Inhaltszusammenfassung zur Seite Nr. 1
SD-W1101 DVD-RAM
with REALmagic Hollywood+ Playback Card
Installation Instructions
Congratulations on your purchase of a Toshiba SD-W1101 DVD-RAM
drive and REALmagic Hollywood+ DVD/MPEG-2 Playback Card Kit.
The following information will help you in the simple installation of
your new DVD-RAM. If you are not replacing a presently installed SCSI
CD-ROM with the enclosed DVD-RAM, additional installation hardware
may be required. Refer to REALmagic Hollywood+ User’s Guide for
installation instruc
Inhaltszusammenfassung zur Seite Nr. 2
The follow steps must be performed to properly install your DVD-RAM. l Set DVD-RAM drive jumper settings. l Connect audio cable. l Install SCSI host adapter board. l Attach SCSI interface cable. l Connect power cable. l Mount DVD-RAM. SETTING JUMPERS The block of mode select jumpers are located on the rear of the DVD- RAM. If the jumper covers both pins on the jumper block, it is ON; if there is no jumper or only one of the pins is covered, the jumper is OFF. The jumper settings include SCSI ID
Inhaltszusammenfassung zur Seite Nr. 3
Test - This setting is for manufacturer use only. Do not jumper. Terminator ON/OFF - This jumper turns termination power ON or OFF. If you are connecting more than one SCSI device to your system, and the DVD-RAM is not at the end of the chain, then terminator jumper is not required. PLACING DVD-RAM INSIDE YOUR COMPUTER Now that you have set the jumpers, you are ready to install your DVD- RAM inside your computer. IMPORTANT: Disconnect power from your computer system before beginning installati
Inhaltszusammenfassung zur Seite Nr. 4
Daisy-Chaining - If the DVD-RAM you are installing is one of two or more SCSI devices you are connecting to your system, you will need to use a custom built SCSI interface cable. Remember that the terminator jumper on the DVD-RAM drive must have the jumper installed when the drive is the last device in the chain. Host Computer Interface I/F Card Connector SCSI Cable DVD-RAM DRIVE (see note 1) Terminator SD-W1101 CONNECTION (ONE DRIVE) SD-W1101 INTERNAL DRIVE(S) Host Computer SCSI Cable Interfa
Inhaltszusammenfassung zur Seite Nr. 5
Audio Cable (optional) - If you have a sound card and speakers, and would like to play audio CDs on your computer, you will need to get a sound cable. Contact AMC, our small parts supplier, at 888/262-9700. Sound cables are made for the sound card you are using and the DVD- RAM to which you are connecting. Make sure you have this information when purchasing a sound cable. The sound cable connects to your sound card at one end and the other end connects to the digital audio connector at the le
Inhaltszusammenfassung zur Seite Nr. 6
USING “WRITE DVD” After installing software, your DVD-RAM drive will be assigned two drive letters. One will be for “read only” media (a CD icon) and the other will be for “DVD-RAM” media ( a removable disk icon). Use your DVD- RAM drive just like any other drive on your system. If you want to copy a file from your hard drive to the DVD-RAM, just select file and drag and drop it onto DVD-RAM removable disk icon. DVD-RAM FRONT PANEL The photo illustrates the following features of the SD-W1101
Inhaltszusammenfassung zur Seite Nr. 7
DVD-RAM RECORDING CARTRIDGE When recording a DVD-RAM, you must use a “recording” cartridge. There are two types of cartridges: Type 1: • Cartridge is reversible (side A & B). • Disc cannot be removed from cartridge. • Cartridges are available with single-sided* or double-sided discs. Type 2: • Cartridge is not reversible (side A only). • Disc in cartridge can be removed and replaced. * Your SD-W1101 comes with a Type 1 single-sided cartridge. INSTALLING CARTRIDGE IN DVD-RAM Place cartridge insid
Inhaltszusammenfassung zur Seite Nr. 8
SD-W1101 SPECIFICATIONS Data Capacity DVD-RAM (single & double) 2.42 GB DVD-R 3.9 GB DVD-ROM SINGLE SIDED-SINGLE LAYER 4.7 GB DVD-ROM SINGLE SIDED-DOUBLE LAYER 8.5 GB DVD-ROM DOUBLE SIDED-SINGLE LAYER 9.4 GB DVD-ROM DOUBLE SIDED-DOUBLE LAYER 17 GB CD-ROM 650 MB Rotational Speed DVD-RAM 1,028-2,400 rpm DVD-ROM/DVD-R 1,200-2,800 rpm (single layer) 1,300-3,000 rpm (double layer/DVD-R) CD-ROM 3,516 rpm (16X) Transfer Rate DVD-RAM 1,350 KB/second DVD-ROM/DVD-R 2,700 KB/second CD-ROM 990-2,400 KB/seco
