time from the beginning of the chapter which is currently playing. Remaining time: Remaining time of the title which is currently playing. Elapsed Time Remaining Time • Press the DISPLAY button twice to display the screen s
Inhaltszusammenfassung zur Seite Nr. 20
Basic playback Special Functions DVD Locating a specific title If a DVD disc contains title numbers, you can locate a specific title by directly selecting a title number. 1.In stop mode, press the GOTO button. 2.Press , or button to highlight a specific field and press the corresponding number button(s) for the title you ou want. 3.Press the ENTER button to confirm. The Unit will start playback about 3 seconds later. Note : • Pressing the CLEAR button resets the title number. DVD CD Locating a
